4.0: Introduction

Aircraft Engine: Design and Analysis · LibreTexts

0%

Contents

    Text

    Size
    100%
    Theme
    Typeface
    Line length
    Spacing

    Read aloud

    How

    Speed: 1×
    Light up
    Highlight

    Symbols: Mulberry Symbols, © 2018–2026 Steve Lee, CC BY-SA 4.0 (licence, the set), the site's own copies.

    From LibreTexts, under CC BY 4.0, as the source states it; its equations are written in TeX, which the PDF shows typeset. This page at LibreTexts.

    4.0: Introduction

    A gas turbine engine is an internal combustion engine that converts the chemical energy in fuel into rotating shaft power or high-speed exhaust thrust. It works on a continuous flow of air, unlike a piston engine, which runs in discrete intake, compression, power, and exhaust strokes. That continuous flow lets it deliver a great deal of power from a compact, relatively lightweight machine, which is why it dominates aviation and plays a major role in electricity generation.

    The thermodynamic cycle is the Brayton cycle, which has four stages handled by three main components. The working fluid of the Brayton cycle is air, which is drawn in and compressed by rows of rotating and stationary blades in the compressor. Modern engines reach overall pressure ratios of 30:1 or higher. Compression increases the air’s temperature and pressure, which improves combustion performance. Fuel is then injected into the compressed air and burned continuously at roughly constant pressure. The temperature of the gases leaving the combustor can exceed 1,500 \(\mathrm{{}^\circ}\) C in advanced engines, which is above the melting point of the metals used downstream. The hot, high-pressure gases expand through the turbine blades, rotating them. The turbine is connected to the compressor by a shaft, so the turbine extracts the energy required to drive the compressor, and any remaining energy is used either for thrust or for turning an output shaft. The remaining gases accelerate out of the nozzle to produce thrust.

    There are different types of gas turbine engines. The turbojet produces all of its thrust from the exhaust jet; it is fast but noisy, and it is efficient at high speeds. The turbofan has a large front fan that bypasses much of the air around the core, giving better fuel efficiency and lower noise. Turboprop and turboshaft engines use the turbine to drive a propeller or rotor through a gearbox, and they are very common in regional aircraft and helicopters. The core of an aircraft gas turbine engine is the gas generator, which consists of three main components: a compressor, a burner, and a turbine. The compressor total pressure ratio, rp, is a design parameter. The flight Mach number is a key factor in choosing the number and type of compressor stages. As a general rule, the higher the flight Mach number, the lower the compressor pressure ratio the cycle needs to operate efficiently. At high supersonic speeds, the engine does not need mechanical compression at all, so the compressor can be removed. These engines rely on ram compression, in which the incoming air is compressed simply because the aircraft is moving fast, and they are called ramjets.


    This page titled 4.0: Introduction was last modified on Wed, 18 Nov 2026 07:18:32 GMT and is shared under a CC BY 4.0 license and was authored, remixed, and/or curated by .