Opening the book…
By the end of this unit, you will be able to:
- Describe the resting potential and the role of the sodium-potassium pump.
- Explain how EPSPs and IPSPs add up to reach threshold and trigger an all-or-none action potential.
- Explain how myelin and saltatory conduction speed up signals.
Neurons “talk” with a mix of electricity and chemicals. Inside a neuron, the message is electrical. Between neurons, most synapses are chemical, but electrical synapses also exist. This unit covers the electrical part.
Resting Potential
Even when a neuron isn’t sending a message, it’s charged and ready, a bit like a battery. Inside, it’s slightly negative compared to outside, about −70 millivolts. This is the resting potential.
The charge comes from ions, tiny particles with an electrical charge. At rest, there’s more sodium outside the cell and more potassium inside, along with negatively charged particles that stay inside. The sodium-potassium pump keeps this balance by moving sodium out and potassium in.
The Action Potential
A neuron receives many small inputs from other neurons. Excitatory postsynaptic potentials (EPSPs) push it closer to firing, and inhibitory postsynaptic potentials (IPSPs) push it further away. The neuron adds them all up, which is called summation.
If the total reaches the threshold, about −55 millivolts, the neuron fires an action potential:
- Sodium rushes into the cell, and the inside becomes positive, up to about +40 millivolts.
- Potassium then flows out, bringing the charge back down. It briefly dips below the resting level before settling back.
- The whole spike lasts only a millisecond or two.

Image description: A line graph titled “An Action Potential,” with voltage inside the neuron (millivolts) on the vertical axis and time (0 to 6 milliseconds) on the horizontal axis. The line starts flat at the resting potential, about −70 mV. Starting at 1 millisecond, inputs push it up to a dashed threshold line at about −55 mV. Then it shoots up as sodium rushes in, peaking at about +40 mV at about 2 milliseconds. It falls quickly as potassium flows out, dips briefly below rest to about −80 mV (hyperpolarization), and returns to −70 mV by about 5 milliseconds.
Credit: Diagram by Michael Miguel for Biological Psychology (Coalinga College Ed.), CC BY-NC-SA 4.0.
An action potential is all-or-none: the neuron either fires completely or not at all. A stronger signal doesn’t make a bigger spike. It makes the neuron fire more often.
Think of a toilet flush. Pushing the handle a little does nothing. Push past a certain point and it flushes all the way, the same every time. Then it needs a moment to refill before it can flush again.
Myelin Speeds Things Up
On a myelinated axon, the signal jumps from one gap in the myelin to the next. These gaps are called nodes of Ranvier, and the jumping is called saltatory conduction, from the Latin word for “to leap.” It’s much faster than creeping along a bare axon, like a stone skipping across water.

Image description: An infographic titled “Saltatory Conduction: Myelin Speeds Things Up.” At the top, a neuron is labeled with its cell body, myelin sheath (insulating layer), nodes of Ranvier (gaps between myelin segments), myelinated axon, and axon terminals. A middle panel compares unmyelinated conduction (slower: the signal moves step by step along the whole membrane) with myelinated conduction (faster: the signal “jumps” from one node of Ranvier to the next). A bottom strip shows the steps: sodium rushes in at a node, current spreads inside the axon under the myelin, and the next node reaches threshold and fires. A final panel compares this to a stone skipping across water. A side panel titled “Why Myelin Matters” lists three benefits: Faster (signals travel much faster down the axon), Efficient (less energy is used because fewer ions cross the membrane), and Efficient & Precise (the signal stays strong and accurate over long distances).
Credit: AI-generated image created by Michael Miguel with ChatGPT (OpenAI).
Mia is a nursing student at Coalinga College. During a hospital clinical shift, she steps on a dropped thumbtack. Before she can think, she lifts her foot. Sensory neurons sent an action potential to her spinal cord, interneurons passed it on, and motor neurons told her leg muscles to pull back. A moment later, signals reaching her brain let her feel the pain and decide to grab a bandage.
- A resting neuron sits at about −70 millivolts.
- If inputs add up to threshold (about −55 millivolts), it fires an all-or-none action potential that peaks around +40 millivolts.
- Myelin lets the signal jump from node to node, so it travels faster.
This page titled Unit 3.4: Communication Within and Between Neurons was last modified on Wed, 11 Nov 2026 09:22:50 GMT and is shared under a CC BY-NC-SA 4.0 license and was authored, remixed, and/or curated by Michael Miguel.
The book could not be loaded just now.