34.1: Single-Slit Diffraction

Physics: A Foundation for Scientists and Engineers · LibreTexts

0%

Contents

    Text

    Size
    100%
    Theme
    Typeface
    Line length
    Spacing

    Read aloud

    How

    Speed: 1×
    Light up
    Highlight

    Symbols: Mulberry Symbols, © 2018–2026 Steve Lee, CC BY-SA 4.0 (licence, the set), the site's own copies.

    From LibreTexts, under CC BY 4.0, as the source states it; its equations are written in TeX, which the PDF shows typeset. This page at LibreTexts.

    34.1: Single-Slit Diffraction

    Recall Huygens’ principle from Chapter 31: every point on a wavefront is itself a source of spherical wavelets. A slit is not infinitely narrow; it has a width \(a\), and every point across that width radiates. The light reaching a point on a distant screen is the sum of all these wavelets, and because they set out from different parts of the slit they arrive having traveled slightly different distances. Their interference (now among a continuum of sources rather than just two) produces the single-slit pattern.

    Single-slit diffraction by the pairing argument, in two panels.
    Figure 34.1. Single-slit diffraction by the pairing argument. (a) Rays from the top edge \(A\) and the center \(B\) of the slit travel to the same point \(P\) on a distant screen. (b) Close-up of the slit. Because \(L \gg a\), the two rays are nearly parallel, and the perpendicular \(AQ\) marks where they are in step, so the lower ray travels an extra distance \(BQ\). In the right triangle \(ABQ\) the hypotenuse is \(a/2\) and the angle at \(A\) equals \(\theta\), so \(BQ = (a/2)\sin\theta\). When this is \(\lambda/2\), every such pair cancels and \(P\) is dark: the first minimum, \(a\sin\theta = \lambda\).
    Figure descriptionSingle-slit diffraction by the pairing argument, in two panels. Panel a shows the whole set-up: plane waves arrive from the left at a slit of width a, and a screen stands a distance L to the right, with L much larger than a. A dashed axis runs from the center of the slit to the central bright fringe on the screen. Two red rays, one from the top edge of the slit and one from its center, run up to the same point P on the screen, at angle theta above the axis; P is labeled dark if a over 2 times sine theta equals lambda over 2. Panel b is the close-up. Point A is the top edge of the slit and point B is the center, a distance a over 2 below it. The two rays toward P leave A and B parallel, at angle theta above the horizontal. A line from A meets the lower ray at a right angle at point Q. This makes a right triangle A B Q with hypotenuse A B equal to a over 2 and angle theta at A, so the short side B Q, highlighted in green as the extra path of the lower ray, equals a over 2 times sine theta.

    The dark fringes are the easy part, and a clever pairing argument finds them exactly. Imagine dividing the slit into an upper half and a lower half (Figure 34.1). Pair the ray from the top edge of the slit (point \(A\)) with the ray from the top of the lower half (point \(B\), the center of the slit): two rays that start \(a/2\) apart and head for the same point \(P\) on the screen. Because the screen is far away, the two rays are very nearly parallel. The close-up in Figure 34.1(b) shows the geometry. Drop a perpendicular from \(A\) to the lower ray, meeting it at \(Q\); from the line \(AQ\) onward the two rays travel equal distances to \(P\), so the only difference is the short stretch \(BQ\) that the lower ray covers first. That stretch is a side of the right triangle \(ABQ\), whose hypotenuse is \(AB = a/2\) and whose angle at \(A\) equals \(\theta\) (the same angle the rays make with the horizontal), so the path difference is

    \[BQ = \frac{a}{2}\sin\theta .\]

    If this equals exactly half a wavelength, the two wavelets arrive crest to trough and cancel. The same is true for every other pair spaced \(a/2\) apart: a point just below \(A\) with the point just below \(B\), and so on down the slit, until every point of the upper half has a partner in the lower half. Every wavelet from the slit is canceled by its partner, so no light at all arrives at \(P\): the screen is dark there. Setting \((a/2)\sin\theta = \lambda/2\) gives the first minimum at \(a\sin\theta = \lambda\).

    The other dark fringes come from the same trick with smaller pieces. Divide the slit into four equal strips, each \(a/4\) wide. Pair each point of strip 1 with the point \(a/4\) below it in strip 2, and do the same for strips 3 and 4. These pairs cancel when \((a/4)\sin\theta = \lambda/2\), that is, when \(a\sin\theta = 2\lambda\): the second dark fringe. Six strips of width \(a/6\) cancel in pairs when \((a/6)\sin\theta = \lambda/2\), giving \(a\sin\theta = 3\lambda\), and so on. Splitting the slit into \(2m\) strips gives the \(m\)th dark fringe:

    Key Equation: Single-slit minima

    \[a\sin\theta = m\lambda, \qquad m = 1, 2, 3, \dots \tag{34.1}\]

    Two features deserve emphasis. First, equation (34.1) looks like the double-slit bright-fringe condition from Chapter 33, but here it gives the dark fringes, and there is no \(m=0\); the center is the brightest point, not a minimum. Second, the central maximum is twice as wide as the others: it stretches from the \(m=-1\) minimum to the \(m=+1\) minimum. On a screen a distance \(L\) away, with small angles (\(\sin\theta \approx y/L\)), the first minimum sits at \(y_1 = \lambda L/a\), so the central bright band has full width

    \[w = 2y_1 = \frac{2\lambda L}{a}. \tag{34.2}\]

    The dark fringes are the landmarks of the whole pattern (Figure 34.2). For small angles they fall at evenly spaced positions \(y_m = m\lambda L/a\), and each bright fringe simply fills the gap between two neighboring dark fringes. The central maximum spans the gap from \(-y_1\) to \(+y_1\), a width of \(2\lambda L/a\); every side maximum spans a single gap, from \(y_m\) to \(y_{m+1}\), a width of only \(\lambda L/a\), with its peak near the middle of the gap. So finding the dark fringes is all it takes to locate the bright ones and measure their widths.

    Single-slit intensity graph against screen position, with the fringe pattern shown above it.
    Figure 34.2. Reading the bright fringes from the dark ones. For small angles the dark fringes fall at evenly spaced positions \(y_m = m\lambda L/a\) on the screen. Each bright fringe fills the gap between two neighboring dark fringes: the central maximum spans \(-y_1\) to \(+y_1\) (width \(2\lambda L/a\)), and each side maximum spans one gap (width \(\lambda L/a\)), with its peak near the middle. The shading of the strip is exaggerated so that the faint side fringes show.
    Figure descriptionA graph of single-slit intensity I against position y on the screen, with a strip above it showing the pattern as it looks on the screen: a wide bright red band in the middle and faint narrower bands on each side, the shading exaggerated so the faint bands show. Dashed vertical lines mark the dark fringes at y sub 1, y sub 2 and y sub 3 on each side of center, evenly spaced, and run up through the strip so each dark line on the graph lines up with a dark gap in the strip. The intensity curve is a tall peak centerd at zero that falls to zero at minus y sub 1 and plus y sub 1, followed by small humps between successive dark fringes. A blue double arrow spans the central maximum from minus y sub 1 to plus y sub 1, labeled central maximum, w equals 2 lambda L over a. Green double arrows span the gaps from y sub 1 to y sub 2 and from minus y sub 2 to minus y sub 1, each labeled lambda L over a. A note below reads: dark fringes at y sub m equals m lambda L over a, where a sine theta equals m lambda, m equals 1, 2, 3 and so on.

    Notice the slit width \(a\) is in the denominator: the narrower the slit, the wider the pattern spreads. Squeezing a wave makes it fan out: the hallmark of diffraction.

    The same factor explains why diffraction escapes notice in everyday life. Light passing through a doorway \(1\,\mathrm{m}\) wide has \(a/\lambda \approx 2\times10^{6}\), so its first minimum lies only \(\theta \approx \lambda/a \approx 5\times10^{-7}\,\mathrm{rad}\) from the straight-ahead direction. Across a \(5\,\mathrm{m}\) room that is a few micrometers: far too small to see, so the doorway seems to cast a perfectly sharp shadow. Sound is another story. A \(340\,\mathrm{Hz}\) note has a wavelength of about \(1\,\mathrm{m}\), comparable to the doorway, so sound spreads widely as it passes through. That is why you can hear someone around a corner but cannot see them.

    Example 34.1: Width of the central maximum

    Light of wavelength \(580\,\mathrm{nm}\) falls on a slit \(0.300\,\mathrm{mm}\) wide; the screen is \(2.00\,\mathrm{m}\) away. (a) Find the width of the central bright fringe. (b) What happens if the slit is widened tenfold, to \(3.00\,\mathrm{mm}\)?

    Solution

    (a) The first minimum is at \(y_1 = \lambda L/a\), and the central maximum spans from \(-y_1\) to \(+y_1\):

    \[w = \frac{2\lambda L}{a} = \frac{2(580\times10^{-9}\,\mathrm{m})(2.00\,\mathrm{m})}{3.00\times10^{-4}\,\mathrm{m}} = \boxed{7.73\times10^{-3}\,\mathrm{m} = 7.73\,\mathrm{mm}}.\]

    (b) Since \(w \propto 1/a\), widening the slit by a factor of ten narrows the central band by a factor of ten, to \(0.773\,\mathrm{mm}\). As the slit grows large compared with the wavelength, the pattern collapses toward the sharp bright rectangle of geometric optics: diffraction becomes negligible, which is why we rarely notice it for everyday openings.

    Intensity in Single-Slit Diffraction

    To find not just where the dark fringes are but how the brightness varies everywhere, we again add the wavelets as phasors, but now there is a continuous fan of them, one from each point across the slit, each a hair more retarded in phase than the last. Adding a continuum of equal phasors that turn through a steadily increasing angle traces an arc of a circle; the resultant is the chord across that arc. Carrying out the sum gives the intensity as a function of angle:

    Key Equation: Single-slit intensity

    \[I(\theta) = I_{\max}\left(\frac{\sin\alpha}{\alpha}\right)^{2}, \qquad \alpha = \frac{\pi a}{\lambda}\sin\theta. \tag{34.3}\]

    A graph of single-slit intensity against alpha, which equals pi a over lambda times sine theta.
    Figure 34.3. Single-slit intensity \((\sin\alpha/\alpha)^2\). The broad central maximum carries almost all the light; minima fall at \(\alpha = m\pi\), i.e. \(a\sin\theta = m\lambda\). Secondary maxima are faint.
    Figure descriptionA graph of single-slit intensity against alpha, which equals pi a over lambda times sine theta. The curve is the function sine alpha over alpha, squared. It has one tall broad central peak of height I max at alpha equals zero, dropping to exactly zero at alpha equals plus and minus pi, 2 pi and 3 pi. Between those zeros are secondary maxima that are very much smaller -- the first is under five per cent of the central height -- and they shrink further outward. Almost all the light sits in the central peak.

    Here \(I_{\max}\) is the intensity at the center, and \(\alpha\) is half the phase difference between the wavelets from the two edges of the slit. The function \((\sin\alpha/\alpha)^2\) is worth reading closely (Figure 34.3). At the center \(\theta = 0\), \(\alpha \to 0\), and \(\sin\alpha/\alpha \to 1\): full brightness. The intensity falls to zero whenever \(\sin\alpha = 0\) with \(\alpha \neq 0\), that is, \(\alpha = m\pi\), which is precisely \(a\sin\theta = m\lambda\), recovering the minima of equation (34.1). Between the zeros sit weak secondary maxima, the first of which carries less than \(5\%\) of the central intensity. Almost all the light is in the central peak.

    Checkpoint 34.1

    (a) A single slit is narrowed to half its original width. What happens to the angular width of the central bright fringe? (b) What happens if the slit is made narrower than the wavelength of the light? (Hint: look at the condition for the first minimum, \(a\sin\theta = \lambda\).)

    Answer

    Answers to Checkpoints

    Checkpoint 34.1. (a) The first minimum is at \(\sin\theta = \lambda/a\), so halving \(a\) doubles \(\sin\theta\) (and, for small angles, doubles the angle): the central fringe becomes about twice as wide. A narrower slit spreads the light more: the opposite of what ray optics would suggest. (b) If \(a < \lambda\), the condition \(\sin\theta = \lambda/a\) would require \(\sin\theta > 1\), which is impossible. There are no minima at all: the central maximum fills the entire half-space beyond the slit, and the slit acts like a point source.


    This page titled 34.1: Single-Slit Diffraction was last modified on Thu, 12 Nov 2026 04:27:09 GMT and is shared under a CC BY 4.0 license and was authored, remixed, and/or curated by Michael Ragsdale.