The New Ford
National Archives
Education
Clips are not offered for this film: no licence or public-domain mark is recorded for it.
Parts
About
The New Ford Produced: 1927
Description The original catalog description provided by the Ford Motor Company reads as follows: Diagrams illustrating the following captions. “To camshaft from bearing.” “Overflow pipe from valve chamber reservoir to oil pan tray.” “Connecting rod dipper forces oil into rod bearing.” “All other lubrication is by the splash system.” “Oil return pipe from crankshaft rear bearing.” “Oil from tray over-flows into main reservoir.” “The transmission. The transmission in the new Ford ranks with the finest made.” Transmission parts on table. “The cluster gear.” Hand holding and displaying gear. “Placing roller bearing in cluster gear.” Hand assembling transmission. “This ball bearing fits on the shifter shaft.” Assembling bearing to shaft. “Assembling into case.” “Every crankshaft is polished.” Worker examining crankshaft. “Crankshaft fitting in engine.” “Shimming the crankshaft.” Worker installing crankshaft. “The camshaft has five bearings.” Worker pointing out bearings. “The center bearing is the gear for the oil pump and distributor shafts.” Close-up. “Assembling the camshaft in engine.” Worker installing camshaft - close-up of crankshaft and camshaft turning. “Connecting rods are tested for gravity balance to ensure proper distribution of weight.” Parts on scale. “Pistons -- aluminum pistons are used in the new Ford.” “Weighing each completely assembled piston -- all piston assemblies are in perfectly matched sets.” Piston on scale, worker lifting it, weight marked on bottom. “The fly wheel is statically and dynamically balanced.” Worker placing flywheel on machine - close-up of level - installing flywheel. “Oil Pump.” Parts on table. “This pump is gear driven and is in a forged steel housing.” Hands assembling pump. “The oil pump is placed in the bottom of the oil pan.” Installing oil pump. “The oil pump -- gear type. It is driven by spiral gear on camshaft.” Diagram of this and the following. “The oil passage to valve chamber reservoir surrounds pump shaft.” “Valve chamber oil inlet.” “The engine is pitched on a three degree angle. Oil line to crankshaft main bearing.” [1927]
https://catalog.archives.gov/id/92707
Human-made No record of this work says a model made it. What this means.