2.4: Motion Graphs

Physics: A Foundation for Scientists and Engineers · LibreTexts

0%

Contents

    Text

    Size
    100%
    Theme
    Typeface
    Line length
    Spacing

    Read aloud

    How

    Speed: 1×
    Light up
    Highlight

    Symbols: Mulberry Symbols, © 2018–2026 Steve Lee, CC BY-SA 4.0 (licence, the set), the site's own copies.

    From LibreTexts, under CC BY 4.0, as the source states it; its equations are written in TeX, which the PDF shows typeset. This page at LibreTexts.

    2.4: Motion Graphs

    Much of the physical content of this chapter can be read directly off a graph, without solving a single equation. Two ideas do all the work, and both follow from definitions you have already seen.

    Slopes give you the next quantity down. Velocity is the derivative of position, and a derivative is a slope. So:

    • The slope of a position–time graph at any instant is the velocity at that instant.
    • The slope of a velocity–time graph at any instant is the acceleration at that instant.

    Steep means fast; flat means stopped (on an \(x\)–\(t\) graph) or coasting at constant velocity (on a \(v\)–\(t\) graph); downward-sloping means negative.

    Areas give you the previous quantity back. Running the derivative backwards, the area between a curve and the horizontal axis accumulates the quantity one level up:

    • The area under a velocity–time graph over an interval is the displacement \(\Delta x\) during that interval.
    • The area under an acceleration–time graph over an interval is the change in velocity \(\Delta v\).

    That the first of these is true is easiest to see for constant velocity: if \(v\) is a constant \(5\,\mathrm{m/s}\) for \(3\,\mathrm{s}\), the region under the graph is a rectangle of height \(5\) and width \(3\), and its “area” is \(15\,\mathrm{m}\), exactly the displacement. Any varying velocity can be sliced into thin strips, each of which is nearly a rectangle of that kind, and the strips add up.

    Key Equation: Areas under a velocity–time graph

    \[\Delta x = \text{signed area under the } v\text{--}t \text{ curve}, \qquad \Delta v = \text{signed area under the } a\text{--}t \text{ curve}. \tag{2.7}\]

    The word signed is essential. Area lying above the horizontal axis counts as positive; area lying below it counts as negative, and cancels against the positive part. This is exactly the distance-versus-displacement distinction wearing a different hat: add the signed areas and you get displacement; add their absolute values and you get distance traveled.

    Three stacked graphs sharing one time axis, describing a single motion of a car in three phases.
    Figure 2.3. One motion, three graphs, one shared time axis. A car starts from rest and accelerates at \(2\,\mathrm{m/s^2}\) for \(3\,\mathrm{s}\) (Phase 1), cruises at \(6\,\mathrm{m/s}\) for \(3\,\mathrm{s}\) (Phase 2), then brakes at \(3\,\mathrm{m/s^2}\) until it stops at \(t = 8\,\mathrm{s}\) (Phase 3). The slope of the top graph is the middle graph; the slope of the middle graph is the bottom graph. Equivalently, the area under the bottom graph builds the middle one, and the area under the middle graph builds the top one.
    Figure descriptionThree stacked graphs sharing one time axis, describing a single motion of a car in three phases. The top graph shows position rising, first curving upward during phase one as the car accelerates from rest at two meters per second squared for three seconds, then rising as a straight line during phase two as it cruises at six meters per second for three seconds, then curving over as it brakes in phase three. The middle graph shows velocity: a straight rise to six meters per second, a horizontal segment, then a fall back to zero. The bottom graph shows acceleration as a step function: positive and constant, then zero, then negative and constant.
    A velocity-versus-time graph used to find displacement as signed area.
    Figure 2.4. Displacement as signed area. Between \(t = 0\) and \(t = 6\,\mathrm{s}\) the velocity is positive and the shaded region above the axis contributes \(+20\,\mathrm{m}\). Between \(t = 6\,\mathrm{s}\) and \(t = 8\,\mathrm{s}\) the velocity is negative and the region below the axis contributes \(-4\,\mathrm{m}\). The net displacement over the full \(8\,\mathrm{s}\) is \(+16\,\mathrm{m}\); the total distance traveled is \(24\,\mathrm{m}\).
    Figure descriptionA velocity-versus-time graph used to find displacement as signed area. From zero to six seconds the velocity is positive and the region between the curve and the time axis is shaded above the axis, contributing plus twenty meters. From six to eight seconds the velocity is negative and the shaded region lies below the axis, contributing a negative amount. The net displacement is the sum of the two signed areas.

    Reading the three graphs together

    The clearest way to see all of this at once is to stack the three graphs for a single motion with their time axes aligned, as in Figure 2.3. Trace a vertical line down through all three panels at any instant and read off position, velocity, and acceleration simultaneously. Notice in particular:

    • Where \(a\) is constant and positive (Phase 1), \(v\) is a straight line with positive slope and \(x\) curves upward.
    • Where \(a = 0\) (Phase 2), \(v\) is flat and \(x\) is a straight line: constant velocity.
    • Where \(a\) is constant and negative (Phase 3), \(v\) is a straight line with negative slope and \(x\) curves downward, flattening out as the car comes to rest.

    The car is moving forward the entire time, so \(x\) never decreases, not even in Phase 3, where the acceleration is negative. Negative acceleration bends the position curve downward; it does not, by itself, send the car backwards.

    Example 2.2: Getting everything from a velocity–time graph

    Use the velocity–time graph in Figure 2.4 to find

    1. the acceleration during each phase of the motion;
    2. the time at which the particle reverses direction;
    3. the displacement over the full \(8\,\mathrm{s}\);
    4. the total distance traveled over the full \(8\,\mathrm{s}\);
    5. the average velocity and average speed over the full \(8\,\mathrm{s}\).
    Solution

    (a) Acceleration is the slope of the \(v\)–\(t\) graph: rise over run, \(\Delta v/\Delta t\). From \(t = 0\) to \(4\,\mathrm{s}\) the graph is flat, so its rise is zero and \(a = 0\). From \(t = 4\,\mathrm{s}\) to \(8\,\mathrm{s}\) the velocity falls from \(+4\) to \(-4\,\mathrm{m/s}\). The change is always final minus initial:

    \[a = \frac{\Delta v}{\Delta t} = \frac{(-4) - (+4)}{8 - 4}\,\frac{\mathrm{m/s}}{\mathrm{s}} = \frac{-8}{4}\,\mathrm{m/s^2} = -2.00\,\mathrm{m/s^2}.\]

    The velocity drops by \(8\,\mathrm{m/s}\), not \(4\,\mathrm{m/s}\), because it passes through zero on the way: \(4\) units down to the axis and \(4\) more below it.

    (b) The particle reverses direction where the velocity changes sign, where the graph crosses the axis, at \(t = 6\,\mathrm{s}\). Note that this is not where the acceleration changes; the acceleration has been \(-2\,\mathrm{m/s^2}\) since \(t = 4\,\mathrm{s}\) and continues unchanged through the turnaround.

    (c) Displacement is the signed area. On a \(v\)–\(t\) graph, a width is measured in seconds and a height in meters per second, so every area comes out in \(\mathrm{s} \times \mathrm{m/s} = \mathrm{m}\): a displacement, as it should be.

    The region above the axis is a trapezoid (a four-sided figure with two parallel sides). Its parallel sides are horizontal: the top edge runs from \(t = 0\) to \(t = 4\,\mathrm{s}\) (length \(4\,\mathrm{s}\)), and the bottom edge along the axis runs from \(t = 0\) to \(t = 6\,\mathrm{s}\) (length \(6\,\mathrm{s}\)). The distance between them is the height, \(4\,\mathrm{m/s}\). The area of a trapezoid is the average of the parallel sides times the distance between them:

    \[A_+ = \tfrac{1}{2}(4 + 6)(4)\,\mathrm{m} = \tfrac{1}{2}(10)(4)\,\mathrm{m} = +20.0\,\mathrm{m}.\]

    If you don’t remember the trapezoid formula, split the region into a rectangle (\(t = 0\) to \(4\,\mathrm{s}\)) and a triangle (\(t = 4\,\mathrm{s}\) to \(6\,\mathrm{s}\)): \((4)(4) + \tfrac{1}{2}(2)(4) = 16 + 4 = 20\,\mathrm{m}\). Same answer.

    The region below the axis is a triangle of base \(2\,\mathrm{s}\) and height \(4\,\mathrm{m/s}\). It lies below the axis, so its area counts as negative:

    \[A_- = -\tfrac{1}{2}(2)(4)\,\mathrm{m} = -4.00\,\mathrm{m}.\]

    The displacement is the sum of the signed areas, \(\Delta x = A_+ + A_- = 20.0 + (-4.00) = +16.0\,\mathrm{m}\).

    (d) The distance ignores the signs and adds the magnitudes: \(\left|A_+\right| + \left|A_-\right| = 20.0 + 4.00 = 24.0\,\mathrm{m}\).

    (e) Dividing each by the elapsed time,

    \[v_{\mathrm{avg}} = \frac{16.0\,\mathrm{m}}{8.00\,\mathrm{s}} = 2.00\,\mathrm{m/s}, \qquad s_{\mathrm{avg}} = \frac{24.0\,\mathrm{m}}{8.00\,\mathrm{s}} = 3.00\,\mathrm{m/s}.\]

    As promised, the average speed is not the absolute value of the average velocity.

    Checkpoint 2.5

    A position–time graph is a parabola opening downward, and the particle’s position is increasing at \(t = 0\). What are the signs of \(v\) and \(a\) at \(t = 0\)? Is the particle speeding up or slowing down? What eventually happens to it?

    Answer

    Answers to Checkpoints

    Checkpoint 2.5. The position is increasing, so the slope of the \(x\)–\(t\) graph is positive: \(v > 0\). A parabola opening downward curves downward, so \(a < 0\). Opposite signs mean the particle is slowing down. It eventually comes momentarily to rest at the vertex of the parabola (its maximum \(x\)), then moves back in the \(-x\) direction, speeding up as it goes, since then \(v\) and \(a\) are both negative.


    This page titled 2.4: Motion Graphs was last modified on Thu, 12 Nov 2026 04:26:47 GMT and is shared under a CC BY 4.0 license and was authored, remixed, and/or curated by Michael Ragsdale.