29.6: Standing Waves and Resonance

Physics: A Foundation for Scientists and Engineers · LibreTexts

0%

Contents

    Text

    Size
    100%
    Theme
    Typeface
    Line length
    Spacing

    Read aloud

    How

    Speed: 1×
    Light up
    Highlight

    Symbols: Mulberry Symbols, © 2018–2026 Steve Lee, CC BY-SA 4.0 (licence, the set), the site's own copies.

    From LibreTexts, under CC BY 4.0, as the source states it; its equations are written in TeX, which the PDF shows typeset. This page at LibreTexts.

    29.6: Standing Waves and Resonance

    We are finally ready to return to the guitar string. The key new ingredient is reflection: when a wave reaches the end of a string it bounces back. At a fixed end (the string tied down) the reflected wave is inverted; at a free end it is not. On a guitar string, pinned at both ends, a wave you launch reflects back and forth, and the original and reflected waves (identical but traveling in opposite directions) superpose.

    Add a wave moving in \(+x\) to an identical wave moving in \(-x\):

    \[y = A\sin(kx - \omega t) + A\sin(kx + \omega t) = 2A\sin(kx)\cos(\omega t),\]

    again by the sum-to-product identity. The result is a standing wave:

    Key Equation: Standing wave

    \[y(x,t) = \big[\,2A\sin(kx)\,\big]\cos(\omega t). \tag{29.11}\]

    This is not a traveling wave at all. Every point oscillates in time as \(\cos(\omega t)\), but its amplitude, \(2A\sin(kx)\), depends only on position. Some points never move: where \(\sin(kx) = 0\), the amplitude is permanently zero. These are the nodes, located at

    \[kx = n\pi \;\Longrightarrow\; x = \frac{n\lambda}{2}, \qquad n = 0, 1, 2, \dots\]

    Halfway between them, where \(\sin(kx) = \pm 1\), the amplitude reaches its maximum \(2A\). These are the antinodes, at \(x = \lambda/4, 3\lambda/4, 5\lambda/4, \dots\). Nodes and antinodes alternate, each separated from the next of its kind by half a wavelength. Figure 29.3 shows three such patterns on a string tied at both ends, each at several instants during half a cycle. Which patterns a given string can hold, and at what frequencies, is the subject of the discussion of harmonics below.

    Three standing-wave patterns on a string tied to walls at both ends, stacked one above another.
    Figure 29.3. Three standing waves on a string tied at both ends, each drawn at five instants during half a cycle. The nodes (dots) never move; the antinodes, halfway between neighboring nodes, swing with the full amplitude \(2A\). From top to bottom the string holds one, two, and three antinodes; in every case neighboring nodes are \(\lambda/2\) apart. Every point between two neighboring nodes moves up and down together, and the next segment moves opposite to it. Nothing travels along the string.
    Figure descriptionThree standing-wave patterns on a string tied to walls at both ends, stacked one above another. Each pattern is drawn at five instants during half a cycle: a thick blue curve at its largest displacement, a dashed blue curve at about seventy percent of that, a dashed gray straight line where the string is momentarily flat, and the matching lighter and thick curves inverted. Black dots mark the nodes, where all five curves cross and the string never moves. Top, n equals 1: one antinode in the middle, with nodes only at the two ends. A labeled arrow points down to the antinode and another points up to the node at the left end. Middle, n equals 2: two antinodes and one node in the middle. Arrows point to the first antinode and to the middle node. Bottom, n equals 3: three antinodes and two interior nodes. Arrows point to the first antinode and to the first interior node. On the bottom pattern, a red arrow from the axis up to the thick curve at the last antinode is labeled 2 A, and a bracket below the axis between the second interior node and the right end is labeled lambda over 2.
    Example 29.4: Nodes and antinodes of a standing wave

    Two waves traveling in opposite directions on a string are \(y_1 = (4.0)\sin(3.0x - 2.0t)\) and \(y_2 = (4.0)\sin(3.0x + 2.0t)\), with \(x\) and \(y\) in centimeters and \(t\) in seconds.

    1. Find the amplitude of the simple harmonic motion of the element at \(x = 2.3\,\mathrm{cm}\).
    2. Find the positions of the nodes and antinodes, taking one end of the string at \(x = 0\).
    Solution

    The two waves superpose into the standing wave \(y = [2A\sin(kx)]\cos(\omega t)\) with \(A = 4.0\,\mathrm{cm}\), \(k = 3.0\,\mathrm{rad/cm}\), and \(\omega = 2.0\,\mathrm{rad/s}\).

    (a) The amplitude at a point is \(|2A\sin(kx)|\). At \(x = 2.3\,\mathrm{cm}\),

    \[2A\sin(kx) = 2(4.0)\sin\big[(3.0)(2.3)\big] = (8.0)\sin(6.9\ \text{rad}) \approx (8.0)(0.578) = \boxed{4.6\,\mathrm{cm}}.\]

    (b) Nodes occur where \(\sin(kx) = 0\), i.e. \(kx = n\pi\):

    \[x = \frac{n\pi}{3.0} = 0,\ 1.05,\ 2.09,\ 3.14,\ \dots\ \text{cm}.\]

    Antinodes occur where \(\sin(kx) = \pm1\), i.e. \(kx = (n + \tfrac12)\pi\):

    \[x = \frac{(n+\tfrac12)\pi}{3.0} = 0.52,\ 1.57,\ 2.62,\ \dots\ \text{cm},\]

    each antinode sitting exactly halfway between two nodes, as expected.

    Harmonics and resonance

    A string fixed at both ends cannot vibrate at just any frequency. Both ends must be nodes, so a standing wave fits only if a whole number of half-wavelengths spans the length \(L\): \(L = n(\lambda/2)\), giving \(\lambda_n = 2L/n\) (Figure 29.4a). Combined with \(f = v/\lambda\), this picks out a discrete ladder of allowed frequencies, the harmonics or resonant frequencies:

    Key Equation: Harmonics of a string fixed at both ends

    \[f_n = n\,\frac{v}{2L}, \qquad n = 1, 2, 3, \dots \tag{29.12}\]

    The lowest, \(f_1 = v/2L\), is the fundamental (the note you hear when you pluck the string) and the rest are its integer multiples. Driving the string at one of these frequencies produces a large-amplitude standing wave: this is resonance, the same phenomenon that brought down mid-rise buildings in the Mexico City earthquake of Chapter 28, here put to musical use. Now we can read off the guitarist’s three controls: a shorter string (smaller \(L\), from fretting), a tighter string (larger \(v\), from tuning), or a lighter string (larger \(v\), from a thinner gauge) all raise the pitch, exactly through equation (29.12) with \(v = \sqrt{F_T/\mu}\).

    A system that is not symmetric, such as a string or air column fixed at one end and free at the other, has a node at the fixed end and an antinode at the free end. It therefore fits only an odd number of quarter-wavelengths, \(L = n(\lambda/4)\) with \(n\) odd, so \(\lambda_n = 4L/n\) (Figure 29.4b), and its harmonics are

    \[f_n = n\,\frac{v}{4L}, \qquad n = 1, 3, 5, \dots, \tag{29.13}\]

    containing only the odd multiples of the fundamental. Its fundamental, \(v/4L\), is half that of a symmetric system of the same length, because only a quarter of a wavelength fits instead of a half. We will use this form for pipes in Chapter 30.

    Two panels of the three lowest standing-wave modes on a string.
    Figure 29.4. The lowest three allowed standing waves, drawn as the envelope of the string’s motion (solid and dashed). (a) With both ends fixed, both ends are nodes and a whole number of half-wavelengths fits in \(L\), so every integer multiple of \(f_1 = v/2L\) is allowed. (b) With one end fixed and the other free (here a ring that slides on a frictionless rod), the fixed end is a node and the free end is an antinode, so an odd number of quarter-wavelengths fits in \(L\). Only the odd multiples of \(f_1 = v/4L\) are allowed.
    Figure descriptionTwo panels of standing-wave patterns, each showing the lowest three allowed modes stacked vertically, drawn as the envelope of the string's motion: a solid blue curve and its dashed mirror image. Panel a, fixed at both ends: both ends are tied to walls and are nodes. The first mode is one loop, with lambda sub 1 equal to 2 L and f sub 1 equal to v over 2 L. The second mode is two loops, with lambda sub 2 equal to L and f sub 2 equal to 2 f sub 1. The third mode is three loops, with lambda sub 3 equal to 2 L over 3 and f sub 3 equal to 3 f sub 1. A bracket under the bottom string is labeled L. Panel b, fixed at one end and free at the other: the left end is tied to a wall and is a node; the right end is a ring free to slide up and down a vertical rod and is an antinode. The first mode is a quarter wavelength, half a loop, with lambda sub 1 equal to 4 L and f sub 1 equal to v over 4 L. The next allowed mode is one and a half loops, with lambda sub 3 equal to 4 L over 3 and f sub 3 equal to 3 f sub 1. The next is two and a half loops, with lambda sub 5 equal to 4 L over 5 and f sub 5 equal to 5 f sub 1. Even multiples are missing.
    Example 29.5: Tuning a driven string

    A string is tied to a sinusoidal oscillator at one end and runs over a support at the other, a distance \(L = 1.20\,\mathrm{m}\) away, where it is stretched by a hanging block of mass \(m\). The string’s linear density is \(\mu = 1.6\,\mathrm{g/m}\) and the oscillator’s frequency is fixed at \(120\,\mathrm{Hz}\). Both ends are nodes.

    1. What hanging mass \(m\) allows the oscillator to set up the fourth harmonic?
    2. What standing-wave mode, if any, is set up if \(m = 1.00\,\mathrm{kg}\)?
    Solution

    The block’s weight is the tension, \(F_T = mg\), so the wave speed is \(v = \sqrt{mg/\mu}\), and the harmonic condition (29.12) reads

    \[f_n = \frac{n}{2L}\sqrt{\frac{mg}{\mu}}.\]

    (a) Setting \(n = 4\), \(f_4 = 120\,\mathrm{Hz}\), and \(\mu = 1.6\times 10^{-3}\,\mathrm{kg/m}\), solve for \(m\):

    \[\sqrt{\frac{mg}{\mu}} = \frac{2Lf_4}{n} = \frac{2(1.20)(120)}{4} = 72.0\,\mathrm{m/s},\]

    so \(mg/\mu = (72.0)^2 = 5184\), giving \(F_T = mg = (5184)(1.6\times10^{-3}) = 8.29\,\mathrm{N}\) and

    \[m = \frac{F_T}{g} = \frac{8.29\,\mathrm{N}}{9.8\,\mathrm{m/s^2}} \approx \boxed{0.85\,\mathrm{kg}}.\]

    (b) With \(m = 1.00\,\mathrm{kg}\), the tension is \(F_T = 9.8\,\mathrm{N}\) and \(v = \sqrt{F_T/\mu} = \sqrt{9.8/1.6\times10^{-3}} = 78.3\,\mathrm{m/s}\). The mode number that the fixed \(120\,\mathrm{Hz}\) drive would require is

    \[n = \frac{2Lf}{v} = \frac{2(1.20)(120)}{78.3} = 3.68,\]

    which is not an integer. \(\boxed{\text{No standing wave can form}}\) at this tension; only the discrete masses that make \(n\) a whole number produce resonance.

    Checkpoint 29.4

    A guitar string, fixed at both ends, has a fundamental frequency of \(110\,\mathrm{Hz}\). (a) What are the frequencies of the next two harmonics? (b) Where along the string are the nodes of the third harmonic? (c) A finger pressed lightly at the exact midpoint suppresses every mode that does not have a node there. Which frequency now sounds lowest?

    Answer

    Answers to Checkpoints

    Checkpoint 29.4. (a) For a string fixed at both ends the harmonics are whole-number multiples of the fundamental, \(f_n = nf_1\): the next two are \(220\,\mathrm{Hz}\) and \(330\,\mathrm{Hz}\). (b) The third harmonic has three half-wavelengths along the string, so besides the two fixed ends it has nodes one-third and two-thirds of the way along. (c) Only modes with a node at the midpoint survive: the even harmonics, \(n = 2, 4, 6, \ldots\). The lowest is the second harmonic, \(220\,\mathrm{Hz}\), an octave above the open string. This is how guitarists play “harmonics.”


    This page titled 29.6: Standing Waves and Resonance was last modified on Thu, 12 Nov 2026 04:27:05 GMT and is shared under a CC BY 4.0 license and was authored, remixed, and/or curated by Michael Ragsdale.