8.3: Potential Energy

Physics: A Foundation for Scientists and Engineers · LibreTexts

0%

Contents

    Text

    Size
    100%
    Theme
    Typeface
    Line length
    Spacing

    Read aloud

    How

    Speed: 1×
    Light up
    Highlight

    Symbols: Mulberry Symbols, © 2018–2026 Steve Lee, CC BY-SA 4.0 (licence, the set), the site's own copies.

    From LibreTexts, under CC BY 4.0, as the source states it; its equations are written in TeX, which the PDF shows typeset. This page at LibreTexts.

    8.3: Potential Energy

    Not all work ends up as motion. Lift a basketball slowly to a shelf and it is no faster at the top than at the bottom, yet you did work \(mgh\) on it. That energy is not lost; it is stored, ready to reappear as motion if the ball falls. Energy stored by virtue of the arrangement of a system is called potential energy, written \(U\).

    Potential energy is tied to a force acting within the system: gravity between the ball and the Earth, the elastic force between the two ends of a spring. In Chapter 7 we found that each of these forces does work that depends only on where the object starts and ends, not on the route between. That is what makes it possible to attach a single number \(U\) to each arrangement. We define the potential energy so that the work \(W_{\rm int}\) done by the internal force, the force one part of the system exerts on another, is the decrease in \(U\):

    \[W_{\rm int} = -\Delta U. \tag{8.4}\]

    When the force does positive work (gravity on a falling ball, a spring pushing a block back toward its relaxed length) the potential energy goes down, and the energy reappears somewhere else, usually as kinetic energy. When the force does negative work, potential energy is stored. Section 8.4 explains why only some forces have a potential energy; here we work out the two that matter most.

    Gravitational potential energy

    By equation (7.3), gravity near the Earth’s surface does work \(W_g = -mg\,\Delta y = -(mgy_f - mgy_i)\). Comparing with equation (8.4), the quantity whose change this is, is \(mgy\). That is the gravitational potential energy:

    Key Equation: Gravitational potential energy

    \[U_g = mgy, \tag{8.5}\]

    where \(y\) is the height above a chosen reference level. (Many books write \(U_g = mgh\), with \(h\) the height; it is the same thing.) When you lift the basketball a height \(h\) at constant speed, \(\Delta U_g = +mgh\), which is exactly the \(mgh\) of work your hand did in equation (7.4): potential energy is stored work.

    Only changes in potential energy are physically meaningful, so we are free to put the reference level (\(U = 0\)) wherever it is convenient: the floor, a tabletop, the bottom of a hill. This freedom takes some getting used to. It means \(U_g\) has no single “correct” value, and that it is perfectly ordinary for \(U_g\) to be negative: an object in a basement is below a reference level chosen at street height, so \(y < 0\) and \(U_g < 0\). Nothing is wrong when that happens. What matters, and what never depends on the choice, is the difference \(\Delta U_g = mg\,\Delta y\) between two positions. Kinetic energy, by contrast, has no such freedom: \(K\) is never negative, and \(K = 0\) has the unambiguous meaning that the object is at rest.

    One further remark, easy to skip but worth knowing. Gravitational potential energy is not really stored “in” the object; it is stored in the configuration of the object and the Earth together, in how far apart they are. We speak of “the ball’s potential energy” as a convenient shorthand, but it belongs to the ball–Earth system, as in Figure 8.1(b).

    There is another way to picture this that will matter a great deal later. The Earth surrounds itself with a gravitational field: at every point near the Earth, a mass \(m\) feels a force \(m\vec{g}\), so \(\vec{g}\) is the force per unit mass. It is a property of the location, not of whatever object happens to be placed there. In the same spirit, the potential energy per unit mass, \(U_g/m = gy\), is also a property of the location: it says how much energy each kilogram has by virtue of being at height \(y\) in the Earth’s field. Both ideas return for electric forces. In Chapter 16 the electric field is defined as the force per unit charge, and in Chapter 18 the electric potential is the potential energy per unit charge. There, the energy of a system of charges can be pictured as stored in the field itself, and the ball and the Earth are the model to keep in mind.

    Example 8.5: Choosing a reference level

    A \(1.2\,\mathrm{kg}\) book sits on a desk \(0.80\,\mathrm{m}\) above the floor. It is lifted to a shelf \(2.1\,\mathrm{m}\) above the floor. Find its gravitational potential energy at both positions, and the change, using (a) the floor as the reference level and (b) the desktop as the reference level.

    Solution

    In each case, \(y\) is the height measured from the chosen reference level, so the first job is to find the two heights relative to that level.

    (a) With \(U = 0\) at the floor, the heights are \(0.80\,\mathrm{m}\) and \(2.1\,\mathrm{m}\):

    \[\begin{aligned}U_i &= (1.2\,\mathrm{kg})(9.8\,\mathrm{m/s^2})(0.80\,\mathrm{m}) = 9.4\,\mathrm{J}, \\ U_f &= (1.2\,\mathrm{kg})(9.8\,\mathrm{m/s^2})(2.1\,\mathrm{m}) = 24.7\,\mathrm{J},\end{aligned}\]

    so \(\Delta U = U_f - U_i = 24.7 - 9.4 = 15.3\,\mathrm{J}\).

    (b) With \(U = 0\) at the desktop, every height is measured from \(0.80\,\mathrm{m}\) up, so subtract \(0.80\) from each floor height. The book starts at \(y = 0.80 - 0.80 = 0\) and ends at \(y = 2.1 - 0.80 = 1.3\,\mathrm{m}\):

    \[U_i = 0, \qquad U_f = (1.2)(9.8)(1.3) = 15.3\,\mathrm{J},\]

    so \(\Delta U = 15.3 - 0 = \boxed{15.3\,\mathrm{J}}.\)

    Why the change cannot depend on the choice. Moving the reference level subtracts the same amount from both heights, so it subtracts the same amount of energy from both \(U_i\) and \(U_f\), and that common amount drops out of the difference. Algebraically, \(\Delta U = mgy_f - mgy_i = mg(y_f - y_i) = mg\,\Delta y\), and \(\Delta y = 2.1 - 0.80 = 1.3\,\mathrm{m}\) whichever level we measure from. So \(\Delta U = (1.2)(9.8)(1.3) = 15.3\,\mathrm{J}\) in one step.

    The individual values disagree (\(9.4\,\mathrm{J}\) versus \(0\,\mathrm{J}\) for the same book on the same desk) but the change is \(15.3\,\mathrm{J}\) either way, and it is the change that physics can measure. Had we placed the reference at the shelf, both values would have come out negative (\(-15.3\,\mathrm{J}\) and \(0\)) and the change would still have been \(0 - (-15.3) = 15.3\,\mathrm{J}\). Choose whichever level makes the arithmetic easiest, state your choice, and then use it consistently for the whole problem.

    Elastic potential energy

    The same reasoning applies to a spring. By equation (7.8), the spring does work \(W_s = \tfrac12 kx_i^2 - \tfrac12 kx_f^2 = -\left(\tfrac12 kx_f^2 - \tfrac12 kx_i^2\right)\) as its end moves from \(x_i\) to \(x_f\). Comparing with equation (8.4), the elastic potential energy is

    Key Equation: Elastic potential energy

    \[U_s = \tfrac{1}{2}kx^2, \tag{8.6}\]

    where \(x\) is the stretch or compression measured from the relaxed length. Here there is a natural reference: \(U_s = 0\) when the spring is relaxed, and \(U_s\) is positive whether the spring is stretched or compressed. And again, \(U_s\) is exactly the work \(\tfrac12 kx^2\) needed to stretch the spring in the first place (equation (7.7)). The energy is in the stretched spring, not in the block pressed against it.

    Checkpoint 8.3

    A spring is stretched \(2.0\,\mathrm{cm}\) from its relaxed length, and then compressed \(2.0\,\mathrm{cm}\) from its relaxed length. In which state does it store more elastic potential energy? What happens to \(U_s\) if the stretch is tripled?

    Answer

    Example 8.6: A spring-loaded dart

    A toy dart gun has a spring with \(k = 850\,\mathrm{N/m}\), compressed \(6.0\,\mathrm{cm}\) when cocked. (a) How much elastic potential energy is stored? (b) The \(25\,\mathrm{g}\) dart leaves the spring as it reaches its relaxed length. Treating the barrel as frictionless and horizontal, how fast is the dart moving?

    Solution

    (a) Convert to SI first, \(x = 0.060\,\mathrm{m}\), then square before multiplying:

    \[U_s = \tfrac{1}{2}kx^2 = \tfrac{1}{2}(850\,\mathrm{N/m})(0.060\,\mathrm{m})^2 = \tfrac12(850)(0.0036)\,\mathrm{J} = \boxed{1.53\,\mathrm{J}}.\]

    (b) As the spring relaxes from \(x_i = 0.060\,\mathrm{m}\) to \(x_f = 0\), it does work \(W_s = \tfrac12 kx_i^2 - 0 = 1.53\,\mathrm{J}\) on the dart: equal to the drop in its potential energy. No other force does work (the barrel is frictionless and level), so by the work–kinetic energy theorem, with the dart starting from rest,

    \[\tfrac{1}{2}mv^2 = 1.53\,\mathrm{J} \;\Longrightarrow\; v = \sqrt{\frac{2(1.53\,\mathrm{J})}{0.025\,\mathrm{kg}}} = \sqrt{122\,\mathrm{m^2/s^2}} \approx \boxed{11\,\mathrm{m/s}}.\]

    The stored potential energy has become kinetic energy, joule for joule. That observation, turned into a general law, is the subject of §8.5.

    Answers to Checkpoints

    Checkpoint 8.3. The same in both. \(U_s = \tfrac12 kx^2\) depends on \(x^2\), so a stretch and a compression of equal size store equal energy. Tripling the stretch multiplies \(U_s\) by \(3^2 = 9\).


    This page titled 8.3: Potential Energy was last modified on Thu, 12 Nov 2026 04:26:53 GMT and is shared under a CC BY 4.0 license and was authored, remixed, and/or curated by Michael Ragsdale.