7.1.1: Soil Formation

Applied Botany · LibreTexts

0%

Contents

    Text

    Size
    100%
    Theme
    Typeface
    Line length
    Spacing

    Read aloud

    How

    Speed: 1×
    Light up
    Highlight

    Symbols: Mulberry Symbols, © 2018–2026 Steve Lee, CC BY-SA 4.0 (licence, the set), the site's own copies.

    From LibreTexts, under CC BY-NC-SA 4.0, as the source states it; its equations are written in TeX, which the PDF shows typeset. This page at LibreTexts.

    7.1.1: Soil Formation

    Soil is an important resource in natural and agricultural settings. It is renewable but the formation is very slow. It is estimated that to produce a single inch (2.5 cm) of topsoil, it takes about 100 years. That same inch can be lost in a single severe weather event. Soil formation through weathering is a complex process that breaks down rocks and minerals over time. Weathering can be physical, chemical, or biological.

    Physical weathering processes do not involve chemical changes. They simply mechanically break down parent rock material into smaller fragments to create sediments and soils. The mechanical forces needed to fracture and disintegrate rocks come from a variety of sources:

    • Freeze-thaw weathering: Water seeps into cracks and pores in rock. When temperatures drop below freezing, the water expands as it turns to ice. This expansion exerts outward pressure on the rock, enlarging the crack or pore. Over many freeze-thaw cycles, this wedging action splits rocks apart along fractures (Figure 7-2).
    • Thermal expansion: Rocks expand and contract with heating and cooling. These stresses can eventually cause cracks and fractures. Exfoliation of surface sheets or onion-skin weathering often results from thermal expansion.
    • Abrasion: Rock-on-rock collisions, such as in a stream or along a cliff face, effectively grind rocks into smaller pieces. Glacial movement is an extreme example of this as the pressure and motion of the glacier causes abrasion as rocks embedded in ice scour the underlying rock surface.
    • Crystal growth: Minerals like salt crystallize and grow in the pores and cracks of rock, exerting pressure that can break rocks apart. In coastal areas, saltwater-spray can penetrate pores and cracks in the rock. As the water evaporates the salts crystalize within the rock. As the salt crystals heat up, they expand.
    • Plant growth: Small plant root can grow into fissures within rocks. As the roots expand in girth, the growth this can literally splits rocks apart.
    Freeze-thaw cycles have fractured rock into smaller pieces.
    Figure 7-2. Freeze-thaw cycles eventually fracture larger rocks into smaller pieces. (By Till Niermann - Own work, CC BY-SA 3.0, curid=745814)

    Chemical weathering alters rocks and minerals through chemical reactions. One cause of chemical weathering is oxidation. From a chemical standpoint, oxidation is the loss of electrons from an element. Iron atoms within rock can be oxidized to rust which weakens the rock material. Oxidation of sulfide minerals results in the creation of sulfuric acid. Acids often play a role in chemical weathering and can come from a variety of sources. Carbon dioxide mixes with water to produce carbonic acid. Pollutants like sulfur and nitrogen oxides dissolve in rainwater to produce acid rain which chemically weathers rocks upon contact. Acids secreted by lichens, mosses and plant roots can impact rocks as well. These acids dissolve rock, creating channels and pits. These channels and pits can then create more entry points to facilitate both physical and chemical weathering. The type and rate of weathering depend on factors like climate, topography, and rock characteristics.

    The smaller particles created through weathering accumulate as sediments like sand, silt, and clay. With continued weathering, these sediments break down into finer particles with more surface area. The texture of the soil becomes finer. In warm, wet climates, high rates of chemical weathering decompose feldspar minerals into clays. In drier grasslands, physical weathering may dominate, with a higher percentage of sand and silts from broken rock pieces.

    Colonization of newly formed inorganic soil components starts with plants such as lichens and mosses. They attract other organisms and initiate the addition of organic matter through secretions and decay. New organisms move into the area and effect soil formation including microbial organisms - such as protozoa, bacteria, and fungi- plants and animals – such as earthworms, nematodes and insects. As weathering continues, soils develop characteristic horizons, with organic accumulation on top. Soil formation is a gradual process dependent on climate, biology, parent material, and topography over long timescales. Weathering continually generates soil from solid rock and mineral material. Not all soil comes from newly weathered local rocks. Soils can be translocated by flooding and landslide. Glaciation moves soil across the landscape while volcanic eruptions add new land to the landscape.

    We tend to think of soil as a solid material, but it is not. It is composed of mineral matter, organic matter, air and water. For a given volume of typical soil, solids only make up about 50% with 45% inorganic and 5% organic matter. The other 50% of the soil is made up of voids that are filled with gases (25%) and water (25%). All four of these components are critical to plant success. The pie graph (Figure 7-4) shows the components of a loam soil by percent volume. Here the mineral matter (collectively 45%) has been separated into sand, silt and clay. Soils are broadly classified as their inorganic (mineral) or organic based on the organic material in the top 80 cm of soil. There is no universally accepted threshold for exact percentage required to make this classification but in general it is 20-30%. Peat and “muck” soils have some of the highest organic matter contents, often 50% or greater (Figure 7-3).

    A) Wetland where standing water penetrates soil on surrounding banks. B) Closeup of organic soil.
    Figure 7-3. Organic soils can be very productive as they hold nutrients well but can become waterlogged. (https://www.flickr.com/photos/soilsc...in/dateposted/. Photo by John A. Kelley, USDA Natural Resources Conservation Service.)
    Relative composition of a loam soil by percent volume.
    Figure 7-4. Components of a loam soil by percent volume.Relative composition of a loam soil by percent volume. Water 25%, gases 25%, sand 18%, silt 18%, clay 9% and organic matter 5%. (Stephanie Harvey. CC-BY-NC)

    This page titled 7.1.1: Soil Formation was last modified on Fri, 13 Nov 2026 18:55:10 GMT and is shared under a CC BY-NC-SA 4.0 license and was authored, remixed, and/or curated by Stephanie Harvey.