15.2: Meter-In Flow Control Circuits

Fluids 1: Fluid Power and Pneumatics (NWTC) · LibreTexts

0%

Contents

    Text

    Size
    100%
    Theme
    Typeface
    Line length
    Spacing

    Read aloud

    How

    Speed: 1×
    Light up
    Highlight

    Symbols: Mulberry Symbols, © 2018–2026 Steve Lee, CC BY-SA 4.0 (licence, the set), the site's own copies.

    From LibreTexts, under CC BY 4.0, as the source states it; its equations are written in TeX, which the PDF shows typeset. This page at LibreTexts.

    15.2: Meter-In Flow Control Circuits

    Meter-In Flow Control Circuits

    A Pneumatic Schematic showing a gage, flow control valve on top, and cylinder.
    Figure \(\PageIndex{1}\): A Pneumatic Schematic. (ISO 1219)
    A Pneumatic Schematic showing a gage, flow control valve on bottom, and cylinder.
    Figure \(\PageIndex{2}\): A Pneumatic Schematic. (ISO 1219)

    The placement of flow control valves in a circuit has significant implications. In a meter-in setup, the valve is positioned to control flow entering the actuator, affecting speed during extension or retraction, depending on placement. The opposing load characteristic of meter-in circuits makes them useful in specific applications like extending a lift cylinder in packaging machines. A key limitation is that they only work where load opposes movement, as they cannot handle aiding loads that might cause uncontrolled movement.

    A Pneumatic Schematic showing an entering flow, rod retracting, and DCV shifted.
    Figure \(\PageIndex{3}\): A Pneumatic Schematic. (ISO 1219)
    A Pneumatic Schematic showing an entering flow, rod extending, and DCV shifted.
    Figure \(\PageIndex{4}\): A Pneumatic Schematic. (ISO 1219)

    15.2: Meter-In Flow Control Circuits is shared under a CC BY 4.0 license and was authored, remixed, and/or curated by Jessy Haid (Northeast Wisconsin Technical College).