7.4: Problems and References

Aircraft Engine: Design and Analysis · LibreTexts

0%

Contents

    Text

    Size
    100%
    Theme
    Typeface
    Line length
    Spacing

    Read aloud

    How

    Speed: 1×
    Light up
    Highlight

    Symbols: Mulberry Symbols, © 2018–2026 Steve Lee, CC BY-SA 4.0 (licence, the set), the site's own copies.

    From LibreTexts, under CC BY 4.0, as the source states it; its equations are written in TeX, which the PDF shows typeset. This page at LibreTexts.

    7.4: Problems and References

    Problem#1

    Given that the average heat flux through a particular zone in a cast iron liner \(8~\mathrm{mm}\) thick is \(0.25{~\mathrm{MW/m}}^2\), the coolant temperature is \({90}^{\circ }\mathrm{C}\), and the coolant-side heat transfer coefficient is \(8000{~\mathrm{W/m}}^2\cdot \mathrm{K}\), find the average surface temperature on the combustion chamber and coolant sides of the liner at that zone.

    Problem#2

    Using dimensional analysis, compare the relative heat losses of two geometrically similar SI engines (same bore/stroke ratio, same connecting rod/stroke ratio) operating at the same imep and power. Engine A has three times the displacement per cylinder of Engine B. Assume that the wall temperature and the gas temperature for both engines are the same.

    Problem#3

    1. Using Woschni’s correlation, evaluate the percentage increase in heat transfer expected from an engine with a mean piston speed of \(12~\mathrm{m/s}\) when the swirl ratio is raised from \(0\) to \(4\). Do your comparison for the intake process only. The engine bore is \(0.12~\mathrm{m}\) and the engine speed is \(3000~\mathrm{rev/min}\).
    2. Explain how both the generation of swirl and the resulting change in heat transfer affect the volumetric efficiency of an engine.

    Problem#4

    The three main regimes of energy loss due to friction: boundary-regime friction, hydrodynamic (full fluid film) lubrication, and turbulent viscous dissipation. Calculate the approximate fractional breakdown of total per-cycle frictional work across these three regimes for a V8 passenger-car gasoline engine running at an engine speed of 3200 RPM.

    Problem#5

    Consider four-stroke, naturally aspirated multi-cylinder gasoline (SI) and diesel compression-ignition (CI) automotive powerplants operating under WOT (100% load) as well as 40% partial load at a intermediate rotational speed of 2500 RPM. Provide rough percentage distributions of the total friction mean effective pressure across the following three functional components: pumping mean effective pressure (\(\mathrm{pmep}\)), mechanical rubbing mean effective pressure (\(\mathrm{rfmep}\)), and auxiliary/accessory loss (\(\mathrm{amep}\)). Clearly explain the methodology used to arrive at your estimates and list all components classified under auxiliary devices.

    References

    J. B. Heywood, Internal Combustion Engine Fundamentals, New York: McGraw-Hill Education, 1988


    This page titled 7.4: Problems and References was last modified on Wed, 18 Nov 2026 07:18:34 GMT and is shared under a CC BY 4.0 license and was authored, remixed, and/or curated by .