Learn · NPTEL

Course108106159105 lectures

Power Management Integrated Circuits

Prof. Qadeer Ahmad Khan Prof. Raveesh Magod · IIT Madras

Start with lecture 1 At NPTEL

Lectures

Week 1

  1. Introduction to PMIC - Part 1 Video
  2. Introduction to PMIC - Part 2 Video
  3. Linear versus Switching Regulators Video
  4. Performance Parameters of Regulators Video
  5. Local vs Remote Feedback, Point of Load Regulators Video
  6. Kelvin Sensing, Droop Compensation Video
  7. Current Regulator Applications, Introduction to Bandgap Voltage References, PTAT and CTAT voltage Video
  8. Adding PTAT and CTAT Voltages Video
  9. Bandgap Voltage Reference Circuit, Brokaw Bandgap Circuit Video

Week 2

  1. Sub-1-volt Bandgap Circuit Video
  2. Generating Multiple Reference Voltages; Applications of Linear Regulators Video
  3. Designing a Linear Regulator, Negative and Positive Feedback Video
  4. First-Order Systems, Phase Margin Video
  5. Closed-Loop Response of Second-Order Systems Video
  6. Relationship between Damping Factor and Phase Margin, Frequency Compensation, MOS Parasitic Capacitances Video
  7. Finding the Poles of the Error Amplifier - Part 1 Video
  8. Finding the Poles of the Error Amplifier - Part 2 Video
  9. Dominant Pole Frequency Compensation Video
  10. Dominant Pole Compensation at No-Load Video

Week 3

  1. Dominant Pole Compensation using Miller Effect, RHP zero due to Miller Capacitor Video
  2. Intuitive Method of Finding the Poles, Pole Splitting after Miller Compensation Video
  3. Effect of RHP zero on Stability, Mitigating the Effect of RHP zero, LDO with NMOS Pass Element Video
  4. Output Impedance of PMOS LDO Video
  5. PSRR of PMOS LDO, Introduction to NMOS LDO Video
  6. Output Impedance & PSRR of NMOS LDO Video
  7. Sources of Error in Linear and Switching Regulators Video

Week 4

  1. Offset in Amplifiers; Real Life Analogy; Static Offset Cancellation Video
  2. Dynamic Offset Cancellation Techniques (Chopping, Auto-zeroing) Video
  3. Digital LDO, Technique to Avoid Limit Cycle Oscillations in Digital LDO Video
  4. Hybrid LDO, Short-Circuit Protection Video
  5. Hiccup Mode and Foldback Current Limit Video
  6. Introduction to Switching Regulators Video
  7. volt-second Balance, Non-Idealities in the Power Stage of a Buck Converter Video
  8. Transformer Model of a Buck Converter, Conduction Efficiency, Efficiency of an LDO versus Efficiency of a Switching Regulator Video
  9. Synchronous versus Non-Synchronous Switching Regulators, PWM Control Techniques Video
  10. Losses in Switching Regulators (Conduction Loss, Gate-Driver Switching Loss) Video
  11. Dead-Time Switching Loss in DC-DC Converters Video

Week 5

  1. Hard Switching Loss in DC DC Converters Video
  2. Magnetic Loss in DC-DC Converters, Relative Significance of Losses as a Function of the Load Current Video
  3. Output Voltage Ripple of a Buck Converter Video
  4. Choosing the Inductor and Capacitor for a Buck Converter Video
  5. CCM Vs DCM Operation in DC DC Converters Video
  6. CCM DCM Boundary Condition, Voltage Conversion Ratio in DCM Video
  7. Concept of Pulse Frequency Modulation PFM Video
  8. Classification of Pulse Width Modulators Video
  9. DC - DC Converter Control Techniques, Stability Analysis of Voltage Mode Buck Converter Part 1 Video
  10. Stability Analysis of Voltage Mode Buck Converter Part 2 Video
  11. Stability Analysis of Voltage Mode Buck Converter Part 3 Video

Week 6

  1. Dominant Pole Compensation (Type-I with Gm-C Architecture) Video
  2. Dominant Pole Compensation (Type-I with Op Amp-RC Architecture) Video
  3. Introduction to Type-II Compensation Video
  4. Type-II Compensator using Gm-C Architecture - Part 1 Video
  5. Type-II Compensator using Gm-C Architecture - Part 2 Video
  6. Type-II Compensator using Gm-C Architecture - Part 3 Video
  7. Type-II Compensator using Op Amp-RC Architecture Video
  8. Introduction to Type-III Compensator Video
  9. Type-III Compensator using Op Amp-RC Architecture Video
  10. Simulation of DC-DC Converter with Type-III Compensator Video

Week 7

  1. Type-III Compensator using Gm-C Architecture Video
  2. Feed-Forward Line Compensation, Loop Gain Compensation by Modulating Gm Video
  3. Designing a Buck Converter, Power Loss Budgeting Video
  4. Sizing Power MOSFETs Video
  5. Estimating Switching Losses and Choosing the Switching Frequency Video
  6. Choosing Inductance and Capacitance Values Video
  7. Choosing 'C' Depending on Factors that Limit the Load Transient Response Video
  8. Inductor and Capacitor Characteristics, Reducing the Effect of Capacitor ESL Video

Week 8

  1. Gate Buffer and Non-Overlap Clock Generator in Gate-Driver Circuit Video
  2. Pulse-Width Modulator- Trailing Edge, Leading Edge and Dual Edge; Triangle Wave Generator Video
  3. Average Ramp Voltage of Single-Edge PW Modulator,Design Considerations of EA Video
  4. Delays Associated with PW Modulator, PFM and PSM Operation, DCM Operation using NMOS Video
  5. Designing a Zero-Cross Comparator, Inverter-Based Auto-Zeroed Comparator, Simulation Demo Video
  6. Current Mode Control- Peak, Valley, Emulated; VMC versus CMC; Sub-Harmonic Oscillation Video
  7. Ramp-Adaptive Slope Compensation to Avoid Current Loop Instability Video

Week 9

  1. Non-Linear Control of DC-DC Converters, Phase-Shift between i_L and v_C Video
  2. Stabilising a Voltage-Mode Hysteretic Converter using R_esr, Relation between F_sw and the Hysteresis Window Video
  3. Hysteretic Converter - Simulation Demo Video
  4. Current-Mode Hysteretic Converter, Using R-C as Ripple Generator Video
  5. Controlling the Switching Frequency of a Hysteretic Converter, Delay in the Hysteretic Comparator Video
  6. Frequency and Voltage Regulation Loops in a Fixed-Frequency Hysteretic Converter Video
  7. Resetting the Capacitor Voltage in a Hysteretic Converter, Constant ON-Time Control Video
  8. Introduction to Boost Converter, RHP Zero in a Boost Converter Video

Week 10

  1. Introduction to Buck-Boost Converter Video
  2. Tri-Mode Buck-Boost Converter (Buck, Buck-Boost and Boost) Video
  3. Boundary Conditions for Mode Transition in a Tri-Mode Buck-Boost Converter Video
  4. Generating Buck and Boost Duty Cycles in a Tri-Mode Buck-Boost Converter Video
  5. Introduction to Switched-Capacitor DC-DC Converters,Switched-Capacitor DC-DC Converter with V_o = 2*V_DD Video
  6. Applications of Switched-Capacitor DC-DC Converters in Open-Loop, Regulating the Output using Feedback Control Video
  7. H-Bridge Switched-Capacitor DC-DC Converter,SC DC-DC converter with Multiple Gain Settings Video
  8. Current Sensing Techniques in DC-DC Converters Video

Week 11

  1. Analog Layout Techniques - Part 1 Video
  2. Analog Layout Techniques - Part 2 Video
  3. Digital Control of DC-DC Converters, ADC Architectures Video
  4. Digital Pulse-Width Modulator Architectures, Adaptive Compensation Video
  5. Limitations of Analog and Digital Controllers, Time-Based Controller for Buck Converter Video
  6. Time-Based Controller for Buck Converter and for LDO, Issues with Time-Based Control Video
  7. Multi-Phase DC-DC Converters Video
  8. Dynamic Voltage and Frequency Scaling, Single Inductor Multiple Output (SIMO) DC-DC Converter Video

Week 12

  1. LCD/AMOLED Display Drivers - Part 1 Video
  2. LCD/AMOLED Display Drivers - Part 2 Video
  3. LCD/AMOLED Display Drivers - Part 3 Video
  4. LED Drivers for Camera Flash Video
  5. Li-Ion Battery and its Charging Phases Video
  6. Battery Charger IC Video

Live Session

  1. Live Session 25-02-2021 Video
  2. Live Session 27-02-2020 Video

Syllabus and materials

At NPTEL, as the course publishes them.

Credits and licence

Institution
IIT Madras
Department
Electrical Engineering
Teacher
Prof. Qadeer Ahmad Khan Prof. Raveesh Magod
Level
Undergraduate
Language
English
Subjects
Engineering
Source
NPTEL
Licence
CC BY-NC-SA, as NPTEL states it. Non-commercial use only. NPTEL's terms
Attribution
NPTEL states: "Distributed under Creative Commons Attribution-ShareAlike / CC BY - NC - SA", beside a BY-NC-SA badge.
Who can watch
NPTEL gives no rating. Invisible Network shows it to Tweens profiles and older, judged from what the source says about it. How courses are placed