Opening the book…
Cuttings from herbaceous plants are typically easier to root than wood stems since there is more active tissue in the herbaceous plant parts. In general, you only need to apply rooting hormones on the most stubborn of species. Since all herbaceous plants are active (not dormant) with leaves, desiccations is a risk. Herbaceous cutting can be taken from multiple organs.
Stem cutting are taken from stems. They should be 4-6 inches long and include a shoot tip along with some leaves. The lower leaves should be removed such that only 1-2 leaves remain. As with the softwood and semi-hardwood cuttings, if the leaves are very large their area should be reduced via trimming. The lowest node is where the root development with take place so make sure it is firmly inserted into the media. If leaves touch the media, try to trim or remove them so they don’t. If the leaves touch the wet media they are more like to rot and potentially compromise the cutting. Rooting media can be as simple as water, or wet sand to vermiculite, perlite, or peat moss. Mostly the medium has to provide water but also allow oxygen to the newly forming roots.
Some plants respond well to leaf cutting. In leaf cutting a leaf with part of the stem or even just part of the leaf can be used to create new propagules. With some plants, rooting hormones can be helpful just to speed up the process. In these cases, the removed part does not contribute significantly to the new plantlet. In Figure 9-24-A the thick leaves of Mother-in-law’s tongue can be cut into 2-3 inches long segments. Roots will form first and then a new plant arises from the base of the cut, after roots and a new rhizome has been established. Likewise, with African violets (Figure 9-24-B), the new plant emerges from the base of the petiole to the leaf blade. As was mentioned in the earlier in this section, it important to maintain polarity of the cuttings. For leaves like the African violet, this is easy to determine. However, a section from the middle of the Mother-in-law’s tongue leaf look about the same regardless of orientation. If placed upside down in the medium, it might eventually produce a new plant, but only after roots form at the “top’’and then grow down in the media. Many cuttings placed upside down will just rot.
This page titled 9.2.2: Cuttings from Herbaceouse Plants was last modified on Sat, 14 Nov 2026 17:11:56 GMT and is shared under a CC BY-NC-SA 4.0 license and was authored, remixed, and/or curated by Stephanie Harvey.
The book could not be loaded just now.