Learn · Electronic Modules for Industrial Applications using Op-Amps
Lecture 42 of 52Week 7 Introduction to Gas Sensors and Experiment on Signal conditioning Circuit for Operating Heater Voltage of MQ-7…
Signal conditioning Circuit for Operating Heater Voltage of MQ-7 Gas Sensor - Part 2
Prof. Hardik Jeetendra Pandya · IISc Bangalore
Credits and licence
- From
- Electronic Modules for Industrial Applications using Op-Amps, IISc Bangalore (at NPTEL)
- Licence
- CC BY-NC-SA, as NPTEL states it. Non-commercial use only.
- Attribution
- NPTEL states: "Distributed under Creative Commons Attribution-ShareAlike / CC BY - NC - SA", beside a BY-NC-SA badge.
- Who can watch
- Tweens profiles and older. How courses are placed
All the lectures
- Introduction to Op-Amps
- Introduction Wafer Manufacturing Process and Clean room Protocols
- Introduction to Fabrication Process Technology and Op-amp
- Op-amp Characteristics and Datasheet Parameters
- Overview of Active Filters and Oscillators
- Overview of Op-amp Oscillators
- Introduction to ECG Experiment
- Design and Implementation of ECG Preprocessing Stage: Part 1
- Design and Implementation of ECG Preprocessing Stage: Part 2
- Design and Implementation of ECG Preprocessing Stage: Part 3
- Design and Implementation of ECG Preprocessing Stage: Part 4
- Design and Implementation of Peak Detector and Thresholding Circuit for ECG Signal Conditioning
- Experiment: Live Demonstration of ECG Signal Acquistion, Conditioning and Measurement of BPM
- Application: ECG Signals for detecting AF and the role of sensors
- Photolithography: Masks
- Understanding the process of photolithography
- Photolithography: Mask Aligner
- Photolithography: Designing of Mask Aligner System
- Fabrication of Piezoresistive Sensor
- Fabrication of MEMS based Catheter Contact Force Sensor
- Design of Speed Control of DC Motor:Introduction
- Design of Speed Control of DC Motor:Circuit Explanation
- Design of Speed Control of DC Motor:Encoder Calibration
- Design of Speed Control of DC Motor: Encoder Signal Conditioning Circuit-1
- Design of Speed Control of DC Motor: Encoder Signal Conditioning Circuit-2
- Design of Speed Control of DC Motor: Encoder Signal Conditioning Circuit-3
- Design of Speed Control of DC Motor: Encoder Signal Conditioning Circuit-4
- Design of Speed Control of DC Motor: Error Amplifier
- Design of Speed Control of a DC Motor using Op-amp: Controllers
- Design of Speed Control of a DC Motor using Op-amp: Circuit Implementation
- Design of Speed Control of a DC Motor using DAQ: Part 1
- Design of Speed Control of a DC Motor using DAQ: Part 2
- Design of Speed Control of a DC Motor using DAQ: Part 3
- Introduction to Hot-Wire Anemometer
- Signal conditioning Circuit for Hot-Wire Anemometer
- Signal-conditioning Circuit for Hot-Wire Anemometer Part 2
- Signal-conditioning Circuit for Hot-Wire Anemometer: Simulation
- Signal-conditioning Circuit for Hot-Wire Anemometer: Experiment
- Introduction to Gas Sensors
- Fabrication Process for Gas Sensor
- Signal conditioning Circuit for Operating Heater Voltage of MQ-7 Gas Sensor - Part 1
- Signal conditioning Circuit for Operating Heater Voltage of MQ-7 Gas Sensor - Part 2
- Signal conditioning Circuit for Operating Heater Voltage of MQ-7 Gas Sensor - Part 3
- Fundamentals of Electrophysiological signals
- Fundamentals of EEG Signal
- Application of EEG Signal for Detection of Hearing Loss
- Closed loop control of temperature using DAQ and LabVIEW
- Experimental Set-up of closed loop control of temperature sensor
- Introduction to MEMS Simulation using COMSOL Multiphysics
- Introduction to COMSOL Multiphysics
- COMSOL Examples for MEMS Applications
- COMSOL Examples for MEMS Applications (cotd.)