2.2: How do Molecules Bond to Surfaces?

Surface Science · LibreTexts

0%

Contents

    Text

    Size
    100%
    Theme
    Typeface
    Line length
    Spacing

    Read aloud

    How

    Speed: 1×
    Light up
    Highlight

    Symbols: Mulberry Symbols, © 2018–2026 Steve Lee, CC BY-SA 4.0 (licence, the set), the site's own copies.

    From LibreTexts, under CC BY-NC-SA 4.0, as the source states it; its equations are written in TeX, which the PDF shows typeset. This page at LibreTexts.

    2.2: How do Molecules Bond to Surfaces?

    There are two principal modes of adsorption of molecules on surfaces: Physical Adsorption (physisorption ) and Chemical Adsorption (chemisorption). The basis of distinction is the nature of the bonding between the molecule and the surface with:

    • Physical Adsorption: the only bonding is by weak Van der Waals - type forces. There is no significant redistribution of electron density in either the molecule or at the substrate surface.
    • Chemisorption: a chemical bond, involving substantial rearrangement of electron density, is formed between the adsorbate and substrate. The nature of this bond may lie anywhere between the extremes of virtually complete ionic or complete covalent character.
    Typical Characteristics of Adsorption Processes
    Chemisorption Physisorption
    Material Specificity
    (variation between substrates of different chemical composition)
    Substantial variation between materials Slight dependence upon substrate composition
    Crystallographic Specificity
    (variation between different surface planes of the same crystal)
    Marked variation between crystal planes Virtually independent of surface atomic geometry
    Temperature Range
    (over which adsorption occurs)
    Virtually unlimited
    (but a given molecule may effectively adsorb only over a small range)
    Near or below the condensation point of the gas
    (e.g. Xe < 100 K, CO2 < 200 K)
    Adsorption Enthalpy Wide range (related to the chemical bond strength) - typically 40 - 800 kJ mol-1 Related to factors like molecular mass and polarity - typically 5-40 kJ mol-1
    (similar to heat of liquefaction)
    Nature of Adsorption Often dissociative
    May be irreversible
    Non-dissociative
    Reversible
    Saturation Uptake Limited to one monolayer Multilayer uptake possible
    Kinetics of Adsorption Very variable - often an activated process Fast - since it is a non-activated process

    The most definitive method for establishing the formation of a chemical bond between the adsorbing molecule and the substrate (i.e. chemisorption) is to use an appropriate spectroscopic technique, for example

    • IR (Section 5.4 ) to observe the vibrational frequency of the substrate/adsorbate bond
    • UPS (Section 5.3 ) to monitor intensity & energy shifts in the valence orbitals of the adsorbate and substrate

    This page titled 2.2: How do Molecules Bond to Surfaces? was last modified on Mon, 21 Feb 2022 19:12:40 GMT and is shared under a CC BY-NC-SA 4.0 license and was authored, remixed, and/or curated by Roger Nix.