Opening the book…
The average greenhouse crop needs about 10 to 12 mol/m2/d. The structure of the greenhouse itself blocks about 35% of the incoming solar radiation. During the winter months, when DLI is low, the light levels can fall below the required levels (Figure 5-26). For example, on a cloudy day in winter levels can drop to as low three mol/m2/d outside which means within the greenhouse levels would be approximately 1.95 mol/m2/d.
Artificial light can also be added to make-up the difference and enhance growth. Plant quality generally increases as the average DLI (daily light interval) increases even beyond “required” amount (with exception of true shade plants). The use of artificial lighting with plants is typically categorized into three types: Supplemental lighting, Photoperiodic lighting, and Sole-source lighting.
Supplemental Lighting
Supplemental light is used to boost existing light levels. These lamps emit moderate light intensity. Adding 60-120 µmol/m2/s to the ambient light level. Supplemental lighting is used when the natural DLI is low. This may be due to the low intensity of the solar radiation or too short day length. Plants can be illuminated from directly above or, for tall dense canopies, from within the canopy to provide light to lower levels of the plant. This ability to hang lights within the crop canopy is only possible due to the invention of low-heat emitting lights – for example LEDs sources.
Photoperiodic Lighting
For plants that are sensitive to photoperiods, photoperiodic lighting can be used to influence plant growth and development. Photoperiodic lighting is accomplished with low intensity lamps (1-2 µmol/m2/s1). Depending on the nature of the plant, the addition of this low intensity light can induce or inhibit flowering. The most common method for this technique is to deliver 1 to 2 μmol/m2/s1 of light for four hours during the night (or at the end of the day) from lamps that at least partly emit red +/- far red light. Incandescent lamps – rich in the red – were the traditional instrument used to deliver this light. However, modern LEDs have replaced the incandescent lamps as they are more efficient.
Sole-source Lighting
Sole-source lighting is used when plants are completely dependent on artificial light for their energy and developmental cues. This occurs when plants are grown indoors without natural light exposure (Figure 5-29). To reach the light requirements of the plants, high-intensity lighting (150 to 200 μmol/m2/s1) is needed, and it typically runs 18-24 hours per day. Night cycles and photoperiodic lighting can be added if necessary for plant health and development.
There are multiple lighting solutions available for growers. The addition of artificial light can be costly so there are multiple things to consider.
- The cost to purchase and install – Are the fixtures themselves expensive? Do they include the lamps (bulbs)? Does it take specialized training to install the fixtures?
- Cost to operate – How much energy is consumed to produce the needed light intensity? How long will the lamps last before they need to be replaced? What is their cost and what is the labor involved in replacing old lamps?
- Spectrum of light needed – different sources emit different light spectrum. If you need red light to induce flowering, does your light source have enough red, or do you need to include additional sources to provide photoperiodic lighting?
- Intensity of light produced – Can the source produce the light intensity needed for your crop under you growing conditions? Will this intensity modify the temperature or water requirements of the plants?
- Structural Requirements – Can your existing structure (greenhouse) support the weight of the lighting units? Will the units create problems for existing mechanization in the greenhouse?
With the cost, both in time and funds, getting the lighting correct for your specific situation is critical. For large spaces, working with an engineer to calculate loads, cost, square-footage, energy consumption is advisable. Many lighting companies will provide this service.
This page titled 5.5.2: Artificial Lighting was last modified on Fri, 13 Nov 2026 17:24:56 GMT and is shared under a CC BY-NC-SA 4.0 license and was authored, remixed, and/or curated by Stephanie Harvey.
The book could not be loaded just now.