26.4: Inductors in an AC Circuit

Physics: A Foundation for Scientists and Engineers · LibreTexts

0%

Contents

    Text

    Size
    100%
    Theme
    Typeface
    Line length
    Spacing

    Read aloud

    How

    Speed: 1×
    Light up
    Highlight

    Symbols: Mulberry Symbols, © 2018–2026 Steve Lee, CC BY-SA 4.0 (licence, the set), the site's own copies.

    From LibreTexts, under CC BY 4.0, as the source states it; its equations are written in TeX, which the PDF shows typeset. This page at LibreTexts.

    26.4: Inductors in an AC Circuit
    Voltage and current of an inductor in an ac circuit: current lags voltage by a quarter cycle.
    Figure 26.4. An inductor in an ac circuit. (a) The current reaches its peaks a quarter cycle after the voltage. (b) The current phasor is \(90^\circ\) behind the voltage phasor.
    Figure descriptionPanel a: graphs against time of the voltage v across an inductor, a sine curve, and the current i, a curve that reaches each peak a quarter cycle later than the voltage: the current lags the voltage by 90 degrees. Panel b: phasors. The voltage phasor V sub m is at angle omega t; the current phasor I sub m is 90 degrees behind it, clockwise.

    Finally, connect the source across an inductor alone. The loop rule gives \(v - L\,di/dt = 0\), so \(di/dt = (V_m/L)\sin\omega t\), and integrating,

    \[i_L = -\frac{V_m}{\omega L}\cos\omega t = \frac{V_m}{\omega L}\sin\left(\omega t - 90^\circ\right).\]

    The current in an inductor lags the voltage by \(90^\circ\) (Figure 26.4). The voltage across an inductor is proportional to the rate of change of the current, so it is greatest when the current is zero and changing fastest. The amplitudes are related by \(V_m = I_mX_L\), with

    Key Equation: Inductive reactance

    \[X_L = \omega L. \tag{26.6}\]

    This is the inductive reactance, also in ohms. It grows with frequency: at \(\omega = 0\) an ideal inductor is just a wire, but at high frequency the rapid changes of current meet a large opposing emf. An inductor passes low frequencies and blocks high ones, the opposite of a capacitor. Loudspeaker systems use this to send the low notes to the large “woofer” through an inductor and the high notes to the small “tweeter” through a capacitor.

    A mnemonic for the phases is “ELI the ICE man”: in an inductor (\(L\)), the emf \(E\) comes before the current \(I\); in a capacitor (\(C\)), the current \(I\) comes before the emf \(E\).

    Example 26.5: An inductor at two frequencies

    A \(0.50\,\mathrm{H}\) inductor with negligible resistance is connected to a \(120\,\mathrm{V}\) (rms) source. Find the rms current at (a) \(60\,\mathrm{Hz}\) and (b) \(6.0\,\mathrm{kHz}\).

    Solution

    (a) \(X_L = 2\pi fL = 2\pi(60)(0.50) = 188\,\mathrm{\Omega}\), so \(I_{\text{rms}} = 120/188 = \boxed{0.64\,\mathrm{A}}\).

    (b) At a hundred times the frequency, \(X_L = 18.8\,\mathrm{k\Omega}\), and \(I_{\text{rms}} = \boxed{6.4\,\mathrm{mA}}\). Compare Example 26.4: raising the frequency lets a hundred times more current through the capacitor, and a hundred times less through the inductor.

    Checkpoint 26.2

    (a) What happens to the current through a capacitor, and through an inductor, when the frequency of the source is halved at the same voltage? (b) Which element would you put in series with a loudspeaker to keep low-frequency hum out of it?

    Answer

    Answers to Checkpoints

    Checkpoint 26.2. (a) Halving the frequency doubles the capacitive reactance, \(X_C = 1/\omega C\), so the capacitor’s current halves. It halves the inductive reactance, \(X_L = \omega L\), so the inductor’s current doubles. (b) A capacitor in series. Its reactance is large at low frequencies and small at high ones, so it blocks the low-frequency hum while passing the higher-frequency sound. An inductor would do the reverse.


    This page titled 26.4: Inductors in an AC Circuit was last modified on Thu, 12 Nov 2026 04:26:59 GMT and is shared under a CC BY 4.0 license and was authored, remixed, and/or curated by Michael Ragsdale.