26.3: Capacitors in an AC Circuit

Physics: A Foundation for Scientists and Engineers · LibreTexts

0%

Contents

    Text

    Size
    100%
    Theme
    Typeface
    Line length
    Spacing

    Read aloud

    How

    Speed: 1×
    Light up
    Highlight

    Symbols: Mulberry Symbols, © 2018–2026 Steve Lee, CC BY-SA 4.0 (licence, the set), the site's own copies.

    From LibreTexts, under CC BY 4.0, as the source states it; its equations are written in TeX, which the PDF shows typeset. This page at LibreTexts.

    26.3: Capacitors in an AC Circuit
    Voltage and current of a capacitor in an ac circuit: current leads voltage by a quarter cycle.
    Figure 26.3. A capacitor in an ac circuit. (a) The current reaches its peaks a quarter cycle before the voltage. (b) The current phasor is \(90^\circ\) ahead of the voltage phasor.
    Figure descriptionPanel a: graphs against time of the voltage v across a capacitor, a sine curve, and the current i, a curve that reaches each peak a quarter cycle earlier than the voltage: the current leads the voltage by 90 degrees. Panel b: phasors. The voltage phasor V sub m is at angle omega t; the current phasor I sub m is 90 degrees ahead of it, counterclockwise.

    Now connect the source across a capacitor alone. At every instant the capacitor’s voltage equals the source’s, so its charge is \(q = Cv = CV_m\sin\omega t\), and the current is

    \[i_C = \frac{dq}{dt} = \omega CV_m\cos\omega t = \omega CV_m\sin\left(\omega t + 90^\circ\right).\]

    The current in a capacitor leads the voltage by \(90^\circ\), a quarter cycle (Figure 26.3): the current is greatest when the voltage is zero and changing fastest, and zero when the voltage is at its peak and the capacitor is momentarily full. Its amplitude is \(I_m = \omega CV_m\). Written like Ohm’s law, \(V_m = I_mX_C\), with

    Key Equation: Capacitive reactance

    \[X_C = \frac{1}{\omega C}. \tag{26.5}\]

    The quantity \(X_C\) is the capacitive reactance. It is measured in ohms, and it plays the role of resistance for the amplitudes, although it relates quantities that are out of phase, and, as Section 26.6 shows, a capacitor dissipates no energy. The reactance depends on frequency. At low frequency it is large: at \(\omega = 0\), steady dc, a capacitor blocks current completely once it has charged. At high frequency it is small: the capacitor charges and discharges so quickly that it barely builds up any voltage opposing the source. A capacitor passes high frequencies and blocks low ones.

    Example 26.4: A capacitor at two frequencies

    A \(10\,\mathrm{\mu F}\) capacitor is connected to a \(120\,\mathrm{V}\) (rms) source. Find the rms current at (a) \(60\,\mathrm{Hz}\) and (b) \(6.0\,\mathrm{kHz}\).

    Solution

    (a) The capacitive reactance is

    \[X_C = \frac{1}{2\pi fC} = \frac{1}{2\pi(60)(10\times10^{-6})} = 265\,\mathrm{\Omega},\]

    so \(I_{\text{rms}} = V_{\text{rms}}/X_C = 120/265 = \boxed{0.45\,\mathrm{A}}\).

    (b) A hundred times the frequency gives a hundredth of the reactance, \(X_C = 2.65\,\mathrm{\Omega}\), and a current of \(\boxed{45\,\mathrm{A}}\). The rms relation \(V_{\text{rms}} = I_{\text{rms}}X_C\) works because the rms values are the amplitudes divided by the same \(\sqrt{2}\).


    This page titled 26.3: Capacitors in an AC Circuit was last modified on Thu, 12 Nov 2026 04:26:59 GMT and is shared under a CC BY 4.0 license and was authored, remixed, and/or curated by Michael Ragsdale.