33.4: Interferometry

Physics: A Foundation for Scientists and Engineers · LibreTexts

0%

Contents

    Text

    Size
    100%
    Theme
    Typeface
    Line length
    Spacing

    Read aloud

    How

    Speed: 1×
    Light up
    Highlight

    Symbols: Mulberry Symbols, © 2018–2026 Steve Lee, CC BY-SA 4.0 (licence, the set), the site's own copies.

    From LibreTexts, under CC BY 4.0, as the source states it; its equations are written in TeX, which the PDF shows typeset. This page at LibreTexts.

    33.4: Interferometry
    Michelson interferometer: a beam splitter sending light to two mirrors and recombining it.
    Figure 33.6. The Michelson interferometer. The half-silvered beam splitter \(M\) divides the laser light between a fixed arm (\(d_1\)) and a movable arm (\(d_2\)); each beam reflects back, and the recombined beams interfere at the detector, often as a set of rings. The path difference is \(2d_2 - 2d_1\), so sliding \(M_2\) by \(\Delta d\) changes it by \(2\,\Delta d\).
    Figure descriptionA Michelson interferometer. A laser at the left sends a red beam to the right into a beam splitter, a thin half-silvered glass plate tilted at 45 degrees. Half the light passes straight through along an arm of length d sub 1 to a fixed mirror M sub 1 and reflects back; the other half turns upward along an arm of length d sub 2 to a movable mirror M sub 2 and reflects back. Small arrowheads on each arm show the light going out and coming back. The mirrors are drawn with hatched backs, and a double arrow labeled delta d shows that M sub 2 slides up and down. The two returning beams recombine at the splitter and travel down together to a detector, beside which an inset shows the resulting interference pattern as concentric red and white rings. The path difference is twice d sub 2 minus twice d sub 1.

    Because interference responds to path differences as small as a fraction of a wavelength, it is the basis of the most precise length measurements we can make. The classic instrument is the Michelson interferometer (Figure 33.6). A beam from a single source strikes a half-silvered mirror \(M\) (the beam splitter), which sends half the light down one arm to a fixed mirror \(M_1\) and half down a perpendicular arm to a movable mirror \(M_2\). Both beams reflect back, recombine at \(M\), and travel together to the detector, where they interfere.

    The round trip down each arm doubles its length, so the path difference between the two beams is \(2d_2 - 2d_1\). Now slide the movable mirror by a distance \(\Delta d\). The path in that arm changes by \(2\,\Delta d\), and each time this change adds one more wavelength, the pattern at the detector advances by exactly one fringe: one full cycle from bright to bright. Counting \(N\) fringes as the mirror moves gives

    Key Equation: Michelson interferometer

    \[2\,\Delta d = N\lambda. \tag{33.11}\]

    Because \(N\) is a pure count of fringes (an integer you can tally exactly) and \(\lambda\) is tiny, this turns a delicate length into a precise number. Move the mirror a known distance and you measure \(\lambda\); know \(\lambda\) and you measure the displacement to a fraction of a wavelength. The same principle, scaled to arms four kilometers long and mirrors hung as pendulums, is how the LIGO observatories detected gravitational waves: a passing ripple in spacetime stretched one arm relative to the other by less than the width of a proton, and the fringe count registered it.

    Example 33.6: Counting fringes

    In a Michelson interferometer using \(632.8\,\mathrm{nm}\) laser light, the movable mirror is advanced slowly and \(500\) bright fringes pass the detector. How far did the mirror move?

    Solution

    From equation (33.11) with \(N = 500\),

    \[\Delta d = \frac{N\lambda}{2} = \frac{500\,(632.8\times10^{-9}\,\mathrm{m})}{2} = \boxed{1.58\times10^{-4}\,\mathrm{m} = 0.158\,\mathrm{mm}}.\]

    A sixth of a millimeter, measured by counting: no ruler involved. This is why interferometers are used to calibrate length standards.

    Checkpoint 33.3

    A Michelson interferometer uses light of wavelength \(500\,\mathrm{nm}\). (a) One mirror is moved \(0.25\,\mathrm{\mu m}\). How many bright fringes pass the center of the field? (b) Why does equation (33.11) contain \(2\Delta d\) rather than \(\Delta d\)?

    Answer

    Answers to Checkpoints

    Checkpoint 33.3. (a) \(N = 2\Delta d/\lambda = 2(0.25\,\mathrm{\mu m})/(0.500\,\mathrm{\mu m}) = 1\): exactly one fringe. (b) The light travels to the moving mirror and back, so moving the mirror by \(\Delta d\) lengthens that arm’s round trip by \(2\Delta d\). A new bright fringe appears each time the round-trip path changes by one wavelength, that is, each time the mirror moves half a wavelength.


    This page titled 33.4: Interferometry was last modified on Thu, 12 Nov 2026 04:27:08 GMT and is shared under a CC BY 4.0 license and was authored, remixed, and/or curated by Michael Ragsdale.