Learn · Plastic Working of Metallic Materials

Lecture 16 of 38Forging - II

Lec 16: Forging Die Design consideration

Prof. P. S. Robi · IIT Guwahati

Credits and licence

From
Plastic Working of Metallic Materials, IIT Guwahati (at NPTEL)
Licence
CC BY-NC-SA, as NPTEL states it. Non-commercial use only.
Attribution
NPTEL states: "Distributed under Creative Commons Attribution-ShareAlike / CC BY - NC - SA", beside a BY-NC-SA badge.
Who can watch
Tweens profiles and older. How courses are placed

All the lectures

  1. Lec 1: Introduction to Plastic Working of Metals Video
  2. Lec 2: Uniaxial Tension Test Analysis Video
  3. Lec 3: Temperature effects in metal forming Video
  4. Lec 4: Friction and Lubrication Video
  5. Lec 5: Friction and Lubrication (contd.) Video
  6. Lec 6: Deformation zone + worked examples Video
  7. Lec 7: Stresses at point & Theory of Plasticity Video
  8. Lec 8: Slab Analysis Video
  9. Lec 9: Slip Line Field Theory-part1 Video
  10. Lec 10: Slip Line Field Theory-Part2 Video
  11. Lec 11:Upper Bound Theorem Video
  12. Lec 12: Plasticity equations Video
  13. Lec 13: Forging Video
  14. Lec 14: Analysis of Forging Video
  15. Lec 15: Analysis of Forging Contd. Video
  16. Lec 16: Forging Die Design consideration Video
  17. Lec 17: Forging Load Video
  18. Lec 18: Rolling of Metals Video
  19. Lec 19: Analysis of Rolling Video
  20. Lec 20: Analysis of Rolling (Contd..) Video
  21. Lec 21:Strain rate in the deformation zone Video
  22. Lec 22: Rolling mills Video
  23. Lec 23: Prblem on rolling Video
  24. Lec 24: Drawing of Rods, Wires and Tubes Video
  25. Lec 25: Drawing of Rods, Wires and Tubes (Contd.) Video
  26. Lec 26: Analysis of Wire Drawing Video
  27. Lec 27: Wire Drawing: Tutorial Problems Video
  28. Lec 28: Extrusion Process Video
  29. Lec 29: Analysis of Extrusion Video
  30. Lec 30: Introduction Video
  31. Lec 31: Sheet deformation process Video
  32. Lec 32: Deformation of sheet in plane stress Video
  33. Lec 33: Analysis of stamping Video
  34. Lec 34: Instability in sheet metal forming Video
  35. Lec 35: Deep drawing Video
  36. Lec 36: Hydroforming Video
  37. Live Session 06-09-2019 Video
  38. Live Session 27-09-2019 Video