Learn · Power Electronics and Distributed Generation
Lecture 26 of 40Power electronic design
Inverter switching and average model
Dr. Vinod John · IISc Bangalore
Credits and licence
- From
- Power Electronics and Distributed Generation, IISc Bangalore (at NPTEL)
- Licence
- CC BY-NC-SA, as NPTEL states it. Non-commercial use only.
- Attribution
- NPTEL states: "Distributed under Creative Commons Attribution-ShareAlike / CC BY - NC - SA", beside a BY-NC-SA badge.
- Who can watch
- Tweens profiles and older. How courses are placed
All the lectures
- Course introduction and overview
- Distributed generation technologies
- Distributed storage technologies
- Distribution system protection
- Circuit breaker coordination
- Symmetrical component analysis and sequence excitation
- Modeling of distribution system components
- Protection components
- Impact of distributed generation of distribution protection
- Consumption and distribution grounding
- Islanding of distribution systems
- Modeling of islanded distribution systems
- Distribution system problems and examples
- Distribution system problems and examples continued
- Anti-islanding methods
- Solid state circuit switching
- Relaying for distributed generation
- Feeder voltage regulation
- Grounding, distribution protection coordination problems and examples
- Ring and network distribution
- Economic evaluation of DG systems
- Design for effective initial cost
- Single phase inverters
- DC bus design in voltage source inverter
- Electrolytic capacitor reliability and lifetime
- Inverter switching and average model
- Common mode and differential mode model of inverters
- Two leg single phase inverter
- Distribution system problems, and examples
- DG evaluation problems and examples
- Switch selection in two level voltage source inverters and loss evaluation
- Thermal model, management and cycling failure of IGBT modules
- Semiconductor switch design reliability considerations
- AC filters for grid connected inverters
- AC inductor design and need for LCL filter
- LCL filter design
- Examples in power electronic design for DG systems
- Examples in power electronic design for DG systems continued
- Higher order passive damping design for LCL filters
- Balance of hardware component for inverters in DG systems