Opening the book…
In this activity you will test three bacterial samples. Label each plate with the sample it is to be inoculated with.
- Turn on the Bunsen burner and sterilize the inoculating loop by passing it through the flame of the burner.
- Obtain a bacterial culture. Remove the cap. Pass the mouth of the tube through the flame of the Bunsen burner.
- Insert the loop into the tube to acquire a sample of the bacterium.
- Pass the tube through the flame of the Bunsen burner and recap the test tube, and return the tube to the test tube rack.
- Aseptically transfer the sample of bacteria to the surface of the blood agar plate, introduce the sample by streaking back and forth in the center of the plate to form a broad down the center of the surface of the plate.
- Sterilize the inoculating loop by flaming the loop in the flame of the Bunsen burner.
- Invert your freshly streaked plate to prevent condensation from raining down on the surface of the agar. Repeat steps 1 - 7 for the second and third bacterial species and blood agar plates to be inoculated.
- Incubate the plates in an inverted position at 37°C for 24 hours.
- After 24 hours observe the plate and record your results below.
In the table below write the name of the species tested and the results for each of the tests performed.
| Bacterial Species | Appearance of media following incubation | Blood Hemolysis Test Results |
|---|---|---|
|
|
||
|
|
||
|
|
||
|
|
||
|
|
This page titled 3.10.2: Blood Agar Test Activity was last modified on Thu, 08 Oct 2026 17:00:56 GMT and is shared under a CC BY 4.0 license and was authored, remixed, and/or curated by Sherry Smith.
The book could not be loaded just now.