11.1: Rotational Kinetic Energy

Physics: A Foundation for Scientists and Engineers · LibreTexts

0%

Contents

    Text

    Size
    100%
    Theme
    Typeface
    Line length
    Spacing

    Read aloud

    How

    Speed: 1×
    Light up
    Highlight

    Symbols: Mulberry Symbols, © 2018–2026 Steve Lee, CC BY-SA 4.0 (licence, the set), the site's own copies.

    From LibreTexts, under CC BY 4.0, as the source states it; its equations are written in TeX, which the PDF shows typeset. This page at LibreTexts.

    11.1: Rotational Kinetic Energy

    A spinning body has kinetic energy even if it is going nowhere, because all of its particles are moving. Each particle has its own speed \(v_i\), but all of them are built from the single \(\omega\) that the whole body shares, through \(v_i = r_i\omega\). Adding up \(\tfrac{1}{2}m_i v_i^2\) over every particle and substituting,

    \[K = \sum_i \tfrac{1}{2}m_i v_i^{2} = \sum_i \tfrac{1}{2}m_i (r_i\omega)^{2} = \tfrac{1}{2}\Big(\sum_i m_i r_i^{2}\Big)\omega^{2}.\]

    The sum in parentheses is just the moment of inertia, so the rotational kinetic energy is

    Key Equation: Rotational kinetic energy

    \[K_{\rm rot} = \tfrac{1}{2}I\omega^2. \tag{11.1}\]

    This is the perfect analog of \(K = \tfrac{1}{2}mv^2\), with \(I\) in place of \(m\) and \(\omega\) in place of \(v\). It is measured in joules and counts as part of a system’s mechanical energy, so conservation of energy (Chapter 8) applies to rotating bodies too.

    Checkpoint 11.1

    A thin hoop and a solid disk have the same mass and the same radius, and at this moment they carry the same rotational kinetic energy. Which one is turning faster, and by what factor? (Their moments of inertia are \(MR^2\) and \(\tfrac{1}{2}MR^2\).)

    Answer

    Example 11.1: A falling rod

    A uniform rod of length \(L\) and mass \(M\) pivots without friction about one end. It is released from rest in the horizontal position. (a) Find its angular speed when it reaches the vertical (lowest) position. (b) Find the tangential speed of the center of mass and of the lowest tip at that moment.

    Rod pivoted at one end, released from horizontal and swinging down to vertical.Figure descriptionA rod pivoted at one end, shown released from a horizontal starting position and swinging down to its lowest vertical position, with a dashed arc showing the path of its free end. The center of mass, at the middle of the rod, falls a height h equal to half the rod's length.
    Solution

    (a) Use energy conservation; the frictionless pivot does no work. As the rod swings down, its center of mass (at the middle) drops a height \(h = L/2\), so the potential energy lost is \(Mg(L/2)\). (Even though different parts of the rod drop different amounts, the potential energy of the whole rod is \(Mg\) times the height of its center of mass.) This becomes rotational kinetic energy, with the rod pivoting about its end, \(I = \tfrac{1}{3}ML^2\):

    \[Mg\frac{L}{2} = \tfrac{1}{2}I\omega^2 = \tfrac{1}{2}\!\left(\tfrac{1}{3}ML^2\right)\omega^2 = \tfrac{1}{6}ML^2\omega^2.\]

    To isolate \(\omega^2\), multiply both sides by \(6\) and divide both sides by \(ML^2\). The mass cancels, and one power of \(L\) cancels:

    \[\omega^2 = \frac{6\,Mg\,(L/2)}{ML^2} = \frac{3MgL}{ML^2} = \frac{3g}{L} \;\Longrightarrow\; \omega = \boxed{\sqrt{\frac{3g}{L}}}.\]

    The units check: \((\,\mathrm{m/s^2})/\,\mathrm{m} = \,\mathrm{s^{-2}}\), whose square root is \(\,\mathrm{s^{-1}}\), the unit of angular speed.

    (b) The tangential speed is \(v = r\omega\). The center of mass is at \(r = L/2\) and the tip at \(r = L\). To combine a factor outside the root with the root, bring it inside as its square, \(L = \sqrt{L^2}\):

    \[v_{\rm cm} = \frac{L}{2}\sqrt{\frac{3g}{L}} = \frac{1}{2}\sqrt{\frac{3gL^2}{L}} = \boxed{\tfrac{1}{2}\sqrt{3gL}}, \qquad v_{\rm tip} = L\sqrt{\frac{3g}{L}} = \boxed{\sqrt{3gL}}.\]

    The tip moves exactly twice as fast as the center of mass, since it is twice as far from the axis.

    Check. A ball dropped from rest through the tip’s fall of \(L\) would reach \(\sqrt{2gL}\). The tip of the rod goes faster, \(\sqrt{3gL}\), because the rest of the rod, falling less far, pushes it along. Surprising, but a well-known result: a falling chimney or a toppling meter stick outruns free fall at its far end.

    Kinetic energy of a rolling body

    A body rolling without slipping (Section 10.2) both translates and rotates, so it carries both kinds of kinetic energy. Its total is the sum,

    Key Equation: Kinetic energy of a rolling body

    \[K = \tfrac{1}{2}mv_{\rm cm}^2 + \tfrac{1}{2}I_{\rm cm}\omega^2, \tag{11.2}\]

    with the two terms linked by equation (10.9). This is why a ball rolling down a ramp arrives with a smaller center-of-mass speed than one that slides down a frictionless ramp: some of the released potential energy must go into spin.

    For a body rolling down a ramp, energy conservation gives the speed at the bottom in one line. Write the moment of inertia as \(I_{\rm cm} = \beta mR^2\), as in Section 10.4. Falling a height \(h\) releases \(mgh\), and by equations (10.9) and (11.2),

    \[mgh = \tfrac{1}{2}mv_{\rm cm}^2 + \tfrac{1}{2}\big(\beta mR^2\big)\!\left(\frac{v_{\rm cm}}{R}\right)^{\!2} = \tfrac{1}{2}mv_{\rm cm}^2(1+\beta) \qquad\Longrightarrow\qquad v_{\rm cm} = \sqrt{\frac{2gh}{1+\beta}}.\]

    This agrees with the force-and-torque result of equation (10.15): an acceleration \(g\sin\theta/(1+\beta)\) along a slope of length \(h/\sin\theta\) gives \(v_{\rm cm}^2 = 2gh/(1+\beta)\). The energy picture explains why a hoop (\(\beta = 1\)) loses the race to a solid sphere (\(\beta = \tfrac{2}{5}\)): the hoop must divert a larger share of the released energy into spin.

    Note: Static friction does no work in rolling

    Using energy conservation on a rolling body may look illegal, since a friction force is plainly acting. It is not, and the reason is the one fact that defines rolling: the contact point is instantaneously at rest. A force does work only when its point of application moves, so the static friction at the contact patch does no work and dissipates no energy: it merely transfers energy between the translational and rotational accounts. Kinetic friction, which acts when a body skids, is a different matter entirely: there the surfaces slide past one another and mechanical energy is lost as heat.

    Answers to Checkpoints

    Checkpoint 11.1. The disk. Equal kinetic energies mean \(\tfrac{1}{2}I_{\rm hoop}\omega_{\rm hoop}^2 = \tfrac{1}{2}I_{\rm disk}\omega_{\rm disk}^2\), so \(\omega_{\rm disk}^2/\omega_{\rm hoop}^2 = I_{\rm hoop}/I_{\rm disk} = MR^2/(\tfrac{1}{2}MR^2) = 2\). Taking the square root, the disk turns faster by a factor of \(\sqrt{2} \approx 1.41\). It needs the higher angular speed because its mass is concentrated nearer the axis, where it moves more slowly.


    This page titled 11.1: Rotational Kinetic Energy was last modified on Thu, 12 Nov 2026 04:26:53 GMT and is shared under a CC BY 4.0 license and was authored, remixed, and/or curated by Michael Ragsdale.