10.13: Chapter Summary

Cell Culture Textbook (Biot 77 IVC) · LibreTexts

0%

Contents

    Text

    Size
    100%
    Theme
    Typeface
    Line length
    Spacing

    Read aloud

    How

    Speed: 1×
    Light up
    Highlight

    Symbols: Mulberry Symbols, © 2018–2026 Steve Lee, CC BY-SA 4.0 (licence, the set), the site's own copies.

    From LibreTexts, under CC BY-NC-SA 4.0, as the source states it; its equations are written in TeX, which the PDF shows typeset. This page at LibreTexts.

    10.13: Chapter Summary

    Cell concentration describes cells per volume. Cell yield describes the number in the full suspension. Percent viability describes the fraction classified as living by the test used. Confluence describes surface coverage in an adherent culture and is not an exact cell count. A standard hemocytometer provides a known counting volume. For the large-square method described here, multiply the average count per square by 10,000 and the actual sample dilution factor. Count clear and blue cells separately. Do not apply the dilution correction again to percent viability. Multiply viable cells/mL by suspension volume to find viable yield. Divide the target viable cell number by viable stock concentration to find the transfer volume. Poor mixing, clumps, faulty loading, or double correction can distort the result. Keep raw counts, units, timing, and device settings so another person can check the estimate.

    Key Terms

    Cell concentration

    Cell yield

    Percent viability

    Viable cell concentration

    Confluence

    Representative sample

    Single-cell suspension

    Hemocytometer

    Trypan blue

    Dye exclusion

    Boundary rule

    Dilution factor

    Seeding target

    Technical repeats

    Measurement uncertainty

    Review Questions

    1. Explain how concentration, viable yield, and percent viability differ. Why can 95% viability occur in a culture with too few cells for an experiment?

    2. Explain the 10,000 factor using the dimensions of a standard large hemocytometer square. Why should you check the counting device before using this factor?

    3. Four large squares contain clear counts of 44, 50, 48, and 58, and blue counts of 6, 4, 5, and 5. The only sample dilution is equal-volume dye mixing. Calculate viable cells/mL, total cells/mL, and percent viability. Show units.

    4. The suspension in Question 3 has a remaining volume of 4.0 mL. Calculate its available viable yield.

    5. A counting sample contains 20 µL of original suspension and 80 µL of medium. It is then mixed with an equal volume of dye. What combined dilution factor restores the original concentration?

    6. A stock has 1.5 × 10⁶ viable cells/mL. What stock volume supplies 300,000 viable cells? How much medium is needed for a final volume of 1.0 mL with no other additions?

    7. A hypothetical adherent-cell target is 8,000 viable cells/cm² in a 25 cm² vessel. Calculate the target cell number and the volume needed from a stock of 1.0 × 10⁶ viable cells/mL.

    8. A suspension contains 4.0 × 10⁶ viable cells in 5.0 mL. Predict concentration and viable yield immediately after adding 5.0 mL of medium, assuming no cell loss or growth.

    9. Two chamber counts differ greatly. Identify three checks to make before reporting their mean. Explain why technical repeats are not independent biological cultures.

    10. An automated counter reports a concentration after applying the dye correction. A student multiplies the result by 2 again. Describe the error and its likely effect on a planned seeding volume.

    11. A target requires 1.0 × 10⁶ viable cells in a final volume of 1.0 mL, but the stock contains 0.50 × 10⁶ viable cells/mL. Explain why simple dilution cannot meet this target.

    12. An NHDF suspension has many clumps after incomplete detachment. A THP-1 sample was taken after cells settled. Explain how each problem could affect the count and what should be documented.

    Apply Your Understanding

    Four large squares contain 160 clear cells and 40 blue cells. The sample was mixed with an equal volume of dye and had no other dilution. Calculate viable cells/mL and percent viability. Explain the two different denominators.

    A suspension contains 1.0 million viable cells/mL in 4.0 mL. Calculate its yield and the volume needed to transfer 200,000 viable cells.

    Two chamber counts differ greatly, and one contains visible clumps. Explain why averaging immediately could hide a problem. Plan a repeat and state which original records to retain.

    An automated counter already corrects for the dye dilution. A student multiplies its concentration by two again. Predict the effect on the reported concentration and the seeding volume calculated from it.


    This page titled 10.13: Chapter Summary was last modified on Wed, 21 Oct 2026 01:35:31 GMT and is shared under a CC BY-NC-SA 4.0 license and was authored, remixed, and/or curated by Emalee MacKenzie.