2.1: Subsonic, sonic and supersonic flow

Aircraft Engine: Design and Analysis · LibreTexts

0%

Contents

    Text

    Size
    100%
    Theme
    Typeface
    Line length
    Spacing

    Read aloud

    How

    Speed: 1×
    Light up
    Highlight

    Symbols: Mulberry Symbols, © 2018–2026 Steve Lee, CC BY-SA 4.0 (licence, the set), the site's own copies.

    From LibreTexts, under CC BY 4.0, as the source states it; its equations are written in TeX, which the PDF shows typeset. This page at LibreTexts.

    2.1: Subsonic, sonic and supersonic flow

    The Mach number divides compressible flow into three regimes as shown in Figure 1, each with different behavior:

    1. Subsonic flow (Ma \(\boldsymbol{\mathrm{<}}\) 1): Pressure disturbances travel faster than the flow, so they propagate upstream and the fluid "senses" obstacles ahead of it. In a converging duct the flow accelerates and its pressure drops, as in incompressible flow.
    2. Sonic flow (Ma = 1): The flow speed equals the local speed of sound. This is the boundary between the two regimes and often occurs at the throat of a nozzle, where the flow is said to be choked. Further downstream conditions can no longer change the mass flow rate.
    3. Supersonic flow (Ma \(\boldsymbol{\mathrm{>}}\) 1): The flow outruns pressure disturbances, so information cannot travel upstream. Abrupt changes occur through shock waves, and the flow behaves opposite to the subsonic case. A diverging duct accelerates it and a converging duct decelerates it.
    image1.png
    Figure 1. converging–diverging (de Laval) nozzle

    For \(Ma < 1\) the flow speeds up as the area shrinks. For \(Ma > 1\) it speeds up as the area grows. This is why a rocket nozzle converges to a throat and then diverges. To calculate the mass flow rate, we need to know the local flow area \(A\), the local Mach number \(Ma\), the local total pressure \(pt\) and total temperature \(Tt\), and the gas properties \(k\) and \(R\). Total temperature stays constant in adiabatic flow with no shaft work, and total pressure stays constant in isentropic flow with no shaft work. In steady flow the mass flow rate must be the same at every section of a duct. We express this as a dimensionless area ratio, using the sonic flow area \(A^*\), which is the area where \(Ma = 1\):

    \[\frac{A}{A^*}=\frac{1}{Ma}{\left[\frac{1+\frac{k-1}{2}{Ma}^2}{\frac{k+1}{2}}\right]}^{\dfrac{k+1}{2\left(k-1\right)}} \nonumber \]


    This page titled 2.1: Subsonic, sonic and supersonic flow was last modified on Wed, 18 Nov 2026 07:18:34 GMT and is shared under a CC BY 4.0 license and was authored, remixed, and/or curated by Haifa El-Sadi.