11.3: Conductivity of Some Common Materials

Electromagnetics II · LibreTexts

0%

Contents

    Text

    Size
    100%
    Theme
    Typeface
    Line length
    Spacing

    From LibreTexts, under CC BY-SA 4.0, as the source states it; its equations are written in TeX, which the PDF shows typeset. This page at LibreTexts.

    The values below are conductivity \(\sigma\) for a few materials that are commonly encountered in electrical engineering applications, and for which conductivity emerges as a consideration.

    Note that materials in some applications are described instead in terms of resistivity, which is simply the reciprocal of conductivity.

    Conductivity may vary significantly as a function of frequency. The values below are representative of frequencies from a few kHz to a few GHz. Conductivity also varies as a function of temperature. In applications where precise values are required, primary references accounting for frequency and temperature should be consulted. The values presented here are gathered from a variety of references, including those indicated in “Additional References” at the end of this section.

    Free Space (vacuum): \(\sigma\triangleq 0\).

    Table \(\PageIndex{1}\): Commonly encountered elements:
    Material \(\sigma\) (S/m)
    Copper \(5.8\times 10^7\)
    Gold \(4.4\times 10^7\)
    Aluminum \(3.7\times 10^7\)
    Iron \(1.0\times 10^7\)
    Platinum \(0.9\times 10^7\)
    Carbon \(1.3\times 10^5\)
    Silicon \(4.4\times 10^{-4}\)

    Commonly encountered elements

    • Water exhibits \(\sigma\) ranging from about \(6~\mu\)S/m for highly distilled water (thus, a very poor conductor) to about \(5\) S/m for seawater (thus, a relatively good conductor), varying also with temperature and pressure. Tap water is typically in the range of 5–50 mS/m, depending on the level of impurities present.
    • Soil typically exhibits \(\sigma\) in the range \(10^{-4}\) S/m for dry soil to about \(10^{-1}\) S/m for wet soil, varying also due to chemical composition.
    • Non-conductors. Most other materials that are not well-described as conductors or semiconductors and are dry exhibit \(\sigma < 10^{-12}\) S/m. Most materials that are considered to be insulators, including air and common dielectrics, exhibit \(\sigma < 10^{-15}\) S/m, often by several orders of magnitude.

    This page titled 11.3: Conductivity of Some Common Materials was last modified on Mon, 22 Mar 2021 02:50:01 GMT and is shared under a CC BY-SA 4.0 license and was authored, remixed, and/or curated by Steven W. Ellingson (Virginia Tech Libraries' Open Education Initiative) via source content that was edited to the style and standards of the LibreTexts platform.