Learn · Plastic Working of Metallic Materials
Lecture 19 of 38Rolling
Lec 19: Analysis of Rolling
Prof. P. S. Robi · IIT Guwahati
Credits and licence
- From
- Plastic Working of Metallic Materials, IIT Guwahati (at NPTEL)
- Licence
- CC BY-NC-SA, as NPTEL states it. Non-commercial use only.
- Attribution
- NPTEL states: "Distributed under Creative Commons Attribution-ShareAlike / CC BY - NC - SA", beside a BY-NC-SA badge.
- Who can watch
- Tweens profiles and older. How courses are placed
All the lectures
- Lec 1: Introduction to Plastic Working of Metals
- Lec 2: Uniaxial Tension Test Analysis
- Lec 3: Temperature effects in metal forming
- Lec 4: Friction and Lubrication
- Lec 5: Friction and Lubrication (contd.)
- Lec 6: Deformation zone + worked examples
- Lec 7: Stresses at point & Theory of Plasticity
- Lec 8: Slab Analysis
- Lec 9: Slip Line Field Theory-part1
- Lec 10: Slip Line Field Theory-Part2
- Lec 11:Upper Bound Theorem
- Lec 12: Plasticity equations
- Lec 13: Forging
- Lec 14: Analysis of Forging
- Lec 15: Analysis of Forging Contd.
- Lec 16: Forging Die Design consideration
- Lec 17: Forging Load
- Lec 18: Rolling of Metals
- Lec 19: Analysis of Rolling
- Lec 20: Analysis of Rolling (Contd..)
- Lec 21:Strain rate in the deformation zone
- Lec 22: Rolling mills
- Lec 23: Prblem on rolling
- Lec 24: Drawing of Rods, Wires and Tubes
- Lec 25: Drawing of Rods, Wires and Tubes (Contd.)
- Lec 26: Analysis of Wire Drawing
- Lec 27: Wire Drawing: Tutorial Problems
- Lec 28: Extrusion Process
- Lec 29: Analysis of Extrusion
- Lec 30: Introduction
- Lec 31: Sheet deformation process
- Lec 32: Deformation of sheet in plane stress
- Lec 33: Analysis of stamping
- Lec 34: Instability in sheet metal forming
- Lec 35: Deep drawing
- Lec 36: Hydroforming
- Live Session 06-09-2019
- Live Session 27-09-2019