14.18: Choosing and Checking Exposure Controls

Quality and Regulatory Compliance in Bioscience · LibreTexts

0%

Contents

    Text

    Size
    100%
    Theme
    Typeface
    Line length
    Spacing

    Read aloud

    How

    Speed: 1×
    Light up
    Highlight

    Symbols: Mulberry Symbols, © 2018–2026 Steve Lee, CC BY-SA 4.0 (licence, the set), the site's own copies.

    From LibreTexts, under CC BY-SA 4.0, as the source states it; its equations are written in TeX, which the PDF shows typeset. This page at LibreTexts.

    14.18: Choosing and Checking Exposure Controls

    The hierarchy of controls helps teams select ways to reduce exposure. Start by asking whether the hazard can be eliminated. If it is needed, consider a safer substitute andChoosing Controls for Safe Centrifuge Work.png check what risks the substitute introduces. Engineering controls isolate workers from the hazard. Administrative controls specify how work is performed, and personal protective equipment (PPE) protects the person wearing it. A task may need several controls at once. 

    Worked Example Choosing Controls for a Centrifuge Task

    A technician needs to centrifuge cell culture samples. The team identifies a possible exposure if a tube leaks or breaks during the run. It checks whether the step is necessary and whether the same work can be done with less hazardous material. If the step must remain, the team assesses whether compatible sealed rotors or safety cups can reduce aerosol release and where the containers should be opened under the approved procedure.

    The procedure specifies how to select and inspect tubes, balance loads, and respond to suspected breakage. Staff demonstrate the procedure before working independently and use PPE selected for the task. Supervisors check that the containers and seals are in good condition and observe whether workers can use the controls correctly. A new rotor, sample type, or procedure is a reason to reassess the risk.

    Matching Controls to the Hazard

    A chemical fume hood can control exposure to hazardous vapors when suitable for the work. A biological safety cabinet can provide containment for biological work when the cabinet type and setup are appropriate. Select the equipment for the hazards involved with help from environmental health and safety (EHS) staff. Review waste handling as part of the same assessment. Identify the waste stream at the point of use, segregate incompatible materials, and follow the facility’s approved labeling, storage, and disposal procedures.

    EHS Practice Reviewing a Change Before Work Begins

    A laboratory replaces capped tubes with a different tube design for centrifuging cell culture samples. Before adopting the change, identify how a leak or break could expose people during loading, unloading, or cleanup. Compare the proposed tubes and closure with the equipment and procedure requirements. Identify an engineering control, a work practice, and task-appropriate PPE that the team should assess with EHS. State how the supervisor would verify that the controls are in place and what would trigger a review. Use the centrifuge example and the existing hierarchy of controls as your starting points. 


    This page titled 14.18: Choosing and Checking Exposure Controls was last modified on Sun, 08 Nov 2026 23:56:20 GMT and is shared under a CC BY-SA 4.0 license and was authored, remixed, and/or curated by Emalee MacKenzie.