12.S: Static Equilibrium and Elasticity (Summary)

Physics: A Foundation for Scientists and Engineers · LibreTexts

0%

Contents

    Text

    Size
    100%
    Theme
    Typeface
    Line length
    Spacing

    Read aloud

    How

    Speed: 1×
    Light up
    Highlight

    Symbols: Mulberry Symbols, © 2018–2026 Steve Lee, CC BY-SA 4.0 (licence, the set), the site's own copies.

    From LibreTexts, under CC BY 4.0, as the source states it; its equations are written in TeX, which the PDF shows typeset. This page at LibreTexts.

    12.S: Static Equilibrium and Elasticity (Summary)

    Summary

    • An object is in static equilibrium when \(\sum\vec F = 0\) and \(\sum\vec\tau = 0\). Because the net torque vanishes about every point, choosing the axis at an unknown force eliminates it from the torque equation.
    • In two dimensions these give exactly three independent equations, so statics alone can determine at most three unknowns. Problems with more are statically indeterminate and need elasticity as well.
    • The center of gravity is where an object’s weight effectively acts; for uniform \(g\) it coincides with the center of mass. We replace distributed weight with a single force \(mg\) there.
    • An object tips when the vertical line through its center of gravity falls outside its base of support. For a block of width \(w\) and height \(h\) this happens at \(\tan\theta_{\rm c} = w/h\) (12.3); low and wide is stable.
    • Stress (force per area) and strain (fractional deformation) are proportional within the elastic limit, with ratio the elastic modulus.
    • Young’s modulus \(Y = (F/A)/(\Delta L/L)\) (12.4) governs stretching; the shear modulus \(S = (F/A)/(\Delta x/h)\) (12.5) governs sideways deformation; and the bulk modulus \(B = -\Delta P/(\Delta V/V)\) (12.6) governs volume compression.
    • Any rod or wire behaves as a spring of stiffness \(k = YA/L\) (12.7): the modulus is a property of the material, the stiffness a property of the piece.
    • The linear relation holds only up to the proportional limit. Past the elastic limit deformation is permanent; a ductile material then yields, strain hardens to its ultimate strength, and fractures. Designers work to a fraction of the yield strength set by a safety factor.

    Key Equations

    Conditions for static equilibrium

    \[\sum\vec{F} = 0 \qquad\text{and}\qquad \sum\vec{\tau} = 0\]

    Critical tipping angle for a block

    \[\tan\theta_{\rm c} = \frac{w}{h}\]

    Young’s modulus

    \[Y = \frac{F/A}{\Delta L/L}\]

    Shear modulus

    \[S = \frac{F/A}{\Delta x/h}\]

    Bulk modulus

    \[B = -\frac{\Delta P}{\Delta V/V}\]


    This page titled 12.S: Static Equilibrium and Elasticity (Summary) was last modified on Thu, 12 Nov 2026 04:26:48 GMT and is shared under a CC BY 4.0 license and was authored, remixed, and/or curated by Michael Ragsdale.