9.6: Questions

Laboratory Manual - DC Electrical Circuit Analysis · LibreTexts

0%

Contents

    Text

    Size
    100%
    Theme
    Typeface
    Line length
    Spacing

    Read aloud

    How

    Speed: 1×
    Light up
    Highlight

    Symbols: Mulberry Symbols, © 2018–2026 Steve Lee, CC BY-SA 4.0 (licence, the set), the site's own copies.

    From LibreTexts, under CC BY-NC-SA 4.0, as the source states it; its equations are written in TeX, which the PDF shows typeset. This page at LibreTexts.

    9.6: Questions

    1. In Table 9.5.1, does the total resistance always equal the nominal resistance of the potentiometer?

    2. If the potentiometer used for Table 9.5.1 had a logarithmic taper, how would the values change?

    3. In Table 9.5.2, is the load voltage always directly proportional to the knob position? Is the progression always linear?

    4. Explain the variation of the four curves plotted in step 7.

    5. In the final circuit, is the load current always proportional to the knob position? If the load was much smaller, say just a few hundred ohms, would the minimum and maximum currents be much different from those in Table 9.5.3?

    6. How could the circuit of Figure 9.3.3 be modified so that the maximum current could be set to a value higher than that achieved by the supply and load resistor alone?


    This page titled 9.6: Questions was last modified on Mon, 22 Mar 2021 03:00:05 GMT and is shared under a CC BY-NC-SA 4.0 license and was authored, remixed, and/or curated by James M. Fiore via source content that was edited to the style and standards of the LibreTexts platform.