Opening the book…
The contents of this chapter have largely focused on the properties of microorganisms, but external factors can also play large roles in determining microbial reaction rates within an environment. Two such controls considered here are the rate of energy resource supply and the surface area of solid-phase reactants.
The rate at which energy resources are supplied often sets the upper limit on the rates at which microorganisms can be active in natural systems. As an example, Bernhardt et al. (2022) demonstrated the importance of light availability on gross primary productivity and ecosystem respiration using data collected from 222 U.S. rivers. Statistical modeling indicated that annual solar energy inputs, together with the stability of flows, were the primary drivers of gross primary production and ecosystem respiration. Thus, light availability sets a limit on organic matter production by phototrophs, which in turn constrains the amount of respiration that can occur.
As a second example, fermentation is generally considered to be the overall rate limiting step in anaerobic degradation of organic matter (Arndt et al., 2013; Postma and Jakobsen, 1996; Westrich and Berner, 1984). This assertion is supported by the short turn over times of fermentation products such as dihydrogen and acetate (Novelli et al., 1988) and the fact that fermentation products are generally maintained at very low concentrations by respiring microorganisms (Postma and Jakobsen, 1996). Fermentation products are not piling up. They are being used virtually as fast as they are supplied. Kinetic properties of individual groups of respiring microorganisms may determine rates of their specific respiration reactions. However, this conceptual model implies that the overall respiration is set by the fermenters.
To illustrate, consider again the model results shown in Figure \(9.5\). Kinetic factors associated with sulfate reducers and methanogens determined the outcome of their competition. However, the overall rate of acetate oxidation was set by the rate at which acetate was delivered to the system by inflowing water. In the model, acetate was simply included as a reactant in the inflowing water but in an actual anaerobic system, acetate typically originates as a fermentation product.
Lastly, for reactions that involve multiple phases (i.e., heterogeneous reactions), the surface area of the interface between the reactions is a constraint on the reaction rate. The reaction must occur through the interface surface area and thus, the size of the interface places an upper limit on the amount of reaction that can occur within a given time. This relationship applies to both abiotic and biotic reactions. As an example, where microorganisms use solid-phase ferric iron as an electron acceptor, they must be able to transfer electrons to the solid phase from the aqueous phase (Fig. \(9.6\)). Therefore, ferric iron crystals with larger surface areas can support more rapid iron reduction. In fact, based on findings from laboratory studies, Roden and others concluded that the surface area of ferric iron minerals was more important than their mineralogical and thermodynamic properties as a control on the rate of microbial iron reduction (Roden, 2006, 2003; Roden and Zachara, 1996).
https://commons.wikimedia.org/wiki/File:Heterogeneous_microbial_reaction.jpg
This page titled 9.7: External controls on microbial reaction rates was last modified on Sun, 31 Mar 2024 22:36:57 GMT and is shared under a CC BY-SA 4.0 license and was authored, remixed, and/or curated by Matthew F Kirk via source content that was edited to the style and standards of the LibreTexts platform.
The book could not be loaded just now.