14.E: Fluids (Problems)

Physics: A Foundation for Scientists and Engineers · LibreTexts

0%

Contents

    Text

    Size
    100%
    Theme
    Typeface
    Line length
    Spacing

    Read aloud

    How

    Speed: 1×
    Light up
    Highlight

    Symbols: Mulberry Symbols, © 2018–2026 Steve Lee, CC BY-SA 4.0 (licence, the set), the site's own copies.

    From LibreTexts, under CC BY 4.0, as the source states it; its equations are written in TeX, which the PDF shows typeset. This page at LibreTexts.

    14.E: Fluids (Problems)

    Difficulty key: ★ introductory, ★★ standard, ★★★ challenging.

    Section 14.1 — Fluids, Density, and Pressure

    14.1 ★ A block of aluminum has a mass of \(2.7\,\mathrm{kg}\) and a volume of \(1.0\times 10^{-3}\,\mathrm{m^3}\). Find its density, and state whether it would sink or float in water.

    14.2 ★ [Conceptual.] A sharp knife cuts far more easily than a dull one, even with the same force behind it. Explain this using the definition of pressure.

    14.3 ★★ [Real-world: engineering.] A rectangular water bed measures \(2.0\,\mathrm{m}\times1.5\,\mathrm{m}\) and is \(0.30\,\mathrm{m}\) thick.

    1. Find the mass of water it holds (\(\rho_{\rm water} = 1000\,\mathrm{kg/m^3}\)).
    2. Find the pressure it exerts on the floor, assuming it rests on its full \(2.0\,\mathrm{m}\times1.5\,\mathrm{m}\) area.

    Section 14.2 — Pressure as a Function of Depth

    14.4 ★ Find the gauge pressure at the bottom of a swimming pool \(3.0\,\mathrm{m}\) deep.

    14.5 ★ [Conceptual.] Two open tanks hold water to the same depth, but one is ten times wider than the other. Compare the pressure at the bottom of each, and explain why volume does not matter.

    14.6 ★★ [Real-world: oceanography.] A submarine dives to a depth of \(250\,\mathrm{m}\) in seawater (\(\rho = 1025\,\mathrm{kg/m^3}\)).

    1. Find the gauge pressure at that depth.
    2. Find the total (absolute) pressure, including atmospheric pressure (\(1.0\times 10^{5}\,\mathrm{Pa}\)).

    14.7 ★★ A dam holds back a lake. At a point \(12\,\mathrm{m}\) below the surface, find the gauge pressure of the water against the dam, and the force that pressure exerts on a \(1.0\,\mathrm{m^2}\) inspection panel centered at that depth. (The panel is small enough that the pressure may be treated as uniform across it.)

    Section 14.3 — Pascal’s Principle

    14.8 ★ In a hydraulic lift, the input piston has area \(8.0\,\mathrm{cm^2}\) and the output piston \(400\,\mathrm{cm^2}\). What force on the input piston supports a \(12000\,\mathrm{N}\) load?

    14.9 ★★ [Real-world: automotive.] A hydraulic brake system applies a force of \(90\,\mathrm{N}\) to a master-cylinder piston of area \(1.2\,\mathrm{cm^2}\). Each brake (slave) cylinder has area \(6.0\,\mathrm{cm^2}\). Find the force exerted at each brake.

    14.10 ★★ [Conceptual.] A hydraulic lift multiplies force, letting a small push lift a heavy car. Does it also multiply energy or work? Explain what happens to the distances the two pistons move, and why energy is still conserved.

    Section 14.4 — Buoyancy and Archimedes’ Principle

    14.11 ★ A rock displaces \(2.0\times 10^{-3}\,\mathrm{m^3}\) of water when fully submerged. Find the buoyant force on it.

    14.12 ★ [Conceptual.] A steel ship floats, yet a solid steel ball of the same mass sinks. Explain the difference in terms of displaced water and Archimedes’ principle.

    14.13 ★★ A wooden block of density \(650\,\mathrm{kg/m^3}\) floats in water. What fraction of its volume is submerged? (Hint: a floating object displaces its own weight of fluid.)

    14.14 ★★★ A \(0.500\,\mathrm{kg}\) crown is suspended from a scale and lowered fully into water; the scale then reads \(4.10\,\mathrm{N}\).

    1. Find the buoyant force on the crown.
    2. Find the crown’s volume and density.
    3. Is it pure gold (\(\rho = 19300\,\mathrm{kg/m^3}\))?

    14.15 ★★★ [Real-world: recreation.] A \(75\,\mathrm{kg}\) swimmer floats in seawater of density \(1025\,\mathrm{kg/m^3}\), with \(2.0\%\) of her volume above the surface. Find her total body volume and her average density.

    Section 14.5 — Fluid Dynamics and Bernoulli’s Principle

    14.16 ★ Water flows through a pipe of cross-sectional area \(0.080\,\mathrm{m^2}\) at \(2.0\,\mathrm{m/s}\). The pipe narrows to \(0.020\,\mathrm{m^2}\). Find the water’s speed in the narrow section.

    14.17 ★ [Conceptual.] Hold two sheets of paper hanging down a few centimeters apart and blow between them. They move together, not apart. Explain using Bernoulli’s principle.

    14.18 ★★ [Real-world: firefighting.] Water flows at \(1.5\,\mathrm{m/s}\) through a fire hose of radius \(3.0\,\mathrm{cm}\), then exits a nozzle of radius \(1.0\,\mathrm{cm}\).

    1. Find the speed of the water leaving the nozzle.
    2. If the nozzle is aimed horizontally \(1.5\,\mathrm{m}\) above the ground, how far horizontally from the nozzle does the stream land? Neglect air resistance.

    14.19 ★★ [Diagram-reading.] Water flows steadily left to right through the horizontal pipe shown, whose cross-section narrows in the middle.

    A horizontal pipe carrying water left to right, with its cross-section narrowing in the middle.Figure descriptionA horizontal pipe carrying water left to right, with its cross-section narrowing in the middle. Three points are marked A in the wide inlet, B in the narrow throat, and C in the wide outlet.
    1. Rank the flow speeds at A, B, and C.
    2. Rank the pressures at A, B, and C. Explain using continuity and Bernoulli’s principle.

    14.20 ★★★ Water flows through a horizontal pipe that narrows from a radius of \(4.0\,\mathrm{cm}\) to \(2.0\,\mathrm{cm}\). In the wide section the speed is \(1.2\,\mathrm{m/s}\) and the gauge pressure is \(3.0\times 10^{4}\,\mathrm{Pa}\). Find (a) the speed and (b) the gauge pressure in the narrow section.

    Additional Problems

    14.21 ★★★ A U-shaped tube open at both ends contains water (\(\rho_w = 1000\,\mathrm{kg/m^3}\)). Oil (\(\rho_{\text{oil}} = 850\,\mathrm{kg/m^3}\)) is slowly poured into the left arm until it forms a column \(8.0\,\mathrm{cm}\) tall floating on the water.

    1. By equating pressures at the level of the oil–water interface, relate the oil column height to the height of water that rises in the right arm. (Recall that two points at the same height in one connected fluid are at the same pressure, so compare the interface with the point in the right arm at that same level.)
    2. Find the height of that water column.
    3. By how much do the two liquid surfaces differ in height, and which is higher?

    14.22 ★★★ [Real-world: recreation.] A wooden raft of density \(600\,\mathrm{kg/m^3}\) measures \(3.0\,\mathrm{m}\times2.0\,\mathrm{m}\times0.25\,\mathrm{m}\) and floats in fresh water.

    1. Floating empty, what fraction of its thickness is submerged?
    2. What is the maximum load (in kg) it can carry before water reaches its top surface?
    3. How many \(75\,\mathrm{kg}\) people is that?

    14.23 ★★★ [Real-world: engineering.] A large open tank of water has a small hole of area \(1.5\,\mathrm{cm^2}\) in its side, \(2.5\,\mathrm{m}\) below the water surface and \(0.80\,\mathrm{m}\) above the floor.

    1. Using Bernoulli’s equation, show that the water leaves the hole at speed \(v = \sqrt{2gh}\), and evaluate it. (Apply equation (14.10) between the top surface and the hole. Both are open to the atmosphere, so the pressures there are equal; and because the tank is wide and the hole small, the surface descends slowly enough to treat its speed as zero.)
    2. Find the volume flow rate through the hole.
    3. How far from the base of the tank does the stream strike the floor? Neglect air resistance.

    This page titled 14.E: Fluids (Problems) was last modified on Thu, 12 Nov 2026 04:26:44 GMT and is shared under a CC BY 4.0 license and was authored, remixed, and/or curated by Michael Ragsdale.