8.17: Appendix D

Fluctuations Near Equilibrium · LibreTexts

0%

Contents

    Text

    Size
    100%
    Theme
    Typeface
    Line length
    Spacing

    Read aloud

    How

    Speed: 1×
    Light up
    Highlight

    Symbols: Mulberry Symbols, © 2018–2026 Steve Lee, CC BY-SA 4.0 (licence, the set), the site's own copies.

    From LibreTexts, under CC BY-NC-SA 4.0, as the source states it; its equations are written in TeX, which the PDF shows typeset. This page at LibreTexts.

    8.17: Appendix D

    While the FDT describes fundamental equilibrium fluctuations, experimentalists must distinguish these from non-thermal noise sources that often dominate measurements.

    D.1 Electronic "Hum"

    In the circuits analyzed in Sections 8-10, "hum" refers to periodic interference, typically at 50/60 Hz, arising from AC power line coupling. Unlike the white Johnson noise with two-sided spectral density \(S_{V}(\omega)=2 k_{B} T R\), hum manifests as sharp spectral peaks at the line frequency and its harmonics. While reactive elements like capacitors can filter high-frequency thermal noise, they are often less effective against low-frequency hum, which requires specialized notch filtering or differential signaling to mitigate.

    D.2 Optical Trap "Jitter"

    In optical tweezers, "jitter" refers to the stochastic displacement of a trapped bead.

    • Thermal Jitter: This is the mechanical equivalent of Johnson-Nyquist noise. A laser provides a harmonic potential \(U(x)=\frac{1}{2} k x^{2}\), and the bead undergoes Brownian motion. The displacement spectral density follows a Lorentzian shape:

      \[ S_{x}(\omega)=\frac{2 k_{B} T \gamma}{k^{2}+(\omega \gamma)^{2}} \tag{8.1} \label{8.1} \]

    This is functionally identical to the noise spectrum of the parallel RC circuit (Eq. 12).

    • Technical Jitter: This arises from laser intensity fluctuations or mechanical vibrations. While thermal jitter is a fundamental limit dictated by \(T\), technical jitter is an engineering constraint.

    The distinction is critical: in electronics, we minimize "hum" to reach the thermal floor; in optical traps, we often measure the "jitter" as a probe to extract the local temperature or viscoelastic properties of the medium.


    This page titled 8.17: Appendix D was last modified on Mon, 02 Nov 2026 06:19:47 GMT and is shared under a CC BY-NC-SA 4.0 license and was authored, remixed, and/or curated by Pabitra N. Sen.