Opening the book…
Friction between solid surfaces is, in our model, independent of speed. A fluid (air or water) resists motion very differently: the faster an object moves through it, the harder the fluid pushes back. This speed-dependent force is the drag force (or resistive force) \(\vec{F}_D\), and it always points opposite to the velocity.
At low speeds, or for very small objects, the drag is roughly proportional to speed, \(F_D \propto v\). At the everyday speeds of cars, balls, and falling people, drag through air is better described as proportional to the square of the speed:
Key Equation: Drag force (high-speed form)
\[F_D = \tfrac{1}{2}\, C \rho A\, v^2, \tag{6.4}\]
where \(\rho\) is the fluid density, \(A\) is the object’s cross-sectional area, and \(C\) is a dimensionless drag coefficient (around \(0.5\)–\(1\) for ordinary shapes) that captures how streamlined the object is.
The quadratic growth of drag has a famous consequence. Drop an object and it speeds up under gravity; but as \(v\) rises, so does the drag, until drag exactly balances weight. From that moment the net force is zero and the object falls at a constant terminal speed \(v_t\). Setting \(F_D = mg\) in equation (6.4),
\[\tfrac{1}{2}\, C\rho A\, v_t^2 = mg \;\Longrightarrow\; v_t = \sqrt{\frac{2mg}{C\rho A}}. \tag{6.5}\]
Heavier or more compact objects (large \(m\), small \(A\)) have higher terminal speeds; this is why a skydiver in a tucked dive falls faster than the same diver spread flat, and why a feather drifts while a pebble plummets. Figure 6.2 shows how the speed of a falling object rises and levels off at \(v_t\).
Notice that equation (6.5) tells us the final speed without our ever having to solve for the motion in between. Getting the whole history \(v(t)\) takes a little more work, because the acceleration now depends on the speed: \(m\,dv/dt = mg - \tfrac12 C\rho A v^2\). Separating variables and integrating gives
\[v(t) = v_t \tanh\!\left(\frac{g t}{v_t}\right), \tag{6.6}\]
which starts out as \(v \approx gt\) (free fall, before drag matters) and flattens toward \(v_t\). A useful rule of thumb follows: the object is within a few percent of terminal speed after a time of roughly \(2v_t/g\), about \(9\,\mathrm{s}\), and some \(250\,\mathrm{m}\) of fall, for a skydiver. If instead the drag is linear in speed, \(F_D = bv\), the same procedure gives the exponential approach \(v(t) = v_t\left(1 - e^{-bt/m}\right)\) with \(v_t = mg/b\).
Example 6.5: Terminal speed of a skydiver
A \(75\,\mathrm{kg}\) skydiver falls spread-eagle, presenting a cross-sectional area of about \(0.70\,\mathrm{m^2}\) with a drag coefficient \(C \approx 1.0\). Taking the density of air as \(\rho = 1.2\,\mathrm{kg/m^3}\), estimate the terminal speed.
Solution
Equation (6.5) applies directly. Work out the numerator and denominator under the square root separately before dividing:
\[\begin{aligned}2mg &= 2(75\,\mathrm{kg})(9.8\,\mathrm{m/s^2}) = 1470\,\mathrm{N}, \\ C\rho A &= (1.0)(1.2\,\mathrm{kg/m^3})(0.70\,\mathrm{m^2}) = 0.84\,\mathrm{kg/m}.\end{aligned}\]
Then
\[v_t = \sqrt{\frac{2mg}{C\rho A}} = \sqrt{\frac{1470\,\mathrm{N}}{0.84\,\mathrm{kg/m}}} = \sqrt{1750\,\mathrm{m^2/s^2}} \approx \boxed{42\,\mathrm{m/s}}.\]
The units under the root are \(\,\mathrm{N}/(\,\mathrm{kg/m}) = (\,\mathrm{kg\cdot m/s^2})(\,\mathrm{m/kg}) = \,\mathrm{m^2/s^2}\), and the square root of that is \(\,\mathrm{m/s}\): a speed, as it must be. To convert to km/h, multiply by \(3.6\): \((42)(3.6) \approx 150\,\mathrm{km/h}\), in the right range for a belly-down skydiver (measured speeds are closer to \(190\,\mathrm{km/h}\), so the rough values of \(C\) and \(A\) overestimate the drag somewhat).
Because \(A\) sits in the denominator under a square root, \(v_t \propto 1/\sqrt{A}\): cutting the area to a quarter doubles the terminal speed. Pulling into a head-down dive cuts \(A\) roughly that much and can roughly double this speed.
Checkpoint 6.3
Two balls of the same size and shape are dropped from a great height. One has twice the mass of the other. Which reaches the higher terminal speed, and by what factor? (Assume quadratic drag.)
Answers to Checkpoints
Checkpoint 6.3. The heavier ball. From equation (6.5), \(v_t = \sqrt{2mg/(C\rho A)}\); with \(C\), \(\rho\), and \(A\) the same for both, \(v_t \propto \sqrt{m}\). Doubling the mass raises the terminal speed by a factor of \(\sqrt{2} \approx 1.4\). The heavier ball must fall faster before drag grows large enough to balance its larger weight.
This page titled 6.2: Resistive Forces was last modified on Thu, 12 Nov 2026 04:26:49 GMT and is shared under a CC BY 4.0 license and was authored, remixed, and/or curated by Michael Ragsdale.
The book could not be loaded just now.