37.2: The First Law of Thermodynamics

Physics: A Foundation for Scientists and Engineers · LibreTexts

0%

Contents

    Text

    Size
    100%
    Theme
    Typeface
    Line length
    Spacing

    Read aloud

    How

    Speed: 1×
    Light up
    Highlight

    Symbols: Mulberry Symbols, © 2018–2026 Steve Lee, CC BY-SA 4.0 (licence, the set), the site's own copies.

    From LibreTexts, under CC BY 4.0, as the source states it; its equations are written in TeX, which the PDF shows typeset. This page at LibreTexts.

    37.2: The First Law of Thermodynamics

    We now broaden conservation of energy to include heat. Describe a gas by its state variables: pressure \(P\), volume \(V\), temperature \(T\), and internal energy \(E_{\rm int}\), each a property of the system’s current state. We can change that state by two kinds of energy transfer, the transfer variables heat \(Q\) and work \(W\). Imagine a gas in a cylinder fitted with a piston: piling sand on the piston does work that compresses the gas, while a flame beneath supplies heat that can expand it. Both change the gas’s internal energy, and the accounting is the first law of thermodynamics:

    Key Equation: First law of thermodynamics

    \[\Delta E_{\rm int} = Q + W. \tag{37.4}\]

    This is conservation of energy, nothing more: the change in a system’s internal energy equals the heat added to it plus the work done on it. The sign convention matters. Here \(Q > 0\) means heat flows into the system, and \(W > 0\) means work is done on the system (for example, compressing it). When a gas instead expands and pushes on its surroundings, it does work on them, so the work done on the gas is negative.

    Note: Two sign conventions

    Some books, especially in engineering, write the first law as \(\Delta E_{\rm int} = Q - W\), where \(W\) is the work done by the system. That \(W\) is the negative of ours, so the physics is identical; only the bookkeeping differs. We write the work done by a gas as \(W_{\rm by} = -W\) whenever we need it, so you will see both quantities, clearly labeled.

    Checkpoint 37.2

    (a) A gas absorbs \(500\,\mathrm{J}\) of heat while doing \(200\,\mathrm{J}\) of work on its surroundings. What is \(\Delta E_{\rm int}\)? (b) A gas is compressed, with \(300\,\mathrm{J}\) of work done on it, while it loses \(100\,\mathrm{J}\) of heat. What is \(\Delta E_{\rm int}\) now?

    Answer

    Two panels: gas pushing a piston of area A, and work as the area under a P-V curve.
    Figure 37.2. (a) A gas at pressure \(P\) pushes on a piston of area \(A\) with force \(PA\). As the piston moves out by \(dx\), the gas does work \(PA\,dx = P\,dV\). (b) The total work done by the gas between states \(i\) and \(f\) is the area under its path on the \(P\)–\(V\) diagram.
    Figure descriptionTwo panels. Panel a: a gas in a cylinder closed on top by a piston of area A. The gas pushes up on the piston with force P times A, and the piston rises by a small distance dx, so the gas volume grows by dV equal to A dx. Panel b: a pressure-versus-volume graph with a curved path from an initial state i at small volume and high pressure down to a final state f at larger volume and lower pressure. The region under the curve, between the curve and the volume axis from V sub i to V sub f, is shaded and labeled W sub by, the work done by the gas.

    Work done by a gas. How much work does a gas do as it expands? Picture it in a cylinder, pushing on a piston of area \(A\) with a force \(F = PA\) (Figure 37.2a). If the piston moves out a small distance \(dx\), slowly enough that the pressure stays uniform, the gas does work \(dW_{\rm by} = F\,dx = PA\,dx\). But \(A\,dx\) is the increase in the gas’s volume, \(dV\), so \(dW_{\rm by} = P\,dV\). For a finite change of volume,

    Key Equation: Work done by a gas

    \[W_{\rm by} = -W = \int_{V_i}^{V_f} P\,dV. \tag{37.5}\]

    This integral has a simple picture: it is the area under the path on a \(P\)–\(V\) diagram (Figure 37.2b). An expanding gas (\(V_f > V_i\)) does positive work; a compressed gas does negative work, meaning work is done on it.

    P-V diagram of two different paths between the same initial and final states.
    Figure 37.3. Two paths between the same initial and final states. The gas does more work along path A (area under its horizontal leg, \(1200\,\mathrm{J}\)) than along path B (shaded area, \(600\,\mathrm{J}\)), so it must also absorb more heat along path A. The change in internal energy is the same for both.
    Figure descriptionA pressure-versus-volume diagram with two states, i at volume 1.0 liter and pressure 4.0 times 10 to the 5 pascals, and f at volume 4.0 liters and pressure 2.0 times 10 to the 5 pascals. Path A, in red, runs horizontally right from i at the higher pressure to a corner at 4.0 liters, then straight down to f. Path B, in blue, runs straight down from i to a corner at 2.0 times 10 to the 5 pascals, then horizontally right to f. The area under path A, a tall rectangle, is larger than the area under path B, a short rectangle, which is shaded.

    Because the work is an area under the path, it depends on the path, not just on where the gas starts and ends. Figure 37.3 shows two ways to take a gas from state \(i\) to state \(f\). Along path A the gas expands first, at high pressure, and then cools at constant volume; along path B it cools first and then expands at low pressure. The gas does more work along path A. Its internal energy, though, is a state variable: \(\Delta E_{\rm int}\) depends only on the two end states, so it is the same along both paths. By the first law, \(Q = \Delta E_{\rm int} + W_{\rm by}\), so the heat must also differ: along path A, the gas absorbs more heat to pay for the extra work. Heat and work depend on the path; their combination \(Q + W\) does not. That is why it makes sense to talk about the internal energy a system has but not about the heat or work it has.

    Example 37.7: Two paths, one change

    A sample of monatomic ideal gas is taken from state \(i\) (\(V_i = 1.0\,\mathrm{L}\), \(P_i = 4.0\times 10^{5}\,\mathrm{Pa}\)) to state \(f\) (\(V_f = 4.0\,\mathrm{L}\), \(P_f = 2.0\times 10^{5}\,\mathrm{Pa}\)) along each path of Figure 37.3. For each path find the work done by the gas, the change in internal energy, and the heat absorbed.

    Solution

    Internal energy. For a monatomic ideal gas \(E_{\rm int} = \tfrac32 nRT = \tfrac32 PV\) (Chapter 36), so we never need \(n\) or \(T\) separately. With volumes in \(\,\mathrm{m^3}\),

    \[\begin{aligned}\Delta E_{\rm int} &= \tfrac32(P_fV_f - P_iV_i) \\ &= \tfrac32\big[(2.0\times10^5)(4.0\times10^{-3}) - (4.0\times10^5)(1.0\times10^{-3})\big] \\ &= \tfrac32(800 - 400) = 600\,\mathrm{J},\end{aligned}\]

    the same for both paths.

    Path A. Only the horizontal leg, at \(4.0\times 10^{5}\,\mathrm{Pa}\), does work (the vertical leg has no volume change):

    \[W_{\rm by,A} = P\,\Delta V = (4.0\times10^5)(3.0\times10^{-3}) = \boxed{1200\,\mathrm{J}},\]

    \[Q_A = \Delta E_{\rm int} + W_{\rm by,A} = 600 + 1200 = \boxed{1800\,\mathrm{J}}.\]

    Path B. Now the expansion happens at \(2.0\times 10^{5}\,\mathrm{Pa}\):

    \[W_{\rm by,B} = (2.0\times10^5)(3.0\times10^{-3}) = \boxed{600\,\mathrm{J}}, \qquad Q_B = 600 + 600 = \boxed{1200\,\mathrm{J}}.\]

    Both paths raise the internal energy by \(600\,\mathrm{J}\). Path A takes in \(600\,\mathrm{J}\) more heat and does exactly \(600\,\mathrm{J}\) more work. Note that we used \(W_{\rm by} = Q - \Delta E_{\rm int}\), the first law rearranged with the work done by the gas; with our sign convention, the work done on the gas is \(W = -W_{\rm by}\).

    Two special cases follow directly from the first law. In a cyclic process, the system returns to its starting state, so \(\Delta E_{\rm int} = 0\) and \(Q = W_{\rm by}\): over a full cycle, the net heat absorbed equals the net work done. This is the principle of every heat engine (Chapter 38). And for an isolated system, which exchanges neither heat nor work with anything, \(Q = W = 0\) and the internal energy cannot change at all.

    Answers to Checkpoints

    Checkpoint 37.2. (a) Here \(Q = +500\,\mathrm{J}\) (heat in), and the work done on the gas is \(W = -200\,\mathrm{J}\), since the gas does work on its surroundings. So \(\Delta E_{\rm int} = Q + W = 500 - 200 = +300\,\mathrm{J}\). (b) Now \(W = +300\,\mathrm{J}\) and \(Q = -100\,\mathrm{J}\) (heat out), so \(\Delta E_{\rm int} = 300 - 100 = +200\,\mathrm{J}\). Keeping the signs straight is the whole problem: heat in and work done on the system both count as positive.


    This page titled 37.2: The First Law of Thermodynamics was last modified on Thu, 12 Nov 2026 04:26:55 GMT and is shared under a CC BY 4.0 license and was authored, remixed, and/or curated by Michael Ragsdale.