8.1: Rules for Drawing Hydraulic Schematics

Fluids 2: Basic Hydraulics · LibreTexts

0%

Contents

    Text

    Size
    100%
    Theme
    Typeface
    Line length
    Spacing

    Read aloud

    How

    Speed: 1×
    Light up
    Highlight

    Symbols: Mulberry Symbols, © 2018–2026 Steve Lee, CC BY-SA 4.0 (licence, the set), the site's own copies.

    From LibreTexts, under CC BY 4.0, as the source states it; its equations are written in TeX, which the PDF shows typeset. This page at LibreTexts.

    8.1: Rules for Drawing Hydraulic Schematics

    Understanding hydraulic schematics is essential for designing, troubleshooting, and maintaining hydraulic systems. To ensure clarity and consistency, eight fundamental rules should be followed when creating schematic diagrams:

    1. Symbol Orientation – Most hydraulic symbols can be rotated or reversed without changing their meaning. However, vented reservoirs and accumulators must always be depicted in the upright position. 
      Hydraulic schematic diagram in a vertical and a horizontal orientation.
      Figure \(\PageIndex{1}\): Hydraulic symbol schematics may be viewed in a vertical or horizontal orientation.
    2. Reservoir Representation – The vented reservoir symbol can be repeated multiple times within a schematic without indicating multiple reservoirs. This improves readability, showing where lines return to the tank without unnecessary connections. 
      Hydraulic schematic diagram showing the vented reservoir symbol.
      Figure \(\PageIndex{2}\): Hydraulic schematic diagram showing the vented reservoir symbol.
    3. Line Alignment – Lines (conductors) should be drawn horizontally or vertically. Diagonal lines should be avoided for clarity and standardization.
    4. Line Representation – Schematics must distinguish between connected lines, crossing lines, and blocked lines to ensure clear circuit interpretation. 
      Schematic symbols for connected lines, crossing lines, and blocked lines.
      Figure \(\PageIndex{3}\): Schematic symbols for connected lines, crossing lines, and blocked lines.
    5. Symbol Functionality – Schematic symbols represent function, flow paths, and connections only. They do not indicate:
      • Physical construction
      • Size or dimensions
      • Port locations
      • Flow rates or pressure values
    6. Default Component Position – Symbols should be drawn to represent the normal (at rest), de-energized, or neutral position of each component unless showing different operational phases.
    7. Use of Letters in Symbols – While letters are generally unnecessary in schematics, two exceptions apply:
      • "M" inside a circle indicates an electric drive motor.
      • "I" inside a flowmeter symbol designates a totalizing flowmeter.
    8. Flow Direction Arrows – A solid arrow or triangle is used to indicate the direction of fluid flow from the pump through the circuit. This arrow can also be used alone to represent a power unit.

    By following these standardized rules, hydraulic schematics remain clear, interpretable, and universally understood in design and maintenance settings.


    This page titled 8.1: Rules for Drawing Hydraulic Schematics was last modified on Tue, 29 Apr 2025 18:14:00 GMT and is shared under a CC BY 4.0 license and was authored, remixed, and/or curated by Jessy Haid.