Opening the book…
Two rules, stated by Gustav Kirchhoff in 1845 while still a student, are enough to analyze any dc circuit. Both are conservation laws in disguise.
The junction rule. Charge does not pile up anywhere in a circuit carrying steady currents, so the total current flowing into any junction must equal the total current flowing out of it (Chapter 20). This is the junction rule:
Key Equation: Kirchhoff’s junction rule
\[\sum I_{\text{in}} = \sum I_{\text{out}}. \tag{21.2}\]
The loop rule. The electric potential has a single value at each point (Chapter 18). So if you start at any point in a circuit, travel around any closed loop, adding up the changes in potential across each element you pass, and return to the starting point, you must arrive back at the same potential. The changes must add to zero. This is the loop rule:
Key Equation: Kirchhoff’s loop rule
\[\sum_{\text{closed loop}} \Delta V = 0. \tag{21.3}\]
It is a statement of energy conservation: a charge carried around the loop gains as much potential energy in the sources of emf as it loses in the resistors.
To use the loop rule, you need the sign of the potential change across each element, which depends on the direction in which you cross it (Figure 21.5):
- Crossing a resistor in the direction of the current, you go from high potential to low: \(\Delta V = -IR\). Crossing it against the current, \(\Delta V = +IR\).
- Crossing a battery from its negative terminal to its positive terminal, \(\Delta V = +\mathcal{E}\). Crossing it from positive to negative, \(\Delta V = -\mathcal{E}\). The direction of the current through the battery does not matter.
The basic circuit. The simplest complete circuit is a single battery connected to a single resistor (Figure 21.6). Starting at point \(a\) and traveling clockwise, with the current, we rise by \(\mathcal{E}\) crossing the battery and fall by \(IR\) crossing the resistor. The wires cause no change. The loop rule gives
\[\mathcal{E} - IR = 0, \qquad\text{so}\qquad I = \frac{\mathcal{E}}{R}.\]
The graph in Figure 21.6 plots the potential around the loop. It is like a roller coaster with a single lift hill: the battery raises the charge by \(\mathcal{E}\), and all of that height is lost in the resistor. The whole potential difference of the battery appears across the resistor, because the ideal wires take none of it.
Example 21.2: A loop with two batteries
In the circuit of Figure 21.7, \(\mathcal{E}_1 = 12\,\mathrm{V}\), \(\mathcal{E}_2 = 6.0\,\mathrm{V}\), \(R_1 = 4.0\,\mathrm{\Omega}\), and \(R_2 = 2.0\,\mathrm{\Omega}\). Find the current, and the potential difference \(V_b - V_a\) across \(R_2\).
Solution
There is only one loop, so there is only one current \(I\). Its direction is not obvious, since the batteries push in opposite directions, so guess: clockwise, as drawn. Starting at the bottom left corner and going clockwise, we cross \(\mathcal{E}_1\) from \(-\) to \(+\) (\(+\mathcal{E}_1\)), \(R_1\) with the current (\(-IR_1\)), \(\mathcal{E}_2\) from \(+\) to \(-\) (\(-\mathcal{E}_2\)), and \(R_2\) with the current (\(-IR_2\)):
\[\mathcal{E}_1 - IR_1 - \mathcal{E}_2 - IR_2 = 0 \quad\Longrightarrow\quad I = \frac{\mathcal{E}_1 - \mathcal{E}_2}{R_1 + R_2} = \frac{12 - 6.0}{4.0 + 2.0} = \boxed{1.0\,\mathrm{A}}.\]
The answer is positive, so the guess was right: the current is clockwise. Had it come out negative, the current would simply flow the other way, with the same magnitude. Across \(R_2\) the current flows from \(b\) to \(a\), from high potential to low, so \(V_b - V_a = +IR_2 = \boxed{2.0\,\mathrm{V}}\).
Multiloop circuits. When a circuit has more than one loop, the currents in different branches differ. A branch is a stretch of circuit between two junctions, and it carries a single current. Label each branch current with a symbol and a guessed direction; write the junction rule at enough junctions (one fewer than the number of junctions); and write the loop rule for enough independent loops to have as many equations as unknown currents.
Note: A strategy for Kirchhoff’s-law problems
- Draw the circuit, and label every branch current with a symbol and an arrow. The direction is a guess; a negative answer means the current flows the other way.
- Apply the junction rule to all but one of the junctions.
- Choose loops, each containing at least one element not in the others, and apply the loop rule to each, using the sign rules of Figure 21.5.
- Solve the equations. Check the answer by applying the loop rule to a loop you did not use.
Example 21.3: A two-loop circuit
Find the three currents in the circuit of Figure 21.8, with \(\mathcal{E}_1 = 12\,\mathrm{V}\), \(\mathcal{E}_2 = 6.0\,\mathrm{V}\), \(R_1 = 2.0\,\mathrm{\Omega}\), \(R_2 = 3.0\,\mathrm{\Omega}\), and \(R_3 = 6.0\,\mathrm{\Omega}\).
Solution
The circuit has two junctions, \(a\) and \(b\), and three branches. Take \(I_1\) and \(I_2\) upward through the outer branches, into \(a\), and \(I_3\) downward through \(R_3\), out of \(a\). The junction rule at \(a\):
\[I_1 + I_2 = I_3.\]
Loop 1 (the left loop, clockwise from \(b\)): up through \(\mathcal{E}_1\) and \(R_1\), then down through \(R_3\):
\[\mathcal{E}_1 - I_1R_1 - I_3R_3 = 0 \quad\Longrightarrow\quad 12 - 2.0I_1 - 6.0I_3 = 0.\]
Loop 2 (the right loop, counterclockwise from \(b\)): up through \(\mathcal{E}_2\) and \(R_2\), then down through \(R_3\):
\[\mathcal{E}_2 - I_2R_2 - I_3R_3 = 0 \quad\Longrightarrow\quad 6.0 - 3.0I_2 - 6.0I_3 = 0.\]
From the loop equations, \(I_1 = 6.0 - 3.0I_3\) and \(I_2 = 2.0 - 2.0I_3\). Substituting into the junction rule, \(8.0 - 5.0I_3 = I_3\), so
\[I_3 = \boxed{1.33\,\mathrm{A}}, \qquad I_1 = \boxed{2.0\,\mathrm{A}}, \qquad I_2 = \boxed{-0.67\,\mathrm{A}}.\]
The negative sign means \(I_2\) actually flows downward through \(\mathcal{E}_2\), into its positive terminal. The stronger battery is driving current backward through the weaker one, charging it. Check with the outer loop, clockwise from \(b\): \(\mathcal{E}_1 - I_1R_1 + I_2R_2 - \mathcal{E}_2 = 12 - 4.0 - 2.0 - 6.0 = 0\). ✓
Checkpoint 21.2
In Figure 21.6, suppose you travel around the loop counterclockwise, against the current. Write the loop-rule equation you would get, and show that it gives the same current.
Energy and Power in a Circuit
The loop rule is an energy statement, and multiplying it by the current turns it into a statement about power. In the basic circuit, \(\mathcal{E} = IR\); multiplied by \(I\),
\[\mathcal{E}I = I^2R.\]
The left side is the rate at which the battery does work on the charge passing through it, and the right side is the rate at which the resistor turns electrical energy into heat (Section 20.4). The battery supplies exactly the power the resistor dissipates.
In general, a source of emf delivers power
Key Equation: Power delivered by a source of emf
\[P = \mathcal{E}I \tag{21.4}\]
when the current flows through it from its negative terminal to its positive terminal, the normal direction for a battery that is discharging. When a larger emf forces current through a battery the other way, into its positive terminal, the battery absorbs power \(\mathcal{E}I\): it is being charged, and the electrical energy is stored as chemical energy. This is what happens when a car’s alternator charges its battery, or when you plug in a phone. In every circuit, the power delivered by the sources equals the power absorbed by everything else.
Example 21.4: Energy bookkeeping
Account for the power in each element of the circuit of Example 21.2.
Solution
The current is \(I = 1.0\,\mathrm{A}\), clockwise. It flows through \(\mathcal{E}_1\) from \(-\) to \(+\), so that battery delivers \(\mathcal{E}_1I = (12)(1.0) = 12\,\mathrm{W}\). It flows through \(\mathcal{E}_2\) from \(+\) to \(-\), so that battery absorbs \(\mathcal{E}_2I = 6.0\,\mathrm{W}\): it is being charged. The resistors dissipate \(I^2R_1 = 4.0\,\mathrm{W}\) and \(I^2R_2 = 2.0\,\mathrm{W}\). The books balance:
\[\underbrace{12\,\mathrm{W}}_{\text{delivered}} = \underbrace{6.0\,\mathrm{W}}_{\text{stored in }\mathcal{E}_2} + \underbrace{4.0\,\mathrm{W} + 2.0\,\mathrm{W}}_{\text{heat}}.\]
Half of the power delivered by the first battery goes into charging the second, and half is lost as heat.
Answers to Checkpoints
Checkpoint 21.2. Start at \(a\) and go counterclockwise: along the bottom to the resistor, up through the resistor, along the top, and down through the battery. Crossing the resistor against the current, you go from low potential to high, a rise of \(+IR\). Crossing the battery from its positive terminal to its negative terminal, you drop by \(\mathcal{E}\). Back at \(a\) the changes must sum to zero: \(+IR - \mathcal{E} = 0\), so \(I = \mathcal{E}/R\), the same current. The loop rule does not care which way you travel, provided every sign follows the direction you actually cross each element.
This page titled 21.2: Kirchhoff’s Laws and the Basic Circuit was last modified on Thu, 12 Nov 2026 04:26:45 GMT and is shared under a CC BY 4.0 license and was authored, remixed, and/or curated by Michael Ragsdale.
The book could not be loaded just now.