31.6: Polarization by Reflection

Physics: A Foundation for Scientists and Engineers · LibreTexts

0%

Contents

    Text

    Size
    100%
    Theme
    Typeface
    Line length
    Spacing

    Read aloud

    How

    Speed: 1×
    Light up
    Highlight

    Symbols: Mulberry Symbols, © 2018–2026 Steve Lee, CC BY-SA 4.0 (licence, the set), the site's own copies.

    From LibreTexts, under CC BY 4.0, as the source states it; its equations are written in TeX, which the PDF shows typeset. This page at LibreTexts.

    31.6: Polarization by Reflection

    Light reflected from a nonmetallic surface, such as water, glass, or a road, is generally partly polarized, and at one particular angle of incidence it is completely polarized. That is why polarized sunglasses can cut glare. To see where the polarization comes from, think about what produces the reflected light. The incoming wave sets the electrons in the surface of the material oscillating along the direction of its electric field, and those oscillating charges radiate the reflected and refracted waves. An oscillating charge radiates most strongly perpendicular to its motion and not at all along the line of its motion.

    Ray diagram of polarization by reflection at Brewster's angle.
    Figure 31.6. Polarization by reflection at Brewster’s angle. The dots represent the electric-field component perpendicular to the page and the double arrows the component in the plane of the page. When the reflected and refracted rays are perpendicular, the in-plane component cannot be reflected, and the reflected light is completely polarized parallel to the surface.
    Figure descriptionA ray diagram at a horizontal interface, with air, index n sub 1, above and water or glass, index n sub 2, below, and a dashed vertical normal. Unpolarized light arrives from the upper left at Brewster's angle theta sub p, drawn with both dots and short double-headed arrows along it to show both polarization components. The reflected ray leaves to the upper right at the same angle and carries only dots, meaning it is polarized perpendicular to the page, parallel to the surface. The refracted ray continues into the lower medium at angle theta sub 2 and carries mostly arrows with a few dots. A small square marks the ninety-degree angle between the reflected and refracted rays.

    Split the incident light’s electric field into two components (Figure 31.6): one perpendicular to the plane of incidence (the plane containing the incident ray and the normal), drawn as dots, and one lying in that plane, drawn as short double-headed arrows. Electrons driven by the perpendicular component oscillate perpendicular to the plane of incidence and can radiate in any direction within it, so that component always reflects. Electrons driven by the in-plane component oscillate perpendicular to the refracted ray. If the reflected ray happens to point along that same direction of oscillation, those electrons cannot radiate into it, and the in-plane component is missing from the reflected light entirely. The reflected light is then completely polarized perpendicular to the plane of incidence.

    This happens when the reflected and refracted rays are perpendicular to each other. The angle of incidence at which it occurs is called the polarizing angle or Brewster’s angle \(\theta_p\). With the reflected ray at \(\theta_p\) from the normal and the refracted ray at \(\theta_2\), the condition that the two rays are perpendicular is \(\theta_p + 90^\circ + \theta_2 = 180^\circ\), or \(\theta_2 = 90^\circ - \theta_p\). Snell’s law then gives

    \[n_1\sin\theta_p = n_2\sin(90^\circ - \theta_p) = n_2\cos\theta_p,\]

    and so

    Key Equation: Brewster’s angle

    \[\tan\theta_p = \frac{n_2}{n_1}. \tag{31.8}\]

    At Brewster’s angle the reflected light is completely polarized, parallel to the surface. The refracted light carries all of the in-plane component and part of the perpendicular one, so it is only partly polarized. At other angles the reflected light is partly polarized, still mostly parallel to the surface.

    Example 31.6: Brewster’s angle for water and glass

    Find Brewster’s angle for light in air reflecting from (a) water (\(n = 1.33\)) and (b) crown glass (\(n = 1.52\)). (c) For water, find the angle of refraction and check that the reflected and refracted rays are perpendicular.

    Solution

    (a) From equation (31.8) with \(n_1 = 1.00\),

    \[\theta_p = \arctan\frac{1.33}{1.00} = \boxed{53.1^\circ}.\]

    (b) For glass, \(\theta_p = \arctan 1.52 = \boxed{56.7^\circ}\).

    (c) Snell’s law gives \(\sin\theta_2 = \sin 53.1^\circ/1.33 = 0.600\), so \(\theta_2 = \boxed{36.9^\circ}\). The reflected ray is at \(53.1^\circ\) from the normal on one side and the refracted ray at \(36.9^\circ\) from it on the other, so the angle between them is \(180^\circ - 53.1^\circ - 36.9^\circ = 90.0^\circ\), as it must be.

    Note: Polarized sunglasses

    Sunlight reflecting off a lake, a wet road, or a car’s hood strikes these horizontal surfaces at fairly large angles of incidence, often near Brewster’s angle, so the glare is strongly polarized horizontally. Polarized sunglasses are simply polarizing filters with their transmission axes vertical. By Malus’s law they block most of the horizontally polarized glare while still passing about half of the unpolarized light from everything else. Photographers use rotatable polarizing filters on their lenses for the same reason, to cut reflections from water and glass or to darken a blue sky, whose scattered light is also partly polarized. You can check whether a pair of sunglasses is polarized by tilting your head while looking at glare: if the glare brightens as you tilt, it is.

    Checkpoint 31.6

    (a) You look at light reflected from a pond through a polarizing filter, and rotate the filter. How can you tell whether the light is reaching you at Brewster’s angle? (b) Should the transmission axis of polarized sunglasses be vertical or horizontal? What would happen to the glare if you wore them sideways?

    Answer

    Answers to Checkpoints

    Checkpoint 31.6. (a) At Brewster’s angle the reflected light is completely polarized, parallel to the water’s surface. Rotating the filter, you would find one orientation at which the reflection vanishes entirely. At other angles of reflection the light is only partly polarized, and the reflection merely dims to a minimum. (b) Vertical. Glare from horizontal surfaces such as water and roads is mostly polarized horizontally, so a vertical transmission axis blocks it. Worn sideways, the glasses’ axis would be horizontal: they would pass the glare while blocking vertically polarized light, making the glare relatively worse.


    This page titled 31.6: Polarization by Reflection was last modified on Thu, 12 Nov 2026 04:26:55 GMT and is shared under a CC BY 4.0 license and was authored, remixed, and/or curated by Michael Ragsdale.