8.11: LCR Circuit and Charge Fluctuations

Fluctuations Near Equilibrium · LibreTexts

0%

Contents

    Text

    Size
    100%
    Theme
    Typeface
    Line length
    Spacing

    Read aloud

    How

    Speed: 1×
    Light up
    Highlight

    Symbols: Mulberry Symbols, © 2018–2026 Steve Lee, CC BY-SA 4.0 (licence, the set), the site's own copies.

    From LibreTexts, under CC BY-NC-SA 4.0, as the source states it; its equations are written in TeX, which the PDF shows typeset. This page at LibreTexts.

    8.11: LCR Circuit and Charge Fluctuations

    The distinction between white and colored noise arises from how the circuit's real part of the impedance, \(\operatorname{Re}[Z(\omega)]\), varies with frequency. This is best understood through the configurations shown in Figs. \(\PageIndex{1}\): and \(\PageIndex{2}\):.

    Redistribution and Effective Resistance: In the Parallel RC configuration (Fig. \(\PageIndex{1}\):), the capacitor provides an alternative path for the current. As frequency increases, the capacitor's impedance \(1 / i \omega C\) decreases, diverting current away from the resistor. This redistribution reduces the current through the resistor at high frequencies, which decreases the dissipated power and is reflected in the dropping \(\operatorname{Re}[Z(\omega)]\). Consequently, the noise power spectral density \(S_{V}(\omega)\) follows this drop, resulting in colored (low-pass) noise.

    78b99fe6-dd4f-499e-8190-ab4a68ee9fee-067.jpgheight270ampwidth634amptop_left_y255amptop_left_x715

    Figure \(\PageIndex{1}\): Parallel RC circuit showing resistor noise source and capacitive current bypass responsible for frequency-dependent noise.

    78b99fe6-dd4f-499e-8190-ab4a68ee9fee-067.jpgheight263ampwidth811amptop_left_y702amptop_left_x627

    Figure \(\PageIndex{2}\): Series LCR circuit. The same current flows through all elements, keeping the resistive dissipation constant.

     

    Conversely, in Series configurations (Fig. 2), the same current must pass through the resistor regardless of the reactance of \(L\) or \(C\). Because the dissipation mechanism (the resistor) is always fully engaged by the total current, the effective resistance \(R(\omega)\) remains exactly \(R\). Thus, while reactive elements may change the phase or the voltage measured across a single component, the total resistive part of the circuit impedance remains constant, and the noise remains white.


    This page titled 8.11: LCR Circuit and Charge Fluctuations was last modified on Mon, 02 Nov 2026 06:09:32 GMT and is shared under a CC BY-NC-SA 4.0 license and was authored, remixed, and/or curated by Pabitra N. Sen.