2.1: Direct Vapor Inlet

An Introduction to Mass Spectrometry · LibreTexts

0%

Contents

    Text

    Size
    100%
    Theme
    Typeface
    Line length
    Spacing

    Read aloud

    How

    Speed: 1×
    Light up
    Highlight

    Symbols: Mulberry Symbols, © 2018–2026 Steve Lee, CC BY-SA 4.0 (licence, the set), the site's own copies.

    From LibreTexts, under CC BY 4.0, as the source states it; its equations are written in TeX, which the PDF shows typeset. This page at LibreTexts.

    2.1: Direct Vapor Inlet

    Direct Vapor Inlet. The simplest sample introduction method is a direct vapor inlet. The gas phase analyte is introduced directly into the source region of the mass spectrometer through a needle valve. Pump out lines are usually included to remove air from the sample. This inlet works well for gases, liquids, or solids with a high vapor pressure. Samples with low vapor pressure are heated to increase the vapor pressure. Since this inlet is limited to stable compounds and modest temperatures, it only works for some samples.


    This page titled 2.1: Direct Vapor Inlet was last modified on Mon, 04 Jul 2022 02:59:11 GMT and is shared under a CC BY 4.0 license and was authored, remixed, and/or curated by Scott Van Bramer.