31.4: Reflection and Refraction

Physics: A Foundation for Scientists and Engineers · LibreTexts

0%

Contents

    Text

    Size
    100%
    Theme
    Typeface
    Line length
    Spacing

    Read aloud

    How

    Speed: 1×
    Light up
    Highlight

    Symbols: Mulberry Symbols, © 2018–2026 Steve Lee, CC BY-SA 4.0 (licence, the set), the site's own copies.

    From LibreTexts, under CC BY 4.0, as the source states it; its equations are written in TeX, which the PDF shows typeset. This page at LibreTexts.

    31.4: Reflection and Refraction

    When light meets a boundary between two transparent media, part of it bounces back (reflection) and part crosses into the new medium, generally bending (refraction). We describe both with rays, in the ray approximation of Section 31.2.

    Measure all angles from the normal, the line perpendicular to the surface. The law of reflection is then beautifully simple: the angle of reflection equals the angle of incidence,

    Key Equation: Law of reflection

    \[\theta_i = \theta_r. \tag{31.4}\]

    This single rule explains both a mirror and a sheet of paper. A mirror is smooth on the scale of a wavelength, so parallel incoming rays stay parallel after reflecting (specular reflection) and an image forms. Paper is rough on that scale, so its tiny facets scatter parallel rays in all directions (diffuse reflection); each individual ray still obeys \(\theta_i = \theta_r\), but the surface as a whole throws the light everywhere and you see no image.

    Ray diagram of reflection and refraction at a boundary between media n1 and n2.
    Figure 31.4. Reflection and refraction at a boundary. The reflected ray obeys \(\theta_r = \theta_1\). The refracted ray bends toward the normal on entering the slower medium (\(n_2 > n_1\)), as Snell’s law \(n_1\sin\theta_1 = n_2\sin\theta_2\) requires.
    Figure descriptionA ray diagram at a horizontal interface between two media, the lighter upper medium n sub 1 being faster and the darker lower medium n sub 2 slower. A dashed vertical normal line crosses the interface at the point where a red incident ray arrives from the upper left at angle theta sub 1 to the normal. A reflected ray leaves back into the upper medium at an equal angle theta sub r on the other side of the normal. A blue refracted ray continues into the lower medium at a smaller angle theta sub 2, bent toward the normal because the lower medium is slower. All three angles are marked with arcs.

    Refraction requires one new idea. Light travels at \(c\) only in vacuum; in a material medium with permittivity \(\epsilon\) and permeability \(\mu\) it slows to \(v = 1/\sqrt{\mu\epsilon} < c\). We capture this slowdown in a single number, the index of refraction:

    \[n = \frac{c}{v} \ \ (\ge 1). \tag{31.5}\]

    Vacuum has \(n = 1\); air is very nearly \(1\); water is \(1.33\); typical glass about \(1.52\); diamond \(2.42\). The greater \(n\) is, the slower light moves and the more sharply a ray bends. The bending is governed by Snell’s law, which relates the angles on the two sides of the boundary to the two indices (Figure 31.4):

    Key Equation: Snell’s law of refraction

    \[n_1\sin\theta_1 = n_2\sin\theta_2. \tag{31.6}\]

    A ray entering a slower (higher-\(n\)) medium bends toward the normal; entering a faster (lower-\(n\)) medium it bends away. (The frequency of the light is unchanged on crossing; since \(v = f\lambda\) changes, the wavelength in the medium shrinks to \(\lambda_n = \lambda/n\).)

    Example 31.3: Into a slab of crown glass

    A ray of wavelength \(589\,\mathrm{nm}\) traveling through air (\(n_1 = 1.00\)) strikes a flat slab of crown glass (\(n_2 = 1.52\)) at \(30.0^{\circ}\) to the normal.

    1. Find the angle of refraction.
    2. Find the speed of the light once it enters the glass.
    Solution

    (a) Apply Snell’s law, equation (31.6), and solve for \(\theta_2\):

    \[\sin\theta_2 = \frac{n_1\sin\theta_1}{n_2} = \frac{(1.00)\sin 30.0^{\circ}}{1.52} = \frac{0.500}{1.52} = 0.329,\]

    \[\theta_2 = \arcsin(0.329) = \boxed{19.2^{\circ}}.\]

    The ray bends toward the normal, as expected on entering a slower medium.

    (b) The speed in the glass follows from the definition of the index, equation (31.5):

    \[v = \frac{c}{n_2} = \frac{3.00\times10^8}{1.52} = \boxed{1.97\times 10^{8}\,\mathrm{m/s}}.\]

    Light loses about a third of its vacuum speed inside the glass, and it is precisely this slowing that bends the ray.

    Example 31.4: A ray through a parallel-sided slab

    A ray passes from medium 1 into a thick slab of index \(n_2\) with flat, parallel faces, and exits back into medium 1 on the far side. Show that the emerging ray is parallel to the original incident ray.

    Solution

    At the first face Snell’s law gives

    \[n_1\sin\theta_1 = n_2\sin\theta_2.\]

    Because the two faces are parallel, the normal at the second face is parallel to the normal at the first, and the ray inside the slab strikes the second face at the same angle \(\theta_2\) it made leaving the first. Applying Snell’s law at the second face, with the ray going from \(n_2\) back into \(n_1\) and emerging at angle \(\theta_3\),

    \[n_2\sin\theta_2 = n_1\sin\theta_3.\]

    The right-hand side of the first equation equals the left-hand side of the second, so \(n_1\sin\theta_1 = n_1\sin\theta_3\), giving

    \[\boxed{\theta_3 = \theta_1}.\]

    The exit ray makes the same angle with the normal as the entry ray, so the two are parallel. The slab does not change the ray’s direction; it merely shifts it sideways by a small parallel displacement. (This is why looking through a thick window does not visibly distort the scene: it only nudges it.)

    Checkpoint 31.4

    You see your face in a bathroom mirror but not in a sheet of white printer paper, even though both are reflecting nearly all the light that hits them. Using the law of reflection, explain the difference between the two surfaces.

    Answer

    Answers to Checkpoints

    Checkpoint 31.4. Both surfaces obey the law of reflection at every point; the difference is their smoothness. A mirror is flat on the scale of the light’s wavelength, so parallel rays arriving from your face leave parallel and preserve the image: specular reflection. Paper is a jumble of fibers tilted every which way, so each ray reflects off a surface element with its own orientation, and the rays scatter in all directions: diffuse reflection. The paper returns the light, but not the image.


    This page titled 31.4: Reflection and Refraction was last modified on Thu, 12 Nov 2026 04:26:55 GMT and is shared under a CC BY 4.0 license and was authored, remixed, and/or curated by Michael Ragsdale.