Learn · Automation In Manufacturing
Lecture 4 of 38Week 2: Design of an automated system
Lec 4: Automated systems and equipment used in manufacturing part-I
Prof. Shrikrishna N. Joshi · IIT Guwahati
Credits and licence
- From
- Automation In Manufacturing, IIT Guwahati (at NPTEL)
- Licence
- CC BY-NC-SA, as NPTEL states it. Non-commercial use only.
- Attribution
- NPTEL states: "Distributed under Creative Commons Attribution-ShareAlike / CC BY - NC - SA", beside a BY-NC-SA badge.
- Who can watch
- Tweens profiles and older. How courses are placed
All the lectures
- Lec 1: Basic concepts
- Lec 2: Mechatronics
- Lec 3: Mechatronics based systems
- Lec 4: Automated systems and equipment used in manufacturing part-I
- Lec 5: Automated systems and equipment used in manufacturing part-II
- Lec 6: Selection of electrical and electronics components for mechatronics based systems
- Lec 7: Terms related to performance of electro-mechanical systems
- Lec 8: Computer aided design of components
- Lec 9: Fabrication Processes
- Lec 10: Measurement system and potentiometer sensors
- Lec 11: Displacement, position and proximity sensors - I
- Lec 12: Displacement, position and proximity sensors - II
- Lec 13: Fluid flow, pressure, and temperature measurement
- Lec 14: Signal Conditioning : amplification, filtering
- Lec 15: Pulse modulation, Protection devices, and Wheatstone bridge
- Lec 16: Signal conversion
- Lec 17: Microprocessor Technology
- Lec 18: Introduction to Microprocessor Programming
- Lec 19: Application of electric drives in automation
- Lec 20: DC and AC motors
- Lec 21 Stepper motor and servo motor
- Lec 22: Types of industrial automation and mechanisms
- Lec 23: Ball screw based linear motion drives
- Lec 24: Application of cams in automation
- Lec 25: Application of indexing mechanisms in automation
- Lec 26: Application of tool magazines in automation
- Lec 27: Material handling systems
- Lec 28: Fundamental concepts
- Lec 29: Hydraulic pumps
- Lec 30: Direction control valves
- Lec 31: Flow control and pressure relief valves
- Lec 32: Graphical representation of hydraulic system elements
- Lec 33: Basic concepts and air compressors
- Lec 34: Air treatment and pressure regulation
- Lec 35: Graphical representation and pneumatic circuits
- Lec 36: Computer aided manufacturing and process planning
- Lec 37: CNC machines and interpolation
- Lec 38: CNC programming