8.10: The L-R Shunted by C Equivalent Circuit Model

Fluctuations Near Equilibrium · LibreTexts

0%

Contents

    Text

    Size
    100%
    Theme
    Typeface
    Line length
    Spacing

    Read aloud

    How

    Speed: 1×
    Light up
    Highlight

    Symbols: Mulberry Symbols, © 2018–2026 Steve Lee, CC BY-SA 4.0 (licence, the set), the site's own copies.

    From LibreTexts, under CC BY-NC-SA 4.0, as the source states it; its equations are written in TeX, which the PDF shows typeset. This page at LibreTexts.

    8.10: The L-R Shunted by C Equivalent Circuit Model

    For a series LCR circuit,

    \[ Z(\omega)=R+i\left(\omega L-\frac{1}{\omega C}\right) . \tag{8.38} \label{8.38} \]

    The voltage noise is generated solely by \(R\), but the charge \(q(\omega)=I(\omega) / i \omega\) fluctuates.

    The charge noise spectral density is defined as

    \[ \left.\left.S_{q}(\omega) \equiv\langle | q(\omega)\right|^{2}\right\rangle . \tag{8.39} \label{8.39} \]

    Using \(I=V / Z\), one finds

    \[ S_{q}(\omega)=\frac{2 k_{B} T R}{\left(1 / C-L \omega^{2}\right)^{2}+(R \omega)^{2}} . \tag{8.40} \label{8.40} \]

    The voltage across the resistor has spectral density

    \[ S_{V_{R}}^{(\mathrm{LCR})}(\omega)=2 k_{B} T R, \tag{8.41} \label{8.41} \]

    but the measurable voltages across \(L\) or \(C\) are resonantly enhanced.

    In the high- \(Q\) limit, Equation \ref{8.40} becomes Lorentzian near \(\omega_{0}=1 / \sqrt{L C}\). Writing \(\omega=\omega_{0}+\epsilon\) with \(|\epsilon| \ll \omega_{0}\), the factor \(\left(1 / C-L \omega^{2}\right) \approx-2 L \omega_{0} \epsilon\) and \((R \omega)^{2} \approx\left(R \omega_{0}\right)^{2}\), so the denominator becomes \(4 L^{2} \omega_{0}^{2} \epsilon^{2}+R^{2} \omega_{0}^{2}=\omega_{0}^{2} 4 L^{2}\left[\left(\omega-\omega_{0}\right)^{2}+(R / 2 L)^{2}\right]\). Hence for \(Q=\omega_{0} L / R \gg 1\) :

    \[ S_{q}(\omega) \approx \frac{k_{B} T R C}{2 L} \frac{1}{\left(\omega-\omega_{0}\right)^{2}+\left(\frac{R}{2 L}\right)^{2}}=\frac{k_{B} T R C}{2 L} \frac{1}{\left(\omega-\omega_{0}\right)^{2}+\left(\frac{\omega_{0}}{2 Q}\right)^{2}} . \tag{8.42} \label{8.42} \]

    While it is physically true that \(R\) is the dissipative element, in a formal FDT sense, the noise is a property of the entire system's impedance, i.e., while \(R\) is the source of dissipation, \(L\) and \(C\) act as the environment that shapes the correlation time of the fluctuations.

    8.10.1 Summary of Results

    Noise spectral densities and characteristic correlation times for various circuits are summarized below in Table 8.1.

    Table \(\PageIndex{1}\): Noise spectral densities and characteristic correlation times. For series configurations, \(V_{R}\) is listed to demonstrate consistent white noise characteristics.
    Circuit Measured Voltage \(\operatorname{Re}[Z(\omega)]\) \(S_{V}(\omega)\) Correlation Time \(\tau\)
    Pure \(R\) \(V_{R}\) \(R\) \(2 k_{B} T R\) (white) → 0
    Series \(R C\) \(V_{R}\) R \(2 k_{B} T R\) (white) → 0
    Series \(R C\) \(V_{C}\) R \(\frac{2 k_{B} T R}{1+\omega^{2} R^{2} C^{2}}\) (colored) \(R C\)
    Parallel \(R C\) \(V_{R \| C}\) \(\frac{R}{1+\omega^{2} R^{2} C^{2}}\) \(\frac{2 k_{B} T R}{1+\omega^{2} R^{2} C^{2}}\) (colored) \(R C\)
    Series LCR \(V_{R}\) \(R\) \(2 k_{B} T R\) (white) \(2 L / R\)
    Shunted \(L R \| C\) \(V_{R}\) \(\frac{R}{\left(1-\omega^{2} L C\right)^{2}+(\omega R C)^{2}}\) \(\frac{2 k_{B} T R}{\left(1-\omega^{2} L C\right)^{2}+(\omega R C)^{2}}\) (colored) \(R C, \sqrt{L C}\)

    Note: For series RC, the noise across the resistor \(V_{R}\) is white, but the noise across the capacitor \(V_{C}\) is colored (low-pass filtered) as shown. For series LCR, voltages across \(L\) or \(C\) exhibit resonant enhancement but the resistor voltage remains white.

    The distinction between white and colored noise in these entries depends on the choice of the measured observable. In series configurations, such as the series \(R C\) or \(L C R\) circuits, the same current flows through all elements. Because the dissipation occurs only within the resistor, the effective resistance \(\operatorname{Re}[Z(\omega)]\) remains constant \((R)\), and the voltage noise measured across that resistor \(\left(V_{R}\right)\) is white.

    However, if the voltage is measured across a reactive element like the capacitor \(\left(V_{C}\right)\), the reactive impedance shapes the signal, resulting in a colored spectrum. This is not due to a change in the noise generation itself, but rather a frequency-dependent redistribution of the voltage. In contrast, parallel configurations exhibit naturally colored noise because the reactive elements provide alternative paths that make the total circuit dissipation frequency-dependent.


    This page titled 8.10: The L-R Shunted by C Equivalent Circuit Model was last modified on Mon, 02 Nov 2026 06:09:32 GMT and is shared under a CC BY-NC-SA 4.0 license and was authored, remixed, and/or curated by Pabitra N. Sen.