Opening the book…
In general, on design is the process used to size and create engine component. It is used to determine component dimensions, mass flow rates, pressure ratios, and geometry. It occurs at a single, chosen to set of flight conditions (Mach number \(M_0\), altitude \(h\), and ambient conditions) and maximum operating limits (such as turbine inlet temperature \(T_{t4}\)). The physical size and internal engine components (e.g., compressor inlet area \(A_2\), turbine nozzle blade angles, nozzle exit area \(A_8/A_9\)) are not fixed beforehand. Instead, they are calculated to meet specific performance requirements (such as achieving the required thrust or optimizing specific fuel consumption). To determine the required airflow, physical component sizes, and baseline cycle parameters needed to satisfy mission requirements at a critical flight condition (often cruise or takeoff).
Off-Design analysis is the process of taking a fixed, already-designed geometry (from the on-design) and simulating how it behaves when operating under different conditions. Off-design analysis evaluates how an engine behaves when operating away from its design point—such as during different flight phases (climb, loiter, descent, idle), changing Mach numbers, varying altitudes, or throttled-back power settings. The physical component sizes and geometry determined during on-design analysis are now fixed (or varied dynamically if using variable-geometry hardware, like variable inlet guide vanes). To predict engine performance (thrust, fuel consumption, spool (rotating assembly of turbine, compressor or fan and the shaft connected compressor to turbine) speeds, component efficiencies, and mass flow rates) across the full flight envelope given a fixed hardware configuration.
Example to show the difference between on/off design, by designing supersonic Concorde turbojet engine:
On Design: engineers chose Mach 2 and 50,000 ft, the physical geometry and baseline cycle parameters were calculated, so Concorde could efficiently travel faster than the speed of sound, a, so the needed physical sizes was calculated such as the precise cross sectional area of the intake, engine’s core diameter and the nozzle expansion geometry to perform the optimal fuel burn and thrust while it is cruising at Ma =2. At this stage physically the engine was not set yet.
Off Design: Before spending millions of dollars building a physical prototype, engineers run off-design computer simulations using the fixed dimensions calculated in on design.
Concorde had to operate in real world but far from \(Ma =2\) cruise point. Concorde had to taxi on the tarmac at 15 knots, take off from London Heathrow at subsonic speeds, hold over airports in heavy air traffic, and fly over land at Mach 0.95 (due to noise regulations prohibiting sonic booms). Because the engine’s physical core size and turbomachinery geometry were fixed by the design step, the engine control unit (and variable inlet ramps) had to adjust fuel flow and inlet airflow control to keep the engine running smoothly and safely without stalling or overheating. The engine hardware dimensions were fixed, and performance was calculated based on throttle adjustments and changing environmental conditions. Once the design passes both on-design and off-design computer simulations, the first physical prototype is manufactured.
This page titled 4.2: On/Off Design Analysis was last modified on Wed, 18 Nov 2026 07:18:32 GMT and is shared under a CC BY 4.0 license and was authored, remixed, and/or curated by Haifa El-Sadi.
The book could not be loaded just now.