34.E: Diffraction (Problems)

Physics: A Foundation for Scientists and Engineers · LibreTexts

0%

Contents

    Text

    Size
    100%
    Theme
    Typeface
    Line length
    Spacing

    Read aloud

    How

    Speed: 1×
    Light up
    Highlight

    Symbols: Mulberry Symbols, © 2018–2026 Steve Lee, CC BY-SA 4.0 (licence, the set), the site's own copies.

    From LibreTexts, under CC BY 4.0, as the source states it; its equations are written in TeX, which the PDF shows typeset. This page at LibreTexts.

    34.E: Diffraction (Problems)

    Difficulty key: ★ introductory, ★★ standard, ★★★ challenging. Treat angles as small where appropriate (\(\sin\theta\approx\tan\theta = y/L\)), and take visible light to span roughly \(400\)–\(700\,\mathrm{nm}\).

    Section 34.1 — Single-Slit Diffraction

    34.1 ★ Light of wavelength \(633\,\mathrm{nm}\) passes through a slit \(0.085\,\mathrm{mm}\) wide. At what angle is the first diffraction minimum?

    34.2 ★★ A slit \(0.040\,\mathrm{mm}\) wide is lit by \(550\,\mathrm{nm}\) light, with a screen \(1.5\,\mathrm{m}\) away. Find the width of the central bright fringe.

    34.3 ★★ [Conceptual.] As a single slit is made narrower and narrower, describe what happens to the diffraction pattern, and explain why in terms of the condition \(a\sin\theta = m\lambda\).

    34.4 ★★ A single slit \(0.060\,\mathrm{mm}\) wide is lit by a laser of unknown wavelength. On a screen \(1.5\,\mathrm{m}\) away, the central bright band is \(2.4\,\mathrm{cm}\) wide. (a) Find the wavelength of the laser. (b) The slit is replaced by one \(0.040\,\mathrm{mm}\) wide. How wide is the central bright band now?

    Section 34.1.1 — Intensity in Single-Slit Diffraction

    34.5 ★★ In a single-slit pattern, find the intensity (as a fraction of \(I_{\max}\)) at the angle where \(\alpha = \pi/2\).

    34.6 ★★★ [Conceptual.] Explain why the single-slit intensity formula \(I = I_{\max}(\sin\alpha/\alpha)^2\) gives a maximum at \(\alpha = 0\) even though \(\sin\alpha/\alpha\) is the indeterminate form \(0/0\) there. What is the value of the limit?

    34.7 ★★★ In single-slit diffraction the intensity is \(I = I_{\max}(\sin\alpha/\alpha)^2\), with \(\alpha = (\pi a/\lambda)\sin\theta\). The first secondary maximum falls near \(\alpha = 3\pi/2\). Find the ratio of its intensity to that of the central maximum.

    Section 34.2 — Diffraction by a Circular Aperture

    34.8 ★ A telescope has an aperture of diameter \(5.0\,\mathrm{m}\). Find its diffraction-limited angular resolution at \(550\,\mathrm{nm}\).

    34.9 ★★ [Real-world application: astronomy.] The Hubble Space Telescope has a mirror \(2.4\,\mathrm{m}\) in diameter. (a) Find its angular resolution at \(500\,\mathrm{nm}\). (b) At the distance of the Moon (\(3.8\times10^{8}\,\mathrm{m}\)), what is the smallest feature it could resolve?

    34.10 ★★★ [Real-world application: vision.] Two stars are separated by an angle of \(2.0\times10^{-5}\,\mathrm{rad}\). What minimum aperture diameter is needed to resolve them at \(550\,\mathrm{nm}\)? Could the human eye (pupil \(\sim2\,\mathrm{mm}\)) do it?

    34.11 ★★ [Real-world application: vision.] In bright light the pupil is about \(3.0\,\mathrm{mm}\) across. Using \(550\,\mathrm{nm}\) light, find (a) the smallest angular separation the eye can resolve, and (b) the smallest separation of two dots at a reading distance of \(40\,\mathrm{cm}\).

    Section 34.3 — Diffraction by a Double Slit

    34.12 ★★ A double slit has slit separation \(d = 0.090\,\mathrm{mm}\) and slit width \(a = 0.015\,\mathrm{mm}\). Which interference orders are missing (suppressed by the diffraction envelope)?

    34.13 ★★★ For a double slit with \(d = 0.12\,\mathrm{mm}\) and \(a = 0.030\,\mathrm{mm}\), how many bright interference fringes lie within the central diffraction maximum?

    34.14 ★★★ A double slit has slit separation \(0.10\,\mathrm{mm}\) with each slit \(0.020\,\mathrm{mm}\) wide, illuminated by \(500\,\mathrm{nm}\) light. How many bright interference fringes lie within the central diffraction envelope?

    Section 34.4 — Diffraction Gratings

    34.15 ★ A diffraction grating has \(5000\) lines per centimeter. Find the angle of the first-order maximum for \(600\,\mathrm{nm}\) light.

    34.16 ★★ [Real-world application: spectroscopy.] A grating with \(8000\) lines per centimeter is lit by light containing \(486\,\mathrm{nm}\) and \(656\,\mathrm{nm}\) (two hydrogen lines). Find the angular separation between these two lines in the first order.

    34.17 ★★★ White light (\(400\)–\(700\,\mathrm{nm}\)) falls on a grating with \(4000\) lines per centimeter. (a) Find the angular width of the first-order spectrum. (b) Does the first-order spectrum overlap the second-order spectrum? Justify with angles.

    Section 34.5 — X-Rays & the Many-Slit Question

    34.18 ★★ X-rays of wavelength \(0.120\,\mathrm{nm}\) undergo first-order Bragg reflection from a crystal whose atomic planes are spaced \(0.250\,\mathrm{nm}\) apart. At what angle (from the planes) does the reflection occur?

    34.19 ★★★ [Real-world application: materials science.] First-order Bragg reflection of \(0.165\,\mathrm{nm}\) X-rays from a crystal is observed at \(21.5^{\circ}\) from the planes. (a) Find the interplanar spacing. (b) At what angle would the second-order reflection appear, if it exists?

    34.20 ★★★ [Conceptual — one slit to many.] Trace the chapter’s through-line. Explain in a few sentences how the pattern evolves as you go from one slit, to two slits, to a grating of thousands of slits, to a crystal’s three-dimensional lattice: identifying for each what stays the same (the role of path difference) and what changes (the sharpness and dimensionality of the pattern).

    Challenge Problems

    34.21 ★★★ [Real-world application: astronomy — imaging a black hole.] The shadow of the supermassive black hole at the center of the galaxy M87 subtends about \(42\) microarcseconds (\(42\times 10^{-6}\,\mathrm{}\) arcsec) as seen from Earth. Radio astronomers imaged it by combining telescopes across the planet into one instrument whose effective aperture is the separation between the dishes. Use \(1\ \text{radian} = 206265\) arcsec.

    1. Convert \(42\) microarcseconds to radians.
    2. Observing at \(\lambda = 1.3\,\mathrm{mm}\), what aperture diameter does Rayleigh’s criterion require to resolve a feature this small?
    3. Compare your answer with Earth’s diameter, \(12742\,\mathrm{km}\). Comment on what this says about how much margin the observation had.
    4. A later campaign by the same collaboration observed at \(0.87\,\mathrm{mm}\) instead. Keeping the baseline at Earth’s diameter, find the angular resolution at each wavelength, in microarcseconds, and explain the motivation for the shorter wavelength. What is the fundamental obstacle to improving the resolution further without leaving the planet?

    34.22 ★★★ [Real-world application: spectroscopy — resolving the sodium doublet.] The yellow light of a sodium lamp is not one line but two, at \(589.00\,\mathrm{nm}\) and \(589.59\,\mathrm{nm}\). A grating can separate them only if its resolving power \(R = \lambda/\Delta\lambda\) is large enough. For a grating, \(R = Nm\), where \(N\) is the number of slits illuminated and \(m\) is the order.

    1. Justify \(R = Nm\) from the angular half-width \(\Delta\theta_{\rm hw} = \lambda/(Nd\cos\theta)\) given in this chapter: two wavelengths are just resolved when the maximum of one falls at the first minimum of the other. (Hint: differentiate the grating equation to find how far a maximum shifts when \(\lambda\) changes by \(\Delta\lambda\), and set that shift equal to \(\Delta\theta_{\rm hw}\).)
    2. Find the resolving power needed for the sodium doublet.
    3. A grating is ruled with \(600\) lines per millimeter. In first order, how wide must the illuminated patch of grating be? At what angle does the doublet appear?
    4. Repeat part (c) for second order. Which order would you use, and what is the practical cost of going to higher order?

    34.23 ★★★ [Real-world application: photography — the diffraction-limited aperture.] A camera lens’s \(f\)-number is \(N_f = f/D\), where \(D\) is the diameter of the aperture. The lens focuses light onto a sensor a distance \(\approx f\) behind it, so the diameter of the Airy disk formed there is \(d = 2 f \theta_{\min}\), with \(\theta_{\min} = 1.22\lambda/D\). Take \(\lambda = 550\,\mathrm{nm}\).

    1. Show that \(d = 2.44\,\lambda\,N_f\): the focal length drops out entirely, so the diffraction spot depends only on the \(f\)-number.
    2. Evaluate \(d\) at \(f/2.8\) and at \(f/16\).
    3. A full-frame sensor \(36\,\mathrm{mm}\) wide with \(8400\) pixels across has a pixel pitch of about \(4.3\,\mathrm{\mu m}\). Find the \(f\)-number at which the Airy disk first spans two pixels, so that stopping down further can no longer add detail.
    4. Landscape photographers nevertheless routinely shoot at \(f/16\). Explain what they are buying with the resolution they give up, and why the trade is usually worth it.

    This page titled 34.E: Diffraction (Problems) was last modified on Thu, 12 Nov 2026 04:27:10 GMT and is shared under a CC BY 4.0 license and was authored, remixed, and/or curated by Michael Ragsdale.