15.5: Monitoring Hydrogenation and Dehydrogenation Reactions by UV Spectroscopy

OIT: CHE 333 Organic Chemistry III · LibreTexts

0%

Contents

    Text

    Size
    100%
    Theme
    Typeface
    Line length
    Spacing

    Read aloud

    How

    Speed: 1×
    Light up
    Highlight

    Symbols: Mulberry Symbols, © 2018–2026 Steve Lee, CC BY-SA 4.0 (licence, the set), the site's own copies.

    From LibreTexts, under CC BY-NC-SA 4.0, as the source states it; its equations are written in TeX, which the PDF shows typeset. This page at LibreTexts.

    15.5: Monitoring Hydrogenation and Dehydrogenation Reactions by UV Spectroscopy

    In order to study any enzyme-catalyzed reaction, a researcher must have available some sort of test, or assay, in order to observe and measure the reaction's progress and measure its rate. In many cases, an assay simply involves running the reaction for a specified length of time, then isolating and quantifying the product using a separation technique such as high performance liquid chromatography (HPLC) or gas chromatography (GC). This type of assay can be extremely time-consuming, however, so it is to the researcher's great advantage if a more convenient assay can be found.

    Redox reactions in which a nicotinamide coenzyme participates as a hydride donor or acceptor are generally quite convenient to assay. In fact, the progress of these reactions can usually be observed in real time, meaning that the researcher doesn't need to stop the reaction in order to see how far it has progressed. \(NADPH\) and \(NADH\) have distinctive \(n-\pi\)* UV absorbance bands centered at 340 nm, with a molar absorptivity of 6290 M-1 cm-1 (section 4.4). The oxidized coenzymes \(NADP^+\) and \(NAD^+\) do not absorb at this wavelength.

    Graph of absorbance against wavelength in mm. Graph shows NAD(P)H in blue and NAD(P) plus in red.

    Therefore, the course of a hydrogenation reaction, in which \(NAD(P)H\) is converted to \(NAD(P)^+\), can be observed in real time if it is run in a quartz cuvette in a UV spectrometer. By observing the decrease in absorbance at 340 nm, the researcher can calculate how much \(NAD(P)H\) has been oxidized to \(NAD(P)^+\) at any given time point, and this number is the molar equivalent of the amount of organic substrate that has been reduced:

    oxidized substrade reacts with NAD(P)H with absorbs at 340 nanometers to produce a reduced product and NAD(P) plus which has no absorbance at 340 nanometers.

    Likewise, a \(NAD^+\)-dependent dehydrogenase reaction can be followed in real time by monitoring the increase in absorbance at 340 nm as \(NAD^+\) is converted to \(NADH\).

    Exercise 15.6.1

    You are observing the progress of the (R)-glycerol phosphate dehydrogenase reaction shown in the figure below.

    (R)-glycerol phosphate reacts with NADP plus to produce NADPH, H plus, and dihydroxyacetone phosphate.

    You run the reaction in a quartz cuvette (path length 1 cm) in a total solution volume of 1 mL. start with 200 mM substrate and 100 mM \(NADP^+\) in solution, zero the UV spectrophotometer, then add the enzyme to start the reaction. After 5 minutes, the A340 reading has climbed from 0.000 to 0.096. At this time point:

    1. How many moles of substrate have been oxidized?
    2. What is the solution concentration of \(NADP^+\)?
    3. The enzyme has a mass of 25 kilodaltons (25,000 g/mol).You added 5 mL of a 2 ng/mL solution of pure enzyme to start the reaction. How many reactions does each enzyme molecule catalyze, on average, per second? (This number is referred to by biochemists as the 'turnover number').

    This page titled 15.5: Monitoring Hydrogenation and Dehydrogenation Reactions by UV Spectroscopy was last modified on Wed, 20 Jul 2022 18:37:21 GMT and is shared under a CC BY-NC-SA 4.0 license and was authored, remixed, and/or curated by Tim Soderberg via source content that was edited to the style and standards of the LibreTexts platform.