20.3: Ohm’s Law

Physics: A Foundation for Scientists and Engineers · LibreTexts

0%

Contents

    Text

    Size
    100%
    Theme
    Typeface
    Line length
    Spacing

    Read aloud

    How

    Speed: 1×
    Light up
    Highlight

    Symbols: Mulberry Symbols, © 2018–2026 Steve Lee, CC BY-SA 4.0 (licence, the set), the site's own copies.

    From LibreTexts, under CC BY 4.0, as the source states it; its equations are written in TeX, which the PDF shows typeset. This page at LibreTexts.

    20.3: Ohm’s Law

    Equation (20.4) defines the resistance of any object, \(R = V/I\). By itself it says nothing about how \(R\) behaves. For many materials, however, and in particular for metals at constant temperature, experiment shows that the current is directly proportional to the applied potential difference over a very wide range. The resistance is then a constant, independent of \(V\) and \(I\). This experimental fact is called Ohm’s law, after Georg Ohm, who reported it in 1827:

    Key Equation: Ohm’s law

    \[V = IR, \qquad R \text{ constant.} \tag{20.9}\]

    Three graphs of current I against potential difference V.
    Figure 20.6. Current–voltage graphs. (a) An ohmic resistor: current proportional to voltage, a straight line of slope \(1/R\). (b) A diode: almost no current in one direction, and a steeply rising current in the other once the voltage exceeds a threshold. (c) A lamp filament: its resistance rises as it heats, so the graph bends toward the \(V\) axis.
    Figure descriptionThree graphs of current I against potential difference V. Panel a, an ohmic resistor: a straight line through the origin, extending into both the positive and negative quadrants, with slope one over R. Panel b, a diode: the current is essentially zero for negative V and for small positive V, then rises very steeply beyond about 0.6 volts. Panel c, a lamp filament: the curve passes through the origin and rises steeply at first, then bends over and becomes less steep at larger V, because the hot filament's resistance is higher.

    A material or device that obeys Ohm’s law is called ohmic. Its graph of current against voltage is a straight line through the origin, with slope \(1/R\) (Figure 20.6a). Ohm’s law is not a fundamental law of nature like Coulomb’s law or Gauss’s law. It is an empirical rule that many materials obey, just as many springs obey Hooke’s law. Many important devices do not obey it at all. A diode, for instance, conducts easily in one direction and hardly at all in the other (Figure 20.6b), which makes it the basic component for turning alternating current into direct current. Even a lamp filament is nonohmic in practice: as the current rises, the filament heats up and its resistance increases, so its graph bends over (Figure 20.6c).

    For a nonohmic device, \(R = V/I\) still defines a resistance at each operating point, but it changes with the voltage, and quoting a single “resistance” for the device is not meaningful. From here on, unless stated otherwise, resistors are ohmic, and \(V = IR\) with a constant \(R\).

    Example 20.7: Using Ohm’s law

    A \(470\,\mathrm{\Omega}\) resistor is connected across a \(9.0\,\mathrm{V}\) battery. (a) What current flows through it? (b) What resistance would make the current \(5.0\,\mathrm{mA}\)?

    Solution

    (a) \(I = V/R = 9.0/470 = \boxed{19\,\mathrm{mA}}\).

    (b) \(R = V/I = 9.0/(5.0\times10^{-3}) = \boxed{1.8\,\mathrm{k\Omega}}\). Resistors are made in a standard series of values, and \(1.8\,\mathrm{k\Omega}\) is one of them.

    Example 20.8: Reading a current–voltage graph

    For the lamp of Figure 20.6c, suppose the current is \(0.10\,\mathrm{A}\) at \(1.0\,\mathrm{V}\) and \(0.30\,\mathrm{A}\) at \(9.0\,\mathrm{V}\). Find the filament’s resistance at each point, and explain the difference.

    Solution

    At \(1.0\,\mathrm{V}\), \(R = V/I = 1.0/0.10 = \boxed{10\,\mathrm{\Omega}}\). At \(9.0\,\mathrm{V}\), \(R = 9.0/0.30 = \boxed{30\,\mathrm{\Omega}}\). Tripling the current raised the resistance threefold, because the filament is much hotter: with twenty-seven times the power going into it (\(2.7\,\mathrm{W}\) against \(0.10\,\mathrm{W}\)) (Section 20.4), its temperature and hence its resistivity rise substantially. Note that \(R\) is \(V/I\) at each point, the slope of the line from the origin, not the slope of the curve.

    Checkpoint 20.3

    (a) A student says: “Ohm’s law, \(V = IR\), is just the definition of resistance, so everything obeys it.” What is wrong with this statement? (b) Sketch the \(I\)–\(V\) graph of a resistor whose resistance decreases as the current increases.

    Answer

    Answers to Checkpoints

    Checkpoint 20.3. (a) \(R = V/I\) defines resistance for any device at any operating point, but Ohm’s law is the stronger, empirical claim that \(R\) stays constant, that \(I\) is proportional to \(V\). Many devices violate it: a diode’s current is nearly zero one way and large the other, and a lamp’s resistance changes as it heats. Ohm’s law describes a class of materials, not a law of nature. (b) The graph passes through the origin and curves upward, growing steeper as \(V\) increases. The slope of an \(I\)–\(V\) graph is \(1/R\), so a decreasing resistance means an increasing slope.


    This page titled 20.3: Ohm’s Law was last modified on Thu, 12 Nov 2026 04:27:00 GMT and is shared under a CC BY 4.0 license and was authored, remixed, and/or curated by Michael Ragsdale.